Instrukcja obsługi Novation Speedio

Novation Niesklasyfikowane Speedio

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Novation Speedio (13 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/13
CONTENTS
Contents
• •1
Introduction.................................................................
Main Features..............................................................
Connections And Software Installation....................
Connecting Up To Equipment......................................
Windows XP USB Driver Installation...........................
Mac OSX USB Driver Installation................................
The Windows Sound System.......................................
About ASIO..................................................................
The SpeedIO Control Panel.........................................
About Latency..............................................................
Main Features And Operation....................................
Front Panel Layout......................................................
Gain Boost Section......................................................
Phantom Power Section..............................................
Input Gain Section.......................................................
Line Out Level Control.................................................
USB Activity Section....................................................
Monitoring Section.......................................................
The Sample Rate And Power LEDs............................
Appendix......................................................................
Troubleshooting...........................................................
Approvals.....................................................................
2
2
3
3
4
4
5
5
5
6
7
7
8
8
9
9
10
10
11
12
12
13
SpeedIO v10.qxd 23/01/04 12:05 Page 1
INTRODUCTION
Main Features
• •2
Thank you for purchasing the Novation SpeedIO USB interface. The SpeedIO is a state of the art product -
it combines a 16 channel MIDI input and output interface along with a high quality audio interface.
When used with a computer running a MIDI / Audio sequencer package it will provide a superb, compact
recording setup with only a single USB cable required to connect both MIDI and Audio signals to the com-
puter.
Main Features
* Two Novation high precision, low noise high bandwidth audio pre-amplifiers with switchable
phantom power and over 70 dB headroom deliver a warm, clear signal typical of Novations
commitment to sonic excellence.
* Integrated USB low latency Audio and MIDI - Requires just a single USB connection a computer
(no PSU needed)
* Separate headphone and line output level controls allowing fast recording / monitoring
turnaround.
* Continuously variable Monitor control allows for direct hardware zero latency monitoring or low
latency software monitoring via the audio application.
* 44.1 / 48 Khz 16 / 24 bit simultaneous 2 channel Audio input and output operation with concur-
rent MIDI transmission and reception.
* Independent Gain controls with LED signal level and overload display. Each channel has 20dB
boost switches.
* Driver software included to run on Windows XP or Mac OSX Operating systems.
SpeedIO v10.qxd 23/01/04 12:05 Page 2
Connecting Up To Equipment
In order to record or replay Audio or MIDI data it will be necessary to connect the SpeedIO to a desktop or
laptop computer with the appropriate MIDI and Audio recording software installed.
The SpeedIO draws all its power requirements from the USB cable, and so no power adapter or batteries
are needed.
The SpeedIO requires approx 350mA of power to operate, dependent on various conditions. Switching on
the Phantom power or turning up the monitor volume in the headphones will add to the power consump-
tion. Although the USB specification dictates that all computers should be able to supply 500mA of current
which is ample, in practice some Laptops are not able to supply as much as this.
For use with Laptops supplying low levels of USB power, it may be necessary to connect the SpeedIO via
a powered USB hub.
USB Driver Software Installation
In order to use the SpeedIO, it must be connected to a computer system using the USB cable supplied.
The USB connector is located on the rear panel. Before it can communicate with the computer’s USB con-
nection port, a special piece of software known as a ‘USB driver’ must be installed.
The USB driver software converts information arriving at the computer’s USB port into the correct format
for use by the software Audio and MIDI interface used by the computers operating system. Most music
application software (Cubase, Logic, Sonar, Digital Performer etc) use this software Audio and MIDI inter-
face to communicate with external hardware devices such as the SpeedIO or MIDI controller keyboards
and sound modules.
The USB driver software is located on the supplied CD ROM and must be used with the Windows XP or
Mac OSX Operating System. If using a PC with a different operating systems such as Linux, Windows 95,
98SE or 2000 USB support will not be available.
CONNECTIONS AND SOFTWARE INSTALLATION
Connecting To Equipment - USB Driver Installation
• •3
Guitar Microphone
Powered Monitor Loudspeakers
Desktop ComputerLaptop Computer or
Sound Modules
SpeedIO v10.qxd 23/01/04 12:05 Page 3

Specyfikacje produktu

Marka: Novation
Kategoria: Niesklasyfikowane
Model: Speedio

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Novation Speedio, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Niesklasyfikowane Novation

Novation

Novation Launchkey MMini 25 K4 Instrukcja

8 Października 2024
Novation

Novation mm10-X Instrukcja

30 Września 2024
Novation

Novation Xio 49 Instrukcja

23 Września 2024
Novation

Novation FLkey Mini Instrukcja

22 Września 2024
Novation

Novation Launchpad Instrukcja

21 Września 2024
Novation

Novation A-Station Instrukcja

17 Września 2024
Novation

Novation nio 2|4 Instrukcja

16 Września 2024
Novation

Novation Supernova II Rack Instrukcja

15 Września 2024
Novation

Novation Launchkey 25 MK1 Instrukcja

15 Września 2024
Novation

Novation Bass Station Keyboard Instrukcja

15 Września 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024
Husqvarna

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024
Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024