Instrukcja obsługi Naim CD5i

Naim Odtwarzacze/nagrywarki CD CD5i

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Naim CD5i (20 stron) w kategorii Odtwarzacze/nagrywarki CD. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/20
o w n e r s m a n u a L
C D P L a Y e r s
e n G L I s H D e u T s C H F r a n Ç a I s I T a L I a n 0
SAFETY INSTRUCTIONS
In order to comply with current European safety regulations
it is essential that the Naim loudspeaker connectors
supplied with amplifiers and loudspeakers are used.
Do not under any circumstances allow anyone to modify
your Naim equipment without first checking with the factory,
your retailer, or your distributor. Unauthorised modifications
will invalidate your guarantee.
Equipment must not be exposed to dripping or splashing
and no objects filled with liquid, such as vases, should be
placed on the equipment.
For your own safety do not under any circumstances open
Naim equipment without first disconnecting it from the
mains.
Warning: an apparatus with CLASS I construction shall
be connected to a mains socket outlet with a protective
earthing connection.
Where the mains plug or an appliance coupler is used as
the disconnect device, the disconnect device shall remain
readily operable. To disconnect the equipment from the
mains remove the mains plug from the mains outlet.
The following label is attached to all mains powered
equipment:
NOTE
This equipment has been tested and found to comply
with the relevant EMC and Safety Standards, and, where
applicable, also complies with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult your Naim retailer or an experienced radio/TV
technician for help.
W A R N I N G
THIS APPARATUS
MUST BE EARTHED
C o n t e n t s
Page Section
E1 1 Connections
E1 2 Mains Power
E2 3 General Installation
E3 4 CD 555 Introduction and Installation
E4 5 CD 555 Connections
E5 6 CD 555 In Use
E6 7 CDS3 Introduction and Installation
E7 8 CDS3 Connections
E8 9 CDS3 In Use
E9 10 CDX2 Introduction and Installation
E9 11 CDX2 Connections
E10 12 CDX2 In Use
E11 13 CD5 XS Introduction and Installation
E11 14 CD5 XS Connections
E12 15 CD5 XS In Use
E13 16 CD5 Introduction and Installationi
E13 17 CD5 Connectionsi
E13 18 CD5 In Usei
E14 19 CD Player Control and Operation
E15 20 R-com Handset
E16 21 Narcom 4 Handset
E17 22 Puck Identification
E17 23 Declarations
E1
1 Connections
It is important for both safety and performance that
the standard cables supplied are not modified.
1.1 Interconnect Ca bles
If options are available with your equipment and
installation, DIN interconnect sockets should be used in
preference to RCA Phono sockets. One end of each Naim
interconnect cable is marked with a band to establish
its correct orientation. The band denotes the end that
connects to the signal source.
Interconnect plugs and sockets should be kept clean
and free from corrosion. The easiest way to clean them
is to switch off the equipment, pull the plugs out of their
sockets, and push them back in again. Contact cleaners
and “enhancers” should not be used as the film they
deposit may degrade the sound.
1.2 Loud sp eaker Ca b les
Loudspeaker cables are vitally important. They should
each be at least 3.5 metres long and of equal length. The
recommended maximum is normally 20 metres although
longer cables may be viable with some Naim amplifiers.
Some Naim amplifiers are designed only to work with
Naim loudspeaker cable and using alternatives may
degrade the performance or even damage the amplifier.
Other Naim amplifiers can be used with any high quality
loudspeaker cable although we recommend that Naim
loudspeaker cable is used. Naim loudspeaker cable is
directional and should be oriented so that the printed
arrow points towards the speakers. The Naim loudspeaker
connectors supplied are designed to comply with
European safety legislation and must be used.
Contact your local retailer or distributor for further advice
on loudspeaker cables and connectors.
2 Mains Power
Where fused plugs are used 13 amp fuses should be
fitted. Fuses of a lower rating will fail after a period
of use. Do not wire voltage dependent resistors or
noise suppressors into mains plugs. They degrade the
mains supply and the sound.
2.1 Mains Plug Wiring
In some territories a mains plug may need to be fitted
to the supplied mains lead. As the colours of the wires in
Naim Audio products are conceived with performance as the top priority. Careful
installation will help ensure that their full potential is achieved. This manual covers the
CD 555, CDS3, CDX2, CD5 XS and CD5 CD players and their associated or upgrade i
power supplies. It begins with some general installation notes and statutory safety
warnings. Product specific information begins in Section 4.
the mains lead may not correspond with the coloured
markings identifying the terminals in the plug proceed as
follows:
The wire coloured GREEN-AND-YELLOW must be
connected to the terminal in the plug marked by the
letter E GREEN or by the safety earth symbol or coloured or
GREEN YELLOWand .
The wire coloured must be connected to the terminal BLUE
in the plug marked with the letter N BLACK or coloured .
The wire coloured BROWN must be connected to the
terminal in the plug marked with the letter or coloured L
RED.
2.2 Equip ment Fuses
Mains powered Naim Audio equipment is fitted with a
mains fuse on the rear panel adjacent to the mains input
socket. Replace it if necessary only with the spare fuse
supplied or with an identical fuse. Repeated failure of the
fuse points to a fault that should be investigated by your
retailer or Naim itself.
2.3 Non-rewirable Mains Plugs
If a non-rewirable plug is cut from a mains lead (for
whatever purpose) the plug MUST be disposed of in a
way to render it totally useless. Considerable shock hazard
exists if the cut-off plug is inserted into a mains outlet.
2.4 Mains Circuits and Ca bles
A hi-fi system usually shares a mains circuit with other
household equipment some of which can cause distortion
of the mains waveform. This distortion can in turn lead to
mechanical hum from mains transformers. Some Naim
transformers are large in size, making them relatively
sensitive to such distortion, and it may be necessary
to take account of transformer hum when siting your
equipment.
Transformer hum is not transmitted through the speakers
and has no effect on the performance of the system;
however, a separate mains circuit may reduce it. Such
a circuit (ideally with a 30 or 45 Amp rating) will also
generally improve system performance. Advice on the
installation of a separate mains circuit should be sought
from a qualified electrician.
Only use the mains leads and plugs supplied or alternative
Naim Audio items.
Introduction

Specyfikacje produktu

Marka: Naim
Kategoria: Odtwarzacze/nagrywarki CD
Model: CD5i

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Naim CD5i, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Odtwarzacze/nagrywarki CD Naim

Naim

Naim Uniti Core Instrukcja

28 Września 2024
Naim

Naim CD5i Instrukcja

28 Września 2024
Naim

Naim Uniti Instrukcja

28 Września 2024

Instrukcje Odtwarzacze/nagrywarki CD

Najnowsze instrukcje dla Odtwarzacze/nagrywarki CD

Marantz

Marantz PMD351 Instrukcja

15 Października 2024
Kärcher

Kärcher MC 6430 Instrukcja

11 Października 2024
Technics

Technics SL-PA10 Instrukcja

11 Października 2024
Reflexion

Reflexion PCD520MF Instrukcja

9 Października 2024
Auna

Auna Reference 802 Instrukcja

9 Października 2024
Advance

Advance X-CD1000 EVO Instrukcja

9 Października 2024
Soundmaster

Soundmaster SCD6500USB Instrukcja

8 Października 2024
Shanling

Shanling EC mini Instrukcja

7 Października 2024
Shanling

Shanling CD80 Instrukcja

7 Października 2024
Shanling

Shanling SCD1.3 Instrukcja

7 Października 2024