Instrukcja obsługi Odyssey ODY-1716NX

Odyssey warkot ODY-1716NX

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Odyssey ODY-1716NX (6 stron) w kategorii warkot. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/6
INSTRUCTION & REFERENCE MANUAL
Model no. 1716NX
Extra Parts Available!
Visit Odyssey online to order:
• Extra Batteries
• New rotor blades
•4 GB Micro SD Memory Card
www.OdysseyToys.com
Follow us at
• Do not submerge the unit in any liquids.
• Keep the unit dry.
• Disconnect the unit and monitor from USB power
sources when not in use.
• Do not place the unit near powerful, un-shielded
magnets.
• Do not expose the unit to extreme hot or cold
temperatures.
• Do not hit, drop, or smash the unit with extreme force.
• Do not disassemble the unit for any reason.
NOT FOLLOWING THESE PRECAUTIONS WILL VOID
YOUR WARRANTY.
CAUTIONS, WARNINGS & NOTICES
GENERAL CARE & MAINTENANCE
Before operating your Pocket Drone for the first time, please read through the
following notices to be aware of proper drone and battery care.
Suitable for ages 12 and older. Adult supervision is always recommended.
This product contains small parts that are a choking hazard. Keep away from small children.
Keep the drone (the flying element) at least 10 feet away from yourself, other people, and objects during use.
Correctly assemble all parts of the Real Pocket Drone and fly it only under the guidelines of this instruction manual. Small
parts should be assembled by an adult.
Keep hands, hair, and loose clothing away from the propellers when powered on to prevent injury to yourself or damage
to the product.
The Real Pocket Drone should not be flown in windy conditions (winds of 5 MPH or stronger) or near any body of water.
Never leave a charging battery unattended. The battery may become damaged from overcharging.
Manufacturers and dealers disclaim all responsibility for damage caused by misuse.
Please retain this manual for future reference.
•
•
•
•
•
•
•
•
WHAT’S IN THE BOX
1
2
3
4
5
Pocket Drone Quadcopter Unit
2.4 GHz Controller
4 Replacement Propellers
3.7 V 550 mAh Rechargeable Battery
USB Charging Cable
6 4 GB Micro SD Memory Card
GETTING TO KNOW YOUR ODYSSEY TOYS POCKET DRONEHOW to MAINTAIN and TAKE CARE of your ODYSSEY TOYS DRONE BATTERIES
PLEASE REFERENCE THESE NOTICES ON THE BATTERIES FOR THE REMOTE CONTROL
Congratulations on your purchase of the new and revolutionary Odyssey Toys Pocket Drone.
Please read through all of the instructions thoroughly to ensure safe and longlasting operation.
Your Drone is furnished with a removable, rechargeable battery. Please pay careful attention to the following safety
instructions:
1. Use only the charging USB cord provided by Odyssey Toys for charging.
2. When charging the battery, if the battery is too hot it means the battery is overcharged. In such a case, stop charging the
battery immediately. Overcharging could damage the battery permanently.
3. After flying, the Drone’s battery temperature may be relatively high. Wait 10 minutes until the battery has cooled before
recharging.
4. Turn off both the Drone and Controller whenever it is not in use. If you don’t plan on flying your Drone for a time, charge
the battery for about 1 hour before storing it.
Caution: There is a risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to
local laws. Never leave this product unattended while charging—this can be a fire hazard.
Use only AAA non-rechargeable battery or AAA rechargeable battery in the controller. Do not mix the two types.
Insert batteries with correct polarity.
Do not short circuit the supply terminals.
Lithium ion batteries can be flammable if misused.
Do not mix old and new batteries.
Do not mix alkaline batteries, standard (carbon-zinc), or rechargeable (nickel-cadmium/NiCad) batteries.
Remove exhausted or drained batteries.
Remove rechargeable batteries before charging them.
Remove and store the batteries away from the Controller when not in use to avoid damage from battery leakage.
•
•
•
•
•
•
•
•
•
1
2
3 4 5 6
POCKET DRONE REMOTE CONTROL QUICK GUIDE
Directional StickThrottle Stick
Battery
Compartment
Joystick
Storage
SmartFLY Mode
Auto Return
Speed Mode
(3 Settings)
Power LED
Power SwitchTurning Trim Lateral Trim
Start/Stop
Video
Take
Picture
Forward/Backward
Trim
Not Used
Auto Hover
Auto Ignition
(Start/Stop)
2 3
SETTING UP YOUR CONTROLLER FOR THE FIRST TIME
CONTROLLER BUTTONS & FEATURE LOCATIONS
CHARGING THE POCKET DRONE RECHARGEABLE BATTERY
Directional StickThrottle Stick
Slide open the battery box cover and the joystick box
cover in the direction shown by the arrows
Insert the joysticks into the holes in the Controller
as shown by the arrows.
Install 4 AAA batteries in the orientation shown.
Battery
Compartment
Joystick
Storage
SmartFLY Mode
Auto Return
Speed Mode
(3 Settings)
Power LED
Start/Stop
Video
Take
Photo
Forward/Backward
Trim
Not Used
Auto Hover
Auto Ignition
(Start/Stop)
1Open and remove the Drone battery cover-grid. The Pocket Drone battery may be hot after use! Allow time Caution!
for it to cool.
Carefully remove the battery, but do not pull it by its wires, since this could cause damage. Disconnect the battery wire
connector from the Drone wire connector by carefully pulling apart the two connectors.
Connect the battery’s wire to the USB charging cable supplied. Then connect the USB to a computer, as
shown at right. The red light will illuminate when charging begins. The light will go out when the Drone’s
battery is fully charged. At that time, immediately remove the USB charging cable from the computer.
When charging through the included USB cable: The red LED light
illuminates to show the battery is charging. The red LED light goes out to
indicate charging is complete. Remove the charger from the computer
immediately. The battery usually comes with a partial charge from the
factory. It is recommended to use the Pocket Drone and completely
discharge the battery before charging for the first time.
1
2
3
2
3
4 5
INSTALLING the POCKET DRONE RECHARGEABLE BATTERY and MICRO SD CARD
Slide the switch in the direction shown by the arrow and remove the battery cover-grid.
Install the battery by carefully sliding the white connector on the battery wire into the white connector on
the wire in the Drone’s battery compartment. The two small silver contacts on each connector will touch.
Then replace the battery cover-grid. Install the SD card as shown. When you push in the Micro SD card, you
will hear it click and spring into place.
Battery
Cover
1
2
NOTICE
3.7V Battery
If you do not plan to use your transmitter for a
while, remove the batteries to avoid leakage and
damage to the unit.
CAUTION
Power SwitchTurning Trim
SmartFLY Mode –Automatically reassigns your device’s orientation while in flight. (See page 8)
Auto Return –Works with SmartFly Mode to return your drone while in flight. (See page 9)
Speed Setting –Switches three different speed settings: Beginner, Intermediate, Expert
(See page 9)
Throttle Stick –Controls speed of the propellers (See page 7)
Start/Stop Video–Starts and stops video recording on the drone
Take Photo - Snaps a picture while in flight
1.
2.
3.
4.
5.
6.
Power Switch –Turns the Controller on or off
Turning Trim –This will trim the drone from turning right or left on the same vertical axis by itself
Forward/Backward Trim –This will trim the drone from moving forward and backwards by itself
Lateral Trim –This will trim the drone from moving side to side by itself
Direction Stick –Turns the Drone in flight (See page 7)
Auto Ignition –Starts and stops the motors (See page 6)
Auto Hover –Sets the altitude lock on the Pocket Drone (See page 7)
7.
8.
9.
10.
11.
12.
13.
Lateral Trim

Specyfikacje produktu

Marka: Odyssey
Kategoria: warkot
Model: ODY-1716NX

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Odyssey ODY-1716NX, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje warkot Odyssey

Odyssey

Odyssey ODY-1716NX Instrukcja

7 Września 2024

Instrukcje warkot

Najnowsze instrukcje dla warkot

DJI

DJI Mavic 2 Enterprise Series Instrukcja

15 Października 2024
DJI

DJI Mini 4K Instrukcja

9 Października 2024
Xiaomi

Xiaomi FIMI X8 Mini Instrukcja

9 Października 2024
Hobbywing

Hobbywing XRotor X11 Plus Instrukcja

9 Października 2024
Hobbywing

Hobbywing XRotor X8 Instrukcja

9 Października 2024
DJI

DJI Neo Instrukcja

9 Października 2024
Denver

Denver PSQ-20008 MK2 Instrukcja

9 Października 2024
Denver

Denver LQI-105 Instrukcja

9 Października 2024
Kogan

Kogan Viper-X 3 Instrukcja

8 Października 2024
Kogan

Kogan Zenith Instrukcja

8 Października 2024