Instrukcja obsługi Mitsubishi WD-62725
Mitsubishi
Telewizory
WD-62725
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Mitsubishi WD-62725 (108 stron) w kategorii Telewizory. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/108
TV Information:
Use this space to record the model and serial numbers of
your television. This information is on the back of your TV.
Model number
Serial number
visit our website at
www.mitsubishi-tv.com
Owner’s Guide
Projection Television Models
WD-52525, WD-52725
WD-62525, WD-62725
TM
TM
The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user of
the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be sufficient
magnitude to constitute a risk of electric shock.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of
important operating and maintenance (servicing) instructions in the literature accompanying the
appliance.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
NOTE TO CATV SYSTEM INSTALLER: THIS REMINDER IS PROVIDED TO CALL THE CATV SYSTEM INSTALLER’S
ATTENTION TO ARTICLE 820-40 OF THE NEC THAT PROVIDES GUIDELINES FOR THE PROPER GROUNDING AND,
IN PARTICULAR, SPECIFIES THAT THE CABLE GROUND SHALL BE CONNECTED TO THE GROUNDING SYSTEM
OF THE BUILDING, AS CLOSE TO THE POINT OF CABLE ENTRY AS PRACTICAL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
This TV is very heavy! Exercise extreme care when lifting or moving. A minimum of two adults
should lift or move the TV.
Portions of the advanced circuitry of this TV must continue to operate even when the TV is turned
off. Some of these circuits therefore need to be cooled at all times. A low power standby fan may
be heard in a quiet environment. This is normal operation.
Custom cabinet installation must allow for proper air circulation around the television.
STAND REQUIREMENT
CAUTION: Mitsubishi TV models WD-52525 and WD-52725 are for use only with Mitsubishi stand, model MB-52525.
Mitsubishi TV models WD-62525 and WD-62725 are for use only with Mitsubishi stand model MB-62525. Use with
other stands is capable of resulting in instability causing possible injury.
FCC Declaration of Conformity
Product: Projection Television Receiver
Models: WD-52525, WD-52725, WD-62525, WD-62725
Responsible Party: Mitsubishi Digital Electronics America, Inc.
9351 Jeronimo Road
Irvine, CA 92618-1904
Telephone: 949-465-6000
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Mitsubishi could cause harmful interference and would
void the user’s authority to operate this equipment.
CAUTION: To assure continued FCC compliance, the user must use a shielded video interface cable
with bonded ferrite cores at both ends, when using the PC or HDMI input.
Specyfikacje produktu
| Marka: | Mitsubishi |
| Kategoria: | Telewizory |
| Model: | WD-62725 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Mitsubishi WD-62725, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Telewizory Mitsubishi
8 Sierpnia 2024
6 Sierpnia 2024
5 Lipca 2024
4 Lipca 2024
2 Lipca 2024
Instrukcje Telewizory
- Telewizory Sony
- Telewizory Samsung
- Telewizory LG
- Telewizory Sharp
- Telewizory Philips
- Telewizory Panasonic
- Telewizory Marquant
- Telewizory JVC
- Telewizory Funai
- Telewizory Aiwa
- Telewizory AKAI
- Telewizory Sanyo
- Telewizory Clatronic
- Telewizory Hitachi
- Telewizory Daewoo
- Telewizory Sylvania
- Telewizory Superior
- Telewizory EKO
Najnowsze instrukcje dla Telewizory
15 Stycznia 2025
14 Stycznia 2025
14 Stycznia 2025
13 Stycznia 2025
12 Stycznia 2025
12 Stycznia 2025
12 Stycznia 2025
15 Października 2024
15 Października 2024
14 Października 2024