Instrukcja obsługi PACO MBC 1212

PACO Ładowarka baterii MBC 1212

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla PACO MBC 1212 (19 stron) w kategorii Ładowarka baterii. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/19
7-STAGE AUTOMATIC
BATTERY CHARGER
MCU CONTROLLED & HIGH FREQENCY SWITCHMODE
Instruction Manual
Please read user manual carefully before use.
1
◆ Explosive gases may escape from the battery during charging. Prevent
flames and sparks. Provide adequate ventilation.
◆ Before charging, read the instructions.
◆ For indoor use. Do not expose to rain.
◆ For charging 12 Volt or 24 Volt lead acid batteries ONLY.
◆ Disconnect the 110V/220-240V AC mains supply before making or breaking
the connections to the battery.
◆ The battery charger must be plugged into an earthed socket-outlet.
◆ Connection to supply mains is to be in accordance with National wiring rules.
◆ Do not attempt to charge non-rechargeable batteries.
◆ Never charge a frozen battery.
◆ If the AC cord is damaged do not attempt to use. It must be replaced or
repaired by a qualified person.
◆ Corrosive substances may escape from the battery during charging and
damage delicate surfaces. Store and charge in a suitable area.
◆ Ensure all vehicle accessories including lights, heaters, appliances etc are
turned off prior to charging.
◆ This appliance is not intended for use by young children or infirm persons
unless they have been adequately supervised by a responsible person to
ensure that they can use the appliance safely.
◆ Young children should be supervised to ensure that they do not play with the
appliance.
1. WARNING
7-STAGE AUTOMATIC CHARGING
This is a fully automatic battery charger with 7 charge stages.
Automatic charging protects your battery from being overcharged. So you can
leave the charger connected to the battery indefinitely.
7-stage charging is a very comprehensive and accurate charging process that
gives your battery longer life and better performance compared to using
traditional chargers.
7-stage chargers are suitable for most battery types including Calcium, Gel and
AGM batteries. They may also help restore drained and sulphated batteries.
The 7 stages are:
Desulphation ; Soft Start; Bulk; Absorption; Battery Test; Recondition and Float.
2. FEATURES
2
Desulphation
The Desulphation stage may break down sulphation that occurs in batteries that
have been left flat for extended periods of time, returning them back to full charge.
sulphation occurs when lead-sulphate hardens and clogs up the battery cells.
Soft Start
A preliminary charge processes that gently introduces power to the battery. This
protects the battery and increases battery life.
Bulk (Constant Current)
Bulk mode charges the battery at the maximum rate (constant current) putting a
large amount of power into the battery in a short amount of time. This stage will
charge the battery to approximately 80%, until the voltage reaches 14.4 volts for
12V charger or 28.8 volts for 24V charger.
Bulk mode for the charging cycle. The start phase continues until the battery's
terminal voltage has risen above the set limit, at which point the charger
switches to bulk charging. If the terminal voltage has not passed the voltage
limit within the time limit, the charger switches to fault mode (lamp ③ solid) and
discontinues the charging. If so, the battery is faulty or its capacity is too large.
Absorption (Constant Voltage)
The charge rate slows down so the battery can absorb more power and reach
100% charge. The voltage remains at a constant 14.4 volts for 12V charger or
28.8 volts for 24V charge while the current is gradually reduced until no more
power can be added without over-charging the battery.

Specyfikacje produktu

Marka: PACO
Kategoria: Ładowarka baterii
Model: MBC 1212

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z PACO MBC 1212, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Ładowarka baterii PACO

PACO

PACO MBC 1220 Instrukcja

19 Września 2024
PACO

PACO MBC 1212 Instrukcja

19 Września 2024
PACO

PACO MBC 1210 Instrukcja

12 Września 2024

Instrukcje Ładowarka baterii

Najnowsze instrukcje dla Ładowarka baterii

MSW

MSW S-CHARGER-20A.2 Instrukcja

15 Października 2024
MSW

MSW S-CHARGER-10A.2 Instrukcja

15 Października 2024
Intenso

Intenso Powerbank 10400 Instrukcja

14 Października 2024
Gembird

Gembird CHM-03 Instrukcja

10 Października 2024
Kostal

Kostal IQ 8.5 Instrukcja

9 Października 2024
Venom

Venom VS5007 Instrukcja

9 Października 2024
Venom

Venom VS5010 Instrukcja

9 Października 2024
Venom

Venom VS2891 Instrukcja

9 Października 2024
Venom

Venom VS2881 Instrukcja

9 Października 2024
Venom

Venom VS2883 Instrukcja

9 Października 2024