Instrukcja obsługi Pioneer S-FCRW3100-K
Pioneer
System głośników
S-FCRW3100-K
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Pioneer S-FCRW3100-K (12 stron) w kategorii System głośników. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/12
1
En
WHAT’S IN THE BOX
Important
The serial number for this equipment is located on the side of
the packing case. Please write this serial number on the
warranty page and keep it in a secure area for future reference.
BEFORE USE
• Thank you for buying this Pioneer product.
• Please read through this operating guide before using your
speaker system to optimize performance.
FRONT / CENTER / SURROUND SPEAKERS
In order to prevent damage to the speaker system resulting from
input overload, please observe the following precautions:
• When connecting or disconnecting cables, be sure amplifier
power is OFF.
• Do not use excessive amplifier volume if using a tone control to
emphasize high or low frequencies.
INSTALLATION PRECAUTIONS
FRONT / CENTER / SURROUND SPEAKERS
• Do not install these units near a stove or other heating
appliance, or put them in a place exposed to the sun. Such
locations may cause the cabinet to change color and the
speaker system to break down.
• The front, center and surround speakers supplied with this
system are magnetically shielded. However, placing them
extremely close to a television may result in color distortion on
the screen. If this happens, move the speakers a little further
away and switch off the television for 15 to 30 minutes.
• Do not use the speaker to output distorted sound for long
periods of time. This can result in damages to the speaker and
poses a potential fire hazard.
SUBWOOFER
• Do not place anything on top of the cabinet.
• Do not spill liquid on the cabinet.
• Place the subwoofer at least 8 inches (20 cm) from any wall or
curtain in order to avoid heat build-up.
• The subwoofer is not magnetically shielded and so should not
be placed near a TV or monitor. Magnetic storage media (such
as floppy discs and tape or video cassettes) should also not be
kept close to the subwoofer.
Caution
• Do not connect this speaker to any amplifier other than the one
supplied with this system. Connection to any other amplifier
may result in a malfunction or a fire.
• Do not attach the subwoofer to the wall or ceiling. It may fall off
and cause injury.
• Front speakers x 2 • Center speaker
• Subwoofer
• Surround speakers x 2
• Speaker cords x 6
Front right (Red)
Subwoofer (Purple) Surround right (Grey) Surround left (Blue)
Front left (White) Center (Green)
• Non-skid pads (large) x 4
• Non-skid pads (small) x 16 • Operating Instructions
• Brackets x 2 • Screws x 4
http://www.pioneerelectronics.com
Operating Instructions
S-FCRW3100-K
Speaker System
Downloaded from manuals search enginewww.Manualslib.com
2
En
PLACEMENT AND FINE TUNING
SUBWOOFER
Sound spreads in all directions in the very low frequency range.
Human hearing cannot easily detect the source of very low
frequencies. Be sure to provide a space of at least 8 inches (20 cm)
between the rear of the subwoofer and the nearest wall.
FRONT SPEAKERS
For best results the loudspeaker should be positioned near ear level
and the loudspeakers separated a distance approximately equal to
the listening distance. Angling the loudspeakers inward towards the
listener will improve the image stability for non-central listeners.
Close proximity to a side or rear wall will enhance the midbass
performance, although too close (particularly a corner location) and
the bass may be unnaturally high and image performance may be
degraded.
CENTER SPEAKER
The loudspeaker should be positioned below the TV. For best results
align the front of the loudspeaker with the front of the TV. If the
loudspeaker is placed under the TV and very close to the floor, then
tilting upwards may be beneficial.
When installing the center speaker on top of the TV, be sure to
secure it with tape or some other suitable means. Otherwise, the
speaker may fall from the TV due to external shocks such as
earthquakes, endangering those nearby or damaging the speaker.
SURROUND SPEAKERS
For best results the loudspeakers should be positioned at or above
ear level. Depending upon your room layout and preferences, the left
and right rear speakers should be positioned on the side walls just
the rear of the listening position, or on the walls.
NON-SKID PADS
If the front and surround speakers are placed on a hard surface,
such as wood or tile place four non-skid pads (small) on the bottom
flat surface of the speakers.
If the subwoofer is placed on a hard floor, such as wood or tile, place
four non-skid pads (large) on the bottom surface of the subwoofer.
STANDARD SURROUND SETUP
This is a standard multichannel surround sound speaker setup for
optimal 5.1 channel home theater sound.
EXTRA POWER SETUP
This optional setup allows you to enjoy richer, fuller sound from
stereo (2.1 ch) sources.
For Front and Surround speakers
Stack the speakers and fix with the brackets.
As shown in the illustration, stack the surround speakers on top of
the front speakers. Align the bracket with the respective upper
screw hole for the surround speaker and lower screw hole for the
front speaker, and fasten the screws securely.
Caution
Do not attempt to carry the speakers when they are connected
with the bracket. Doing so may cause damage to the bracket or
worsen damage to the bracket and speakers in the event they
are dropped.
Surround left Surround right
Center
Front
left
Listening position
Front
right
Subwoofer
Surround
left
Surround
right
Center
Front
left
Listening position
Front
right
Subwoofer
Bracket
Screw
Surround
speaker
Front
speaker
Downloaded from manuals search enginewww.Manualslib.com
3
En
CONNECTING YOUR SYSTEM
Important
Make sure all equipment is turned off before making any
connections.
• Correct wiring of your loudspeakers is essential for achieving
the best sound quality. Be careful to ensure proper polarity of
connection.
• If any of the bare speaker wire touches the back panel it may
cause the power to cut off as a safety measure.
Twist and pull off the protective shields on each wire.
Connect to the speaker terminals on the rear of the
receiver.
To connect, insert the colored wire into the matching positive
(colored) terminal and the other wire into the negative (black)
terminal as shown below.
Note that the color-coded tabs are as follows:
• Red : Front right (R)
• White : Front left (L)
• Green : Center speaker
• Purple : Subwoofer
• Grey : Surround right (R)
• Blue : Surround left (L)
Connect to the speaker terminals on the rear of the
speakers.
Match the colored wire with the color-coded label (above the tabs),
then insert the colored wire into the red (+) tab and the other wire
with the black (–) tab.
CABINET MAINTENANCE
Use a polishing cloth or dry cloth to wipe off dust and dirt.
When the cabinet is very dirty, clean with a soft cloth dipped in some
neutral cleanser diluted five or six times with water, and then wipe
again with a dry cloth. Do not use furniture wax or cleaners.
Never use thinners, benzine, insecticide sprays and other chemicals
on or near the cabinets, since these will corrode the surfaces.
WALL-MOUNTING THE FRONT, CENTER AND
SURROUND SPEAKER SYSTEM
Before mounting
• Remember that the speaker system is heavy and that its weight
could cause the screws to work loose, or the wall material to fail
to support it, resulting in the speaker falling. Make sure that the
wall you intend to mount the speakers on is strong enough to
support them. Do not mount on plywood or soft surface walls.
• Mounting screws are not supplied. Use screws suitable for the
wall material and support the weight of the speaker.
Note
• If you are unsure of the quality and strength of the walls, consult
a professional for advice.
• Pioneer is not responsible for any accidents or damage that
result from improper installation.
Colored marker
Colored marker
red
black
5 mm to 7 mm
(3/16 in. to 1/4 in.)
5 mm
(3/16 in.)
10 mm
(3/8 in.)
Mounting screw
(not supplied)
Downloaded from manuals search enginewww.Manualslib.com
Specyfikacje produktu
| Marka: | Pioneer |
| Kategoria: | System głośników |
| Model: | S-FCRW3100-K |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Pioneer S-FCRW3100-K, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje System głośników Pioneer
3 Lipca 2024
3 Lipca 2024
2 Lipca 2024
2 Lipca 2024
Instrukcje System głośników
- System głośników Sony
- System głośników Yamaha
- System głośników Samsung
- System głośników AEG
- System głośników JBL
- System głośników Onkyo
- System głośników Panasonic
- System głośników Toshiba
- System głośników Grundig
- System głośników Paradigm
- System głośników Jamo
- System głośników Auna
- System głośników ION
- System głośników American Audio
- System głośników Sonos
- System głośników BW
Najnowsze instrukcje dla System głośników
26 Września 2024
26 Września 2024
25 Września 2024
24 Września 2024
24 Września 2024
23 Września 2024
23 Września 2024
23 Września 2024
23 Września 2024
22 Września 2024