Instrukcja obs艂ugi Mount-It! MI-4223
Mount-It!
podpora 艣cienna
MI-4223
Przeczytaj poni偶ej 馃摉 instrukcj臋 obs艂ugi w j臋zyku polskim dla Mount-It! MI-4223 (7 stron) w kategorii podpora 艣cienna. Ta instrukcja by艂a pomocna dla 3 os贸b i zosta艂a oceniona przez 2 u偶ytkownik贸w na 艣rednio 4.5 gwiazdek
Strona 1/7
MOTORIZED TV CEILING MOUNT
MI-4223
MI-4223W
Please scan this QR code
to visit the product page.
Thank you for choosing Mount-It
2
Mount-It!
Mount-It!
4
1. The mount beeps constantly or is making an abnormal noise.
a). Reset the system: Press and hold the " " button for 5 seconds. The mount will retract to the highest position,
and the reset is complete.
c). If the beeps or noise continueplease contact Mount-It! for more assistance.
2. The TV mount stops moving during operation and emits a long beep.
a). Check to see if a foreign object is impeding the mount from moving. If so, remove the obstruction.
b). The weight of TV may exceed the maximum weight limitation of the mounting system.
c). Reset the system: Press and hold the " " button for 5 seconds. The mount will retract to the highest position,
and the reset is complete.If the problem persists please contact Mount-It! for more assistance.
3. The mount emits 2 short beeps, then stops.
Weight Capacity/Over-current protection: Ensure the mount is not over the weight capacity, then raise and lower
the mountcontinuously for 2 minutes until the mount stops moving. Unplug the power cable and wait approximately
20 minutes for the motor to cool, then plug it back in. The mount should resume normal operation.
4. The mount emits 2 sets of 2 short beeps.
The Mount is Overextended and needs to be reset: Disconnect the power adaptor then plug it in again, next press
and hold the " " button on the remote for 5 seconds. The mount will retract to the highest position, and the reset
is complete.
5. The mount emits 3 sets of 2 short beeps.
Operating Fault or Signal Error: Please contact Mount-It! for further assistance.
6. The mount emits 4 sets of 2 short beeps.
Mount strap is misaligned or stuck: Press the " " button to raise the mount to the highest position, if it will not
move or will not fully raise it will need to be reset, press and hold the " " button for 5 seconds. The mount will
retract to the highest position, and the reset is complete. If the mount still will not move, or is stuck in the highest
position the belt may be stuck. Please contact Mount-It! for assistance to manually reset the belt.
Specyfikacje produktu
| Marka: | Mount-It! |
| Kategoria: | podpora 艣cienna |
| Model: | MI-4223 |
Potrzebujesz pomocy?
Je艣li potrzebujesz pomocy z Mount-It! MI-4223, zadaj pytanie poni偶ej, a inni u偶ytkownicy Ci odpowiedz膮
Instrukcje podpora 艣cienna Mount-It!
31 Stycznia 2025
Instrukcje podpora 艣cienna
Najnowsze instrukcje dla podpora 艣cienna
21 Lutego 2025
21 Lutego 2025
20 Lutego 2025
20 Lutego 2025
20 Lutego 2025
5 Lutego 2025
30 Stycznia 2025
30 Stycznia 2025
30 Stycznia 2025