Instrukcja obsługi Pentacon Praktisix II

Pentacon Niesklasyfikowane Praktisix II

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Pentacon Praktisix II (7 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/7
Praktisix II Manual
Instructions for use
The Praktisix II is a single lens reflex camera with focal plane shutter for the 6 X 6-cm (21/4 X 21/a) picture format. It possesses all the
advantages of a modern precision camera, as there are: Automatic diaphragm Focal plane shutter with speeds from 1 second to 1/1,000
second and B Rapid wind lever Interchangeable finder elements Interchangeable field lenses Shutter wind coupled to film transport Lock
against double exposures and blanks Synchronization (X-socket) for flash tubes and flash bulbs Built-in delayed action Interchangeable
lenses.
The following items deserve special attention (abridged instructions)
1 Place film into the left-hand spool chamber.
2 Remove the gumstrip completely, pull the paper leader across the picture gate and insert it into the longer slit of the receiving spool.
3 Swing rapid lever (2) around once as far as it will go, then continue operating it by rocking movements to advance the film up to the
point where the index mark on the paper leader stands against the white dot on the picture gate. At the same time keep the spring support of
the left-hand spool under slight pressure to assure taut and even winding of the film. Move the rapid lever back to its initial position.
4 Depress set-back knob (9); a red dot becomes visible in the window of exposure counter (13).
5 Adjust film speed indicator (8) on the inner side of the camera back.
6 Release the shutter and cock it began four times. The rapid wind lever (2) must be swung around completely each time as far as it will go
and then moved back again. The exposure counter (13) now stands at number 1.
7 View and focus your image on the ground glass field. A magnifier may be swung in for critical focusing.
8 After the 12th exposure (an "E" appears in the counter window) the paper backing has to be wound up to the end by one full stroke of the
rapid wind lever followed by short rocking movements.
Important parts of the camera
1. finder hood
2. rapid wind lever
3. shutter release with cable release connection
4. lever for setting delayed action mechanism
5. flash socket
Not only of these items of course, but the complete instructions for use must be studied carefully.
6. Latch for camera back
7. Knob for opening the finder hood
8. Film speed indicator
9. Set back knob for exposure counter
10. Frame finder (sports finder)
A surface coated mirror reflects the image designed by the lens onto the ground glass screen. At the moment of the exposure the mirror is
swung out the path of rays and, forming a light tight cover over the ground glass, allows the light rays to pass freely on to the image plane.
As soon as the mirror has reached its topmost position, the shutter is opened for the exposure.
Taking lens and finder lens being one and the same, there is no danger of parallax error. Everything that you see in the viewfinder must
necessarily appear on the film, even in extreme close-ups. This renders it possible to use lenses of various focal lengths and intermediate
rings for close-up work without the need for any extra finder attachments.
Inserting the film
You may use any kind of commercially available 120 roll film Fort 12 exposures 6 X 6 cm (21/ X 21/ "). Undo latch (6) and open the
camera back. Place empty spool into the right hand spool chamber and make sure that the driving mechanism catches the spool core. The
bottom spring support has to be slightly pulled away. The full spool is inserted into the left-hand chamber in the same manner.
The leader of the protective paper backing must point in the traveling direction of film. Do not loosen the gumstrip and remove it
completely before the film is held fast in the spool chamber. Pull the paper leader across the picture gate (printed side outwards) and fix it
into the longer slit of the receiving spool.
Swing the rapid wind lever (2) around as far as it will go and continue advancing the film leader by small rocking movements until the
arrow mark stands against the white dot on the picture gate. Now move the rapid wind lever back to its initial position. Tight and even
winding of the film is absolutely necessary to avoid faulty film feed periods. The spring support of the full spool should, therefore, be kept
under slight pressure as a means of checking the wind-off movement of the film. Close the camera back and lock it Depress set back knob
(9) to bring exposure counter (13) to its starting point. A red dot appears in the counter window (13). Release the shutter and cock it again
four times. The number 1 now stands in the counter window.
At every subsequent cocking of the shutter, the counting mechanism advances to the next number. After the twelfth exposure an "E"
becomes visible. Actuate the wind lever will go; move it back to its original position. Do smoothly and without interruption as far as it
not let it jump back.
Setting the film speed indicator
A film speed indicator (8) is built into the camera back. It is adjusted from the interior before the camera is closed.
The finder hood
Push the little knob (7) is on the finder hood housing in the direction of the arrow, thus causing the finder hood (1) to spring into operating
position.
The magnifier
For critical focusing and to facilitate picture composition, a magnifying lens (12) yielding a fourfold enlargement may be swung into
parallel position with the field lens.

Specyfikacje produktu

Marka: Pentacon
Kategoria: Niesklasyfikowane
Model: Praktisix II

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Pentacon Praktisix II, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Niesklasyfikowane Pentacon

Pentacon

Pentacon LTL-3 Instrukcja

22 Września 2024
Pentacon

Pentacon Super TL1000 Instrukcja

22 Września 2024
Pentacon

Pentacon Six TL Instrukcja

21 Września 2024
Pentacon

Pentacon BC Auto Instrukcja

21 Września 2024
Pentacon

Pentacon MTL-5B Instrukcja

21 Września 2024
Pentacon

Pentacon Luxmedia 16-Z21C Instrukcja

20 Września 2024
Pentacon

Pentacon Praktisix II Instrukcja

20 Września 2024
Pentacon

Pentacon LM14-04 Instrukcja

18 Września 2024
Pentacon

Pentacon LM1405 Instrukcja

18 Września 2024
Pentacon

Pentacon Luxmedia 16-Z24S Instrukcja

18 Września 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024
Husqvarna

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024
Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024