Instrukcja obsługi Onkyo SKS-HT978

Onkyo głośnik SKS-HT978

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Onkyo SKS-HT978 (12 stron) w kategorii głośnik. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/12
En-1
7.1ch Home Theater Speaker Package
Make sure you have the following accessories.
Front Speakers (SKF-980)
Center Speaker (SKC-980)
*1 For use of front speakers and center speaker.
Surround Speakers (SKR-980)
Surround Back Speakers (SKB-980)
Powered Subwoofer (SKW-980/SKW-938)
■Front
Caution
• The front grille is not designed to be removed so do not
attempt to remove it forcibly, as this will damage it.
Supplied Accessories
Front speakers
Speaker cables 3.5 m (11 ft.)
Center speaker Speaker cable
3.0 m (10 ft.)
12 cork stoppers*1
(White) (Red)
(Green)
Surround speakers
Surround back speakers
(HTP-993THX/SKS-HT993THX only) Speaker cables 8.0 m (26 ft.)
Subwoofer RCA cable 3.0 m (10 ft.)
(Blue) (Gray)
(Brown) (Tan)
Speaker cables 8.0 m (26 ft.)
Power cord
(Asian models)
Standby/On indicator
Red: Subwoofer in standby mode
Blue: Subwoofer on
The status indicator lights blue when
low frequency sound is being passed
through the speaker.
The indicator does not light in the
normal dialog or high frequency sound.
HTP-993THX/SKS-HT993THX
5.1ch Home Theater Speaker Package
SKS-HT978THX
E
n
En-2
■Rear
SKW-980 (North American models)
SKW-980 (Asian models)
SKW-938 (European models)
Caution
• With other audio-video components, connect the subwoofer’s
LINE INPUT to the subwoofer pre out jack of your equipment.
Never plug any kind of musical instrument to the subwoofer.
Note
• The Auto Standby function turns the subwoofer on when the
input signal exceeds a certain level. If the Auto Standby
function does not work reliably, try slightly increasing or
decreasing the subwoofer output level on your receiver.
When there’s no input signal for a while, the SKW-980/SKW-
938 automatically enters Standby mode.
• If the Standby/On indicator lights (both red and blue LEDs)
several seconds or minutes after the sound output stopped,
this means that the amp protection circuit has been activated.
In this case, set the OUTPUT LEVEL control to the center
position, and disconnect the power cord from the AC outlet.
Wait at least 10 minutes, and then reconnect the power cord.
If that doesn’t solve the issue, contact your Onkyo dealer.
Using the Cork Stoppers for a More Stable
Platform
We recommend using the supplied cork stoppers to achieve
the best possible sound from your speakers. The cork
stoppers prevent the speakers from moving, providing a
more stable platform.
■Attaching and detaching the speaker grilles
The front, center, surround and surround back speakers
have detachable grilles.
See the illustrations to attach or detach them.
Setting the Subwoofer Level
Make sure the SKW-980/SKW-938
subwoofer’s output level control is set at
the “THX POSITION”.
You can then adjust the level as needed.
Wall Mounting
To mount the front/surround/surround back speakers
vertically, use the keyhole slot shown to hang each speaker
on a screw that’s securely screwed into the wall.
To mount the center speaker horizontally, use the two
keyhole slots shown to hang each speaker on two screws
that are securely screwed into the wall.
OUTPUT LEVEL control
This control is used to adjust the
volume of the subwoofer.
LINE INPUT
This RCA input should be connected to
the subwoofer pre out on your AV
receiver with supplied RCA cable.
To AC outlet
OUTPUT LEVEL control
This control is used to adjust the
volume of the subwoofer.
LINE INPUT
This RCA input should be connected to
the subwoofer pre out on your AV
receiver with supplied RCA cable.
To AC outlet
AC INLET
Connects the supplied power cord.
OUTPUT LEVEL control
This control is used to adjust the
volume of the subwoofer.
LINE INPUT
This RCA input should be connected to
the subwoofer pre out on your AV
receiver with supplied RCA cable.
To AC outlet
POWER switch
Press this switch to the ON position to
turn on the power. Press it to the OFF
position to turn off the power.
Before Using the Home Theater
Speaker Package
Cork stoppers
Bottom of the SKF-980
Bottom of the SKC-980
Cork stoppers
Removal Replacement
SKF-980 SKR-980/SKB-980 (HTP-
993THX/SKS-HT993THX
only)
Keyhole slots for wall
mounting
Keyhole slots for wall mounting
260 mm (10-1/4")
SKC-980
En-3
Caution
• A mounting screw’s ability to support a
speaker depends on how well it’s
anchored to the wall. If you have hollow
walls, screw each mounting screw into a
stud. If there are no studs, or the walls
are solid, use suitable wall anchors. Use
screws with a head diameter of 9 mm
(5/16") or less and a shank diameter of
4 mm (1/8") or less. With hollow walls,
use a cable/pipe detector to check for any power cables or
water pipes before making any holes.
• Leave a gap of between 5 mm (3/16") and 10 mm (7/16")
between the wall and the base of the screw head, as shown.
(We recommend that you consult a home installation
professional.)
The Home Theater means that you can enjoy surround
sound with a real sense of movement in your own home —
just like being in a movie theater or concert hall.
.
Speaker Connection Precautions
Read the following before connecting your speakers:
• Turn off your receiver before making any connections.
• Pay close attention to speaker wiring polarity.
Connect positive (+) terminals to only positive
(+) terminals, and negative (–) terminals to only
negative (–) terminals. If the speakers are wired
incorrectly, the sound will be out of phase and
will sound unnatural.
• Be careful not to short the positive and negative wires.
Doing so may damage your amp.
Note
• When you connect the front high left and right speakers,
prepare for it separately, or use the surround back left and
right speakers.
Enjoying Home Theater
Wall
5 to 10 mm
(3/16" to 7/16")
43
5 21
Corner
position 1/3 of wall
position
1Front left and right speakers (SKF-980)
They should be positioned facing the listener at about
ear level, and equally spaced from the TV. Angle them
inward slightly so as to create a triangle, with the
listener at the apex.
2Center speaker (SKC-980)
Position it close to your TV facing forward at about ear
level, or at the same height as the front left and right
speakers.
3Surround left and right speakers (SKR-980)
Position them at the sides of the listener, or slightly
behind, about 60 to 100 cm (2 to 3 feet) above ear
level. Ideally they should be equally spaced from the
listener.
4Surround back left and right speakers (SKB-980:
HTP-993THX/SKS-HT993THX only)
These speakers further enhance the realism of
surround sound and improve sound localization
behind the listener.
Position them behind the listener about 60 to 100 cm
(2 to 3 feet) above ear level.
5Subwoofer (SKW-980: North American and Asian
models/SKW-938: European models)
The subwoofer handles the bass sounds of the LFE
(Low-Frequency Effects) channel and bass from the
satellite speakers when a crossover is specified. The
volume and quality of the bass output from your
subwoofer will depend on its position, the shape of
your listening room, and your listening position. In
general, a good bass sound can be obtained by
installing the subwoofer in a front corner, or at one-
third the way along the front wall, as shown.
Connecting the Speakers
Surround back
left speaker *
Surround back
right speaker *
Surround
left speaker
Surround
right speaker
Front left
speaker
Front right
speaker
Center speaker
Brown Tan Blue Gray
White Red
Green
Powered
subwoofer
* HTP-993THX/SKS-HT993THX only

Specyfikacje produktu

Marka: Onkyo
Kategoria: głośnik
Model: SKS-HT978

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Onkyo SKS-HT978, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje głośnik Onkyo

Onkyo

Onkyo D-407M Instrukcja

16 Września 2024
Onkyo

Onkyo HTP-2S Instrukcja

10 Września 2024
Onkyo

Onkyo SKS-4700 Instrukcja

9 Września 2024
Onkyo

Onkyo SKS-3600 Instrukcja

4 Września 2024
Onkyo

Onkyo D-407F Instrukcja

3 Września 2024
Onkyo

Onkyo D-309H Instrukcja

3 Września 2024
Onkyo

Onkyo SKS-HT230 Instrukcja

30 Sierpnia 2024
Onkyo

Onkyo SKR-L500 Instrukcja

29 Sierpnia 2024
Onkyo

Onkyo SKS-101 Instrukcja

29 Sierpnia 2024
Onkyo

Onkyo Smart Speaker G3 VC-GX30 Instrukcja

28 Sierpnia 2024

Instrukcje głośnik

Najnowsze instrukcje dla głośnik

Bowers & Wilkins

Bowers & Wilkins LCR3 Instrukcja

15 Stycznia 2025
Hifonics

Hifonics Vulcan VX6.2E Instrukcja

15 Stycznia 2025
Pyle

Pyle PLRGSW64BK Instrukcja

15 Stycznia 2025
ION

ION Insta Sound Instrukcja

15 Stycznia 2025
Pure Acoustics

Pure Acoustics QBT-340 Instrukcja

15 Stycznia 2025
Yamaha

Yamaha WX-010 Instrukcja

15 Stycznia 2025
Polk

Polk REACT SOUND BAR 1 Instrukcja

15 Stycznia 2025
Sennheiser

Sennheiser AMBEO Soundbar Plus SB02M Instrukcja

15 Stycznia 2025
Klipsch

Klipsch Reference RB-25 Instrukcja

15 Stycznia 2025
Klipsch

Klipsch Reference RB-35 Instrukcja

15 Stycznia 2025