Instrukcja obsługi Mini-Box picoPSU-150-XT
Mini-Box
Zasilanie komputera
picoPSU-150-XT
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Mini-Box picoPSU-150-XT (4 stron) w kategorii Zasilanie komputera. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/4
Mini-Box.com ATX DC-DC Converter Series
pixoPSU 150- -XT Quick Installation Guide Page 1
picoPSU 150- -XT
12V, 150Watt, 24pin ATX Power Supply
Quick Installation Guide
Version 1.0a
P/N picoPSU- -150 XT
Introduction
The picoPSU- -XT is a small yet powerful and fully compliant ATX power 150
supply designed to power a wide variety of motherboard from a single 12V
regulated power source.
The PICOPSU- -XT is the only snap power supply solution for general150
purpose motherboards. Compatible with an entire range of mini-ITX, UATX or full
size ATX motherboards the picoPSU- -XT provides cool, silent power for 150
system. The PICOPSU- -XT has many advantages over a regular power 150
supply:
- Smallest 24 pin ATX PSU to date
- silent operation100%
- Low heat dissipation with efficiency over 95%
- Plugs directly into the motherboard’s power connector, no cable mess
- Solid Capacitor design, very long life design.
- 12V Aux power connector designed to support processors with TDP of 35 or
65Watts.
- 2nd HDD power harness connector.
Mini-Box.com ATX DC-DC Converter Series
pixoPSU 150- -XT Quick Installation Guide Page 2
Quick installation Instructions
The PICOPSU- -XT has been specifically designed for the Mini-ITX form 150
factor, thus eliminating the need for ATX power cables. It is also 1U compliant –
height will not exceed 1U form factor.
1) After the picoPSU module was ‘snapped in’, hook the hard drive power or
floppy power to your floppy/hard drives. If more hard drives or floppy connectors
are needed, use a HDD/floppy “Y” splitter cable.
Fig 1.1 picoPSU-120 plugged into ATX connector.
2) Connect a 12 VDC power adapter (or any 12V source) to the DC- -to DC
connector, center pin / white wire is positive (+).
3) Turn on the PC using the motherboard ON/OFF switch
Typical configuration
The picoPSU- -XT has been tested with all mini- board under virtually any 150 ITX
disk/floppy/CDROM/PCI configuration. Additionally, the PICOPSU- -XT can 150
power boards that require 4 pin 12V aux power connector to be used with
processors with TDP ranging from 35 to 65watts.
Removing the picoPSU- -XT150
In order to remove the picoPSU you must release the power connector latch and
then remove the unit. Gently lift the picoPSU out from the ATX connector, by
grabbing from the picoPSU PCB, not from components or the wire harness.
Mini-Box.com ATX DC-DC Converter Series
pixoPSU 150- -XT Quick Installation Guide Page 3
Specifications, picoPSU- -XT, 150Watts DC-DC ATX Power Supply150
Power Ratings (max load = 150watts)
Volts (V)
Max Load (A)
Peak Load (A)
Regulation %
5V
6A
8A
+/- 1.5%
5VSB
1.5A
2A
+/- 1.5%
3.3V
6A
8A
+/- 1.5%
-12V
0.05A
0.1A
+/- 5%
12V
8A
10A
Switched input
Precautions for operating this DC-DC converter:
- For fan less operation de-rate the output of the 3.3 and 5V rails by ~35% or
ensure PSU surface temperature should not exceed 65C, whichever comes first.
- Combined and sustained output should not exceed 65% of total power or or
ensure PSU surface temperature should not exceed 65C, whichever comes first.
- Input current should not exceed 8A. For current higher loads, we suggest using
a 2x2 mini-FIT JR as an input connector.
- Peak load for individual rails should not exceed 60 seconds.
- For long life operation, PSU surface temperature should not exceed 65C.
Efficiency Ratings, 3.3 and 5V rail
CH1=5V
Efficiency (%)
CH2=3.3V
Efficiency (%)
1A
86%
1A
85%
3A
94%
3A
93%
5A
96%
5A
94%
8A
93%
8A
91%
Input Requirements: 12V regulated, min=2A, max = load dependent. Over-
voltage shutdown will occur at ~13-13.5V. Do not operate this PSU from a car
battery, as unit requires 12VDC regulated input voltage.
Size: 53mm(L) * 20mm(W) * 30mm (H) (1U compliant)
Weight: 60gramms, including cable harness, 30 grams without cable harness.
DC Jack: - Female, panel mount, 2.5*5.5*10 mm.
Specyfikacje produktu
| Marka: | Mini-Box |
| Kategoria: | Zasilanie komputera |
| Model: | picoPSU-150-XT |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Mini-Box picoPSU-150-XT, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Zasilanie komputera Mini-Box
2 Października 2024
2 Października 2024
2 Października 2024
2 Października 2024
2 Października 2024
2 Października 2024
2 Października 2024
Instrukcje Zasilanie komputera
- Zasilanie komputera LC-Power
- Zasilanie komputera StarTech.com
- Zasilanie komputera MSI
- Zasilanie komputera APC
- Zasilanie komputera Akasa
- Zasilanie komputera Cooler Master
- Zasilanie komputera Corsair
- Zasilanie komputera Ansmann
- Zasilanie komputera Pyle
- Zasilanie komputera FSP
- Zasilanie komputera Ewent
- Zasilanie komputera CLUB3D
- Zasilanie komputera Antec
- Zasilanie komputera Sharkoon
- Zasilanie komputera Silverstone
- Zasilanie komputera Thermaltake
- Zasilanie komputera Fractal Design
- Zasilanie komputera Be Quiet!
- Zasilanie komputera Chieftec
- Zasilanie komputera Allied Telesis
- Zasilanie komputera Steren
- Zasilanie komputera Fantec
- Zasilanie komputera ENDORFY
- Zasilanie komputera Xilence
- Zasilanie komputera Zalman
- Zasilanie komputera Seasonic
- Zasilanie komputera Zippy
- Zasilanie komputera AeroCool
- Zasilanie komputera Approx
- Zasilanie komputera 3Com
- Zasilanie komputera AZZA
- Zasilanie komputera CoolerMaster
- Zasilanie komputera FSP/Fortron
Najnowsze instrukcje dla Zasilanie komputera
9 Października 2024
9 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024