Instrukcja obsługi Philips S221C7AFB

Philips monitor S221C7AFB

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Philips S221C7AFB (37 stron) w kategorii monitor. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/37
www.philips.com/welcome
EN User manual 1
Customer care and warranty 22
Troubleshooting & FAQs 30
S221C7
Table of Contents
1. For Your Safety ............................ 1
1.1 Precautions ..................................... 1
1.2 Cleaning ......................................... 2
1.3 Special notes on SMART All-in-
One .................................................. 2
1.4 Disposal of product and packing
material 3 ...........................................
2. Setting up the SMART All-In-
One ................................................. 5
2.1 Installation ..................................... 5
2.2 Operating the SMART All-in-
One ...................................................7
2.3 Detach the hinge for VESA ........ 9
2.4 SMART All-in-One Operation .10
3. Image Optimization 16 ...................
3.1 SmartImage ..................................16
4. Technical Specications 18 ...........
4.1 Resolution & Preset PC Modes ...
21
5. Customer care and warranty .. 22
5.1 Philips’ Flat Panel SMART All-
in-Ones Pixel Defect Policy .... 22
5.2 Customer Care & Warranty ...... 25
6. Troubleshooting & FAQs .........30
6.1 Troubleshooting .........................30
6.2 General FAQs 31 ...............................
6.3 SMART All-in-One FAQs ......... 34
1
1. Important
1. For Your Safety
Before operating the SMART All-in-One,
please read this manual thoroughly. This
manual should be retained for future
reference.
FCC Class B Radio Frequency
Interference Statement
WARNING: (FOR FCC CERTIFIED
MODELS)
NOTE:
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy, and if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to
try to correct the interference by one or
more of the following measures:
1. Reorient or relocate the receiving
antenna.
2. Increase the separation between the
equipment and receiver.
3. Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
4. Consult the dealer or an
experienced radio/TV technician for
help.
NOTICE:
1. The changes or modifications not
expressly approved by the party
responsible for compliance could
void the user’s authority to operate
the equipment.
2. Shielded interface cables and AC
power cord, if any, must be used in
order to comply with the emission
limits.
3. The manufacturer is not responsible
for any radio or TV interference
caused by unauthorized
modification to this equipment. It
is the responsibilities of the user to
correct such interference.
WARNING:
To prevent fire or shock hazard, do not
expose the SMART All-in-One to rain or
moisture. Dangerously high voltages are
present inside the SMART All-in-One.
Do not open the cabinet. Refer servicing
to qualified personnel only.
1.1 Precautions
• Do not use the SMART All-in-One
near water, e.g. near a bathtub,
washbowl, kitchen sink, laundry
tub, swimming pool or in a wet
basement.
• Do not place the SMART All-in-One
on an unstable cart, stand, or table.
If the SMART All-in-One falls, it can
injure a person and cause serious
damage to the appliance. Use only
a cart or stand recommended by
the manufacturer or sold with the
SMART All-in-One.
• Slots and openings in the back and
bottom of the cabinet are provided
for ventilation. To ensure reliable
operation of the SMART All-in-One
and to protect it from overheating,
be sure these openings are not


Specyfikacje produktu

Marka: Philips
Kategoria: monitor
Model: S221C7AFB

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Philips S221C7AFB, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje monitor Philips

Instrukcje monitor

Najnowsze instrukcje dla monitor

Acer

Acer VG281K Instrukcja

15 Stycznia 2025
Acer

Acer V223W Instrukcja

15 Stycznia 2025
Orion

Orion R4N55RNF Instrukcja

15 Stycznia 2025
Orion

Orion 23REDPH Instrukcja

15 Stycznia 2025
Orion

Orion R4N46UNF Instrukcja

15 Stycznia 2025
Orion

Orion 21REDPH Instrukcja

15 Stycznia 2025
BenQ

BenQ G2750HM Instrukcja

14 Stycznia 2025
Hamlet

Hamlet HM27JF-VDR Instrukcja

14 Stycznia 2025
Hamlet

Hamlet HM24JF-VDR Instrukcja

14 Stycznia 2025
Hamlet

Hamlet HM24JF-V Instrukcja

14 Stycznia 2025