Instrukcja obsługi Naim NAT05 XS

Naim Tuner NAT05 XS

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Naim NAT05 XS (34 stron) w kategorii Tuner. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/34
R E F E R E N C E M A N U A L
N A T 0 5 X S F M T U N E R
E N G L I S H , D E U T S C H , F R A N Ç A I S , I T A L I A N O
Page Section
E1 1 Connections
E1 2 Mains Power
E2 3 General Installation
E3 4 NAT05 XS Installation
E4 5 NAT05 XS Operation
E5 6 NARCOM 4 Remote Handset
E6 7 NAT05 XS Connections
E6 8 NAT05 XS Specification
E6 9 Declaration of Conformity
Contents
SAFETY INSTRUCTIONS
In order to comply with current European safety regulations
it is essential that the Naim loudspeaker connectors
supplied with amplifiers and loudspeakers are used.
Do not under any circumstances allow anyone to modify
your Naim equipment without first checking with the
factory, your retailer, or your distributor. Unauthorised
modifications will invalidate your guarantee.
Equipment must not be exposed to dripping or splashing
and no objects filled with liquid, such as vases, should be
placed on the equipment.
Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
For your own safety do not under any circumstances open
Naim equipment without first disconnecting it from the
mains.
Warning: an apparatus with CLASS I construction shall be
connected to a mains socket outlet with a protective
earthing connection.
Where the mains plug or an appliance coupler is used as
the disconnect device, the disconnect device shall remain
readily operable. To disconnect the equipment from the
mains remove the mains plug from the mains outlet.
The following label is attached to all mains powered
equipment:
W A R N I N G
THIS APPARATUS
MUST BE EARTHED
Products that display the crossed-out wheeled bin logo
cannot be disposed of as domestic waste. These products
must be disposed of at facilities capable of re-cycling them
and appropriately handling any waste byproducts. Contact
your local authority for details of the nearest such
facility. Appropriate recycling and waste disposal
helps conserve resources and protects the
environment from contamination.
E1
Naim products are conceived with performance as the top priority. Careful
installation will help ensure that their full potential is achieved. This manual covers the
NAT05 XS FM tuner. It begins with some general installation notes and statutory safety
warnings. Product specific information begins in Section 4.
Introduction
1 Connections
It is important for both safety and performance that
any standard cables supplied are not modified.
1.1 Analogue Audio Interconnect Cables
If options are available with your equipment and
installation, DIN interconnect sockets should be used in
preference to phono sockets. One end of each Naim
audio interconnect cable is marked with a band to
establish its correct orientation. The band denotes the
end that connects to the signal source. Naim Hi-Line
interconnect cables will provide the best results.
Audio interconnect plugs and sockets should be kept
clean and free from corrosion. The easiest way to clean
them is to switch off the equipment, pull the plugs out
of their sockets, and push them back in again. Contact
cleaners and “enhancers” should not be used as the film
they deposit may degrade the sound.
2 Mains Power
Where fused plugs are used 13 amp fuses should be
fitted. Fuses of a lower rating will fail after a period
of use. Do not wire voltage dependent resistors or
noise suppressors into mains plugs. They degrade the
mains supply and the sound.
2.1 Mains Plug Wiring
In some territories a mains plug may need to be fitted
to the supplied mains lead. As the colours of the wires in
the mains lead may not correspond with the coloured
markings identifying the terminals in the plug proceed as
follows:
The wire coloured must be GREEN-AND-YELLOW
connected to the terminal in the plug marked by the
letter or by the safety earth symbol or coloured or E GREEN
GREEN YELLOWand .
The wire coloured must be connected to the terminal BLUE
in the plug marked with the letter or coloured .N BLACK
The wire coloured must be connected to the BROWN
terminal in the plug marked with the letter or coloured L
RED.
2.2 Equipment Fuses
Mains powered Naim equipment is fitted with a mains
fuse on the rear panel adjacent to the mains input socket.
Replace it if necessary only with the spare fuse supplied or
with an identical fuse. Repeated failure of the fuse points
to a fault that should be investigated by your retailer or
Naim itself.
2.3 Non- rewirable M a ins Plugs
If a non-rewirable plug is cut from a mains lead (for
whatever purpose) the plug MUST be disposed of in a way
to render it totally useless. Considerable shock hazard exists
if the cut-off plug is inserted into a mains outlet.
2.4 Mains Circuits and Cables
A hi-fi system usually shares a mains circuit with other
household equipment, some of which can cause distortion
of the mains waveform. This distortion can in turn lead to
mechanical hum from mains transformers. Some Naim
transformers are large in size, making them relatively
sensitive to such distortion, and it may be necessary
to take account of transformer hum when siting your
equipment.
Transformer hum is not transmitted through the speakers
and has no effect on the performance of the system;
however, a separate mains circuit may reduce it. Such
a circuit (ideally with a 30 or 45 Amp rating) will also
generally improve system performance. Advice on the
installation of a separate mains circuit should be sought
from a qualified electrician.
Only use either the mains cable and plugs supplied or a
Naim Power-Line mains cable.


Specyfikacje produktu

Marka: Naim
Kategoria: Tuner
Model: NAT05 XS

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Naim NAT05 XS, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą