Instrukcja obsługi Pingi Cascada CHD-W6000M

Pingi oczyszczacz powietrza Cascada CHD-W6000M

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Pingi Cascada CHD-W6000M (13 stron) w kategorii oczyszczacz powietrza. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/13
OPERATING INSTRUCTIONS
humidiFier
CASCADA™ CHD-W6000M
OPERATING INSTRUCTIONS
ULTRASONIC
EN
DE
FR
NL
SAFETY – GENERAL
• This appliance should be used as described within the instructions for
use that accompany it.
• For indoor, domestic use only.
• This appliance can be used by children aged 8 years and above, and
persons with reduced physical, sensory or mental capabilities or lack
of experience and knowledge, if they have been given supervision or
instruction concerning the use of the appliance in a safe way,
and understand the hazards involved.
• Keep the appliance out of reach of small children. Children should
not play with the appliance or its accessories. Cleaning and user
maintenance operations should not be performed by children unless
they are older than 8 years and under supervision.
• This appliance contains small parts which may cause choking.
• Children of less than 3 years should be kept away unless continuously
supervised.
• CAUTION - The plastic bags and packaging used to wrap this
appliance may be dangerous. To avoid the risk of suffocation, keep
these bags out of reach of babies and children. These bags are not
toys.
• Ensure that all packaging materials and any promotional labels or
stickers are removed from the appliance before the first use.
SAFETY – PLACEMENT
• Place the device away from other objects in an open space with good
airflow. Allow sufficient ventilation. Make sure that no objects block
the air vents.
• ATTENTION - Do not place the appliance on moisture-sensitive
objects or surfaces (i.e. electrical appliances, wooden furniture,
carpet) during operation, while filling the tank or when performing
routine maintenance. Water may leak out or precipitate and cause
permanent damage or stains.
SAFETY – OPERATION
• Always inspect the appliance before use for noticeable signs of
damage. Do not use if it has been damaged or has been dropped. In
the event of damage, or if the appliance develops a fault, contact a
qualified electrician.
• Make sure your electricity supply matches the voltage shown on the
appliance label.
• Unplug the appliance from the mains electricity when not in use
and before cleaning. To unplug, pull the power plug from the mains
socket.
• To protect against fire, electric shock or personal injury, do not
immerse cord or device in water or other liquids.
• Always ensure that your hands are dry before removing the power
plug from the mains socket. Never pull the plug out of the mains
socket by its lead.
• To avoid injury or possible fire, do not cover the appliance when in
use.
• Do not connect this appliance to an external timer or remote-control
system.
• An extension cable may be used with caution. The electrical rating of
the cable should be at least as high as that of the device. Do not allow
the cable to hang over the edge of the worktop, or touch any hot
surfaces.
• Empty the tank and base when the appliance is not in use. Only
operate the device with fresh, clean water.
TECHNICAL SPECIFICATIONS CHD-W6000M
RATED INPUT AC 220-240V, 50Hz ........................................................................................................
APPLIANCE POWER CONSUMPTION 28W .......................................................................................
WATER OUTPUT PER HOUR 300ml (±30ml)/hour ...........................................................................
MAX. RECOMMENDED APPLICATION AREA 35m .........................................................................
TANK VOLUME 6000ml ..........................................................................................................................
OPERATING TEMPERATURE 5°C~45°C ...............................................................................................
dB <35dB ....................................................................................................................................................
SIZE 275 x 165 x 265 mm ........................................................................................................................
CHD-W6000M - ULTRASONIC HUMIDIFIER
EN
INTENDED USE
Your new Pingi Cascada humidifier CHD-W6000M is suitable for humidifying the air in enclosed indoor
spaces. The appliance operates on 220-240V, 50Hz (mains electricity). Never try to connect the device to other
power sources. Please always follow the safety instructions in this manual. Keep this instruction manual in
a safe place so that it is available at all times. This product complies with regulatory, national and European
requirements. Never try to make technical modifications to this device. We do not accept liability for accidents
or damages resulting from failure to follow these operating and safety instructions.
WHAT TO EXPECT
The Pingi Cascada humidifier CHD-W6000M is an ultrasonic humidifier that atomises water. High-frequency
vibrations transform up to 300 ml (±30ml) of water per hour into a fine mist. This means it will increase the
humidity level in the air by generating millions of small droplets. The device has a 6L tank that can be top
filled. The CHD-W6000M humidifying speed can be set using the control dial. Humidifiers need to be cleaned
regularly to prevent limescale build-up or biofilm formation. Please refer to the cleaning section for further
information.
BEFORE YOU START
Please carefully read the safety instructions on the front page of this manual before getting
started.
PLACEMENT AND INSTALLATION
1. Select a level surface that provides sufficient distance between the humidifier and any walls and other
objects. Please mind that some water may escape from the base or tank when installing the tank. Do not
place the device on or near moisture-sensitive objects or surfaces.
2. If needed, install the included filter cartridge in the appropriate slot in the base.
3. Plug in the device.
We recommend using this appliance in rooms with a room temperature of 18 - 22 °C
FILLING THE TANK
1. Empty and flush the tank. Then fill it with cold tap water. The tank can hold up to 6L of water.
2. Place the filled tank on the base and replace the tank cover.
3. You can change the direction of the mist output by rotating the mist nozzles.
4. You can add water at any time without removing the tank from the base.
SWITCHING ON THE HUMIDIFIER
The humidifier can be switched on and off with the control dial. After switching on the appliance, the
indicator LED will become green and the device will start to emit humidity. Use the dial to select the desired
power setting and to switch off the appliance. Selecting a higher power level will increase the amount of mist
produced.
OUT OF WATER SIGNAL
The humidifier will automatically switch off when it detects that the tank is empty. The indicator LED will turn
red when the tank is empty. Fill the tank to resume operation. The indicator LED will become green.
CLEANING
Both the tank and base need to be cleaned regularly.
We recommend cleaning the appliance once a week.
Important notices:
- Make sure the device is unplugged when cleaning it.
- Do not pour hot water in the tank.
- Do not use detergents or chlorine.
- Use vinegar or a coffee machine descaling fluid.
Procedure:
Water tank: Empty out the water tank. Rinse the water tank with cold water and some vinegar (1 cup).
Optionally use a soft brush. Thoroughly flush the tank after emptying out the vinegar solution.
Base: Empty out the base. Use a microfibre cloth with some cold water to clean it.
Filter cartridge: Rinse the filter cartridge with hot water. Optionally soak the filter several minutes in hot
water.
Foam filter: Regularly check the foam filter for dust by opening the filter compartment on the underside of
the device. Rinse the filter under running water if it is dirty.
Ultrasonic element: The ultrasonic element is located in the base. Over time limescale deposits may become
visible on and around this element. If you notice this, it may require descaling. Empty out the base and
pour a mixture 1 part water and 1 part vinegar in the base. Wait for at least 30 minutes before pouring out
the vinegar. You may use a soft brush. Do not use hard brushes or tools, as this may damage the ultrasonic
element. Thoroughly rinse the base before switching on the appliance again.
Exterior: If necessary, wipe off the exterior of the appliance with a lightly dampened cloth.
BOX CONTENT
CHD-W6000M - ULTRASONIC HUMIDIFIER
EN
HUMIDIFIER
CHD-W6000M
INSTRUCTION
MANUAL
PARTS
Water
tank
Control
dial
Tank cover
Base
Indicator LED
Tank handle
Mist nozzle

Specyfikacje produktu

Marka: Pingi
Kategoria: oczyszczacz powietrza
Model: Cascada CHD-W6000M

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Pingi Cascada CHD-W6000M, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje oczyszczacz powietrza Pingi

Pingi

Pingi Cascada CHD-W6000M Instrukcja

27 Grudnia 2024

Instrukcje oczyszczacz powietrza

Najnowsze instrukcje dla oczyszczacz powietrza

Uniprodo

Uniprodo UNI_AIR PURIFIER_03 Instrukcja

4 Stycznia 2025
Haier

Haier QDHR20 Instrukcja

4 Stycznia 2025
Sunbeam

Sunbeam Fresh Protect SAP1000WH Instrukcja

30 Grudnia 2025
Honeywell

Honeywell HPA250B Instrukcja

29 Grudnia 2024
Honeywell

Honeywell HPA300COM Instrukcja

29 Grudnia 2024
Winix

Winix AUS-0850AAPU Instrukcja

29 Grudnia 2024
TruSens

TruSens Z-2000 Instrukcja

28 Grudnia 2024
Dri Eaz

Dri Eaz HEPA 700 Instrukcja

28 Grudnia 2024
Levoit

Levoit Core 300S Plus Smart Instrukcja

28 Grudnia 2024
Haus & Luft

Haus & Luft HL-OP-11/WiFi Instrukcja

27 Grudnia 2024