Instrukcja obsługi Onkyo SKS-3600

Onkyo głośnik SKS-3600

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Onkyo SKS-3600 (4 stron) w kategorii głośnik. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
En
Speaker System
SKS-3600
SKC-3600 Center Speaker System
SKM-3600 Surround Speaker System
Instruction Manual
Thank you for your purchase of the Onkyo speaker
system.
Please read this manual thoroughly before using it.
Following the instructions in this manual will enable
you to obtain optimum performance and listening
enjoyment from your new speaker system.
Please retain this manual for future reference.
Contents
Supplied accessories 2
Placement 2
Using the included cork
spacers and installation
brackets 2
Connections 3
Precaution on use 3
Speaker care 4
Use with a TV set or
computer 4
Specifications 4
2
SKC-3600 (center speaker)
× 1
SKM-3600 (surround speaker)
× 2
Speaker cord
× 3 (green: 3 m, blue, gray: 9 m)
Bracket
× 4
Screw
× 4
Cork spacer
× 12
SKC-3600 (Center speaker)
Complements the sound effects from front left and right
speakers to enrich and clear the sound image and move-
ment. In movies, an actor’s speech comes mainly from
the center speaker.
Place the center speaker as close as possible to the TV
or monitor, pointing it towards the listener’s ears. Also,
keep the center speaker’s height at the same level as the
front left and right speakers.
SKM-3600 (Surround left and right speakers)
Enhance the sensation of being at a live performance by
giving three-dimensional sound movement to the sound
effects. Place the surround speakers at the side of the
listener or at a position diagonally from the listener. Ide-
ally, speakers should be placed symmetrically.
Place these speakers so that their height is 1 meter
higher than that of the listener’s ears.
The speaker cabinet is made of wood and sensitive to
extreme temperatures and humidity. Avoid placing the
speaker system in locations subjected to direct sunlight
or in humid places such as near an air conditioner, bath-
room, or kitchen.
We recommend that you use the included cork spacers
so you can enjoy superior sound. The cork spacers also
prevent the speakers from slipping.
Mounting on a wall
Wall-mount the speakers upside down. Layer two spac-
ers and attach them to two locations. The plaques rotate
so that you can position the speakers upside down.
Attaching the brackets:
Use the included screws to attach the brackets to the
back of the speakers.
Caution:
• Make sure that the walls are rigid enough for support-
ing the speaker’s weight.
• The weight a mounting screw can support varies
greatly depending on the wall material and the posi-
tion of the reinforcing ribs embedded in the wall. Use
the thickest and longest possible mounting screws
whose head diameter is less than 10 mm and shank
diameter is less than 4 mm (consult with your
installer).
Supplied accessories
Placement
Using the included cork spacers and
installation brackets
Cork spacer
Bottom of SKM-3600
Bottom of
SKC-3600
Cork spacer SKM-3600
Bracket
Screw
SKC-3600
Bracket
Screw
Cork spacer
3
• Be sure to turn off your amplifier before connecting
the speaker system. Connecting it while the amplifier
is on may result in damage to the amplifier or the
speaker system.
• The nominal impedance of this speaker system is 8
Ω.
Use only amplifiers capable of handling this imped-
ance.
• Use the supplied speaker cables to connect between
the speaker’s input terminals and the amplifier’s
speaker terminals as illustrated below.
• Be sure to connect the Center, Surround Right and
Left speakers with the amplifier’s corresponding
speaker terminals. Also, be sure that you are connect-
ing the speaker’s positive (+) and negative (–) input
terminals with the amplifier’s corresponding positive
and negative speaker terminals. Otherwise, undesir-
able sound field or impaired bass-range reproduction
will result.
• Before turning on the amplifier’s power switch, pull
lightly on the speaker cables to ensure that they are
connected securely.
• To prevent damage to cir-
cuitry, never short-circuit the
positive (+) and negative (–)
speaker wire.
The surround speaker bottom and rear are equipped
with screw holes so that you can attach commercially-
available stands or mounting fixtures for a variety of
mounting options. (Two M5 screw holes, 60 mm pitch
on the bottom and one M5 screw hole on the rear.)
Note:
When attaching an
accessory item to a
speaker, be careful
of the length of the
screws used. Use
only screws that
provide the required strength with a screw length
between 7 and 12 mm.
• This speaker system can handle the specified input
power when it is used for ordinary music reproduc-
tion. If the following abnormal signals are fed to the
speaker, however, an overcurrent may flow in the
internal circuits, causing burning or breakage of the
wires even if the input power is below the specified
rating.
1. Noise produced when FM station is not tuned in
2. Sound produced when fast-forwarding cassette
tape deck
3. High-frequency sound generated by an oscillator,
an electronic musical instruments, etc.
4. Oscillating amplifier signals
5. Special test signals produced by audio checking
CD, etc.
6. Sound produced when connecting or disconnect-
ing audio connection cables (Always turn off the
amplifier’s power before connecting or discon-
necting cables.)
7. Howling when a microphone is used
• Do not place magnetic objects such as screwdrivers
and iron parts near the speaker system since they use
speakers with strong magnets. Otherwise, the objects
may be attracted, causing injury or damaging the dia-
phragm.
Connections
SURROUND BACK
SPEAKER
FRONT
SPEAKERS SURROUND
SPEAKERS CENTER
SPEAKER
R
L
R
L
A B
R
L
SKF-3600
Front right
speaker
SKF-3600
Front left
speaker
SKC-3600
Center speaker
SKM-3600
Surround right
speaker
SKM-3600
Surround left
speaker
Gray
Green
Blue
1. Strip the insulation of speaker
cables, and twist the core wires
tightly.
2. While pressing the lever, insert
the wire into the hole, and then
release the lever.
3. Make sure that the terminals
are gripping the core wires, not
the insulation.
Installation using commercially-
available stands and fixtures
Precaution on use
M5 screw
5 mm
7 ~ 12 mm

Specyfikacje produktu

Marka: Onkyo
Kategoria: głośnik
Model: SKS-3600

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Onkyo SKS-3600, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje głośnik Onkyo

Onkyo

Onkyo D-407M Instrukcja

16 Września 2024
Onkyo

Onkyo HTP-2S Instrukcja

10 Września 2024
Onkyo

Onkyo SKS-4700 Instrukcja

9 Września 2024
Onkyo

Onkyo SKS-3600 Instrukcja

4 Września 2024
Onkyo

Onkyo D-407F Instrukcja

3 Września 2024
Onkyo

Onkyo D-309H Instrukcja

3 Września 2024
Onkyo

Onkyo SKS-HT230 Instrukcja

30 Sierpnia 2024
Onkyo

Onkyo SKR-101 Instrukcja

25 Sierpnia 2024
Onkyo

Onkyo G3 Smart Speaker Instrukcja

8 Sierpnia 2024
Onkyo

Onkyo SKR-4700 Instrukcja

8 Sierpnia 2024

Instrukcje głośnik

Najnowsze instrukcje dla głośnik

Yamaha

Yamaha DZR10-D Instrukcja

11 Grudnia 2024
Yamaha

Yamaha DZR15-D Instrukcja

11 Grudnia 2024
Yamaha

Yamaha DXS15XLF-D Instrukcja

11 Grudnia 2024
Yamaha

Yamaha NS-2000A Instrukcja

11 Grudnia 2024
Bogen

Bogen WMT1AS Instrukcja

11 Grudnia 2024
Ruark Audio

Ruark Audio Sabre-R Instrukcja

11 Grudnia 2024
Antelope

Antelope R4S Instrukcja

11 Grudnia 2024
Antelope

Antelope Atlas i8 Instrukcja

11 Grudnia 2024
MB

MB PESSPROVS62A Instrukcja

11 Grudnia 2024
MB

MB PESSPROVS32A Instrukcja

11 Grudnia 2024