Instrukcja obsługi Metra ASWC-TOY-LEX

Metra nieskategoryzowany ASWC-TOY-LEX

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Metra ASWC-TOY-LEX (4 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
ASWC-TOY-LEX
I N S TA L L AT I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2017 METRA ELECTRONICS CORPORATION REV. 6/20/17 INSTASWC-TOY-LEX
INTERFACE FEATURES
INTERFACE COMPONENTS TOOLS REQUIRED
• Cutting tool • Crimping tool • Tape
• Connectors (example: butt-connectors, bell
caps, etc.)
TABLE OF CONTENTS
Connections to be made
–Into the vehicle .................................................2
–To the radio .......................................................2
Programming .........................................................3
Radio legend ..........................................................3
Troubleshooting ..................................................... 3
Extra Features ........................................................4
Resetting the ASWC-TOY-LEX ................................4
Axxess Steering Wheel Control interface
Toyota/Lexus Select vehicles 1999-2009
APPLICATIONS
• One Interface does it all - No additional interfaces needed
• Automatically programs the audio buttons on the steering wheel
• Auto detects what radio it’s connected to
• Works with most major radio brands
• Micro-B USB updatable
• All connections are made behind the radio
• Non-volatile memory retains settings even if the battery is
disconnected or the interface is removed from the vehicle
TOYOTA
Avalon 2003-2004
Prius 2001-2003
Sienna 1999-2003
LEXUS
GS300 / GS430 2001-2005
LX470 2001-2002
SC430 2002-2009
• ASWC-TOY-LEX interface
• ASWC-TOY-LEX harness
• Female 3.5mm connector with Brown and Brown/White wires
2
CONNECTIONS TO BE MADE
Into the vehicle
With the key in the off position:
1. Connect the Black wire of the ASWC-TOY-LEX to ground.
2. Connect the (2) Red wires of the ASWC-TOY-LEX to accessory power.
3. For all vehicles EXCEPT the Lexus SC430, connect ONLY the 12-pin connector to the
mating connector in the vehicle. The 6-pin connector on the ASWC-TOY-LEX harness
WILL NOT be used in the application.
4. For the 2002-2005 Lexus SC430, connect ONLY the 6-pin connector to the mating
connector in the vehicle. The 12-pin connector on the ASWC-TOY-LEX harness WILL
NOT be used in the application.
Note:
Disregard the 12-pin connector in the vehicle.
5. For the 2006-2009 Lexus SC430, connect BOTH the 6-pin and 12-pin connectors to
the mating connectors in the vehicle.
To the radio
1. For the radios below, connect the included female 3.5mm connector with the Brown
and Brown/White wires into the male 3.5mm connector of the ASWC-TOY-LEX
harness.
•
For Eclipse radios: Connect the Eclipse steering wheel control wires (normally
Brown Brown/Black Brown Brown/White and ) to the and wires of the ASWC-
TOY-LEX. Brown of the ASWC-TOY-LEX goes to the Brown/Black of the Eclipse and
Brown/White of the ASWC-TOY-LEX goes to the Brown of the Eclipse.
•
For Metra OE:
Connect the SWC Key 1 wire
(Gray)
to the
Brown
wire of the
ASWC-TOY-LEX. Isolate and tape the
Brown/White
wire, it will not be used.
•
For Kenwood or select JVC’s
with a
Blue/Yellow
steering wheel control wire
:
Connect the Kenwood/JVC steering wheel control wire to the
Brown
wire of the
ASWC-TOY-LEX. Isolate and tape the
Brown/White
wire, it will not be used.
Note:
Some of the newer Kenwood radios will auto detect as a JVC. If this is
the case, use a 12k ohm resistor in line between the Blue/Yellow and Brown
wire of the female 3.5mm jack during programming only (remove resistor once
programmed).
2. For Parrot Asteroid Smart or Tablet: Connect the ASWC-TOY-LEX male 3.5mm jack
into the AX-SWC-PARROT (sold separately) female 3.5mm jack and plug the 4-pin
end into the corresponding SWC plug on the radio.
Note:
AX-SWC-PARROT required (sold separately) and radio MUST BE updated to
rev 2.1.4 or higher.
3. For XITE radios: Connect the steering wheel control SWC-2 wire from the radio to
the Brown wire of the ASWC-TOY-LEX.
4. For all other radios: Connect the 3.5mm jack of the ASWC-TOY-LEX into the jack on
the aftermarket radio designated for an external steering wheel control interface.
Please refer to the aftermarket radios manual if in doubt as to where the 3.5mm
jack goes into.
3
REV. 6/20/2017 INSTASWC-TOY-LEX
PROGRAMMING RADIO LEGEND
1. Confirm that the 3.5mm connector is connected to your radio securely and in the correct
location.
2. If using the female 3.5mm connector in Eclipse, Kenwood, select JVC, or Metra OE radios,
verify that the radio’s steering wheel control wire is connected to the correct wire to the
ASWC-TOY-LEX.
Note:
Not every radio will have all the possible SWC commands on the steering wheel.
Please refer to the radio owner’s manual or contact the radio vendor for specific commands
that the radio will recognize.
The ASWC-TOY-LEX will auto program itself through Auto Detect Mode.
1. Turn the ignition on and wait until the L.E.D. in the ASWC-TOY-LEX lights up solid (about
twenty seconds).
Note:
Do not press any buttons on the steering wheel or radio during this time.
2. Once solid, cycle the key off, then back on.
Note:
The ASWC-TOY-LEX will give you two sets of L.E.D. feedback reports. The first set of
flashing green L.E.D. lights is for knowing the vehicle type and the second set of red flashing
L.E.D. lights is for knowing the radio type. Knowing the vehicle type is irrelevant as this
interface is pre-programmed for vehicles in the application list only. But knowing the radio
type is important for troubleshooting if the ASWC-TOY-LEX does not work. Please see the
below Radio Legend for L.E.D. feedback information for radio type.
1st L.E.D. flash is for Eclipse (type 1)
2nd L.E.D. flash is for Kenwood
3rd L.E.D. flash is for Clarion (type 1)
4th L.E.D. flash is for Sony and Dual
5th L.E.D. flash is for JVC
6th L.E.D. flash is for Pioneer & Jensen
7th L.E.D. flash is for Alpine*
8th L.E.D. flash is for Visteon
9th L.E.D. flash is for Valor
10th L.E.D. flash is for Clarion (type 2)
11th L.E.D. flash is for Metra OE
12th L.E.D. flash is for Eclipse (type 2)
13th L.E.D. flash is for LG
14th L.E.D. flash is for PARROT**
15th L.E.D. flash is for XITE
16th L.E.D. flash for Phillips
17th L.E.D. flash TBD
18th L.E.D. flash for JBL
*Note:
If the ASWC-1 flashes 7 times and you do not have an Alpine radio connected to it that means that
the ASWC-1 did not see any radio connected. Verify the 3.5mm connector is connected to the steering
wheel control input into the radio.
**Note:
The AX-SWC-PARROT is required (sold separately). The radio must be updated to rev. 2.1.4 or higher
from www.parrot.com and ASWC-1 must be updated to the latest firmware from www.axxessinterfaces.com.
TROUBLESHOOTING

Specyfikacje produktu

Marka: Metra
Kategoria: nieskategoryzowany
Model: ASWC-TOY-LEX

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Metra ASWC-TOY-LEX, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje nieskategoryzowany Metra

Metra

Metra 99-7382HG Instrukcja

17 Września 2024
Metra

Metra 99-3410 Instrukcja

17 Września 2024
Metra

Metra 99-7397B Instrukcja

17 Września 2024
Metra

Metra Axxess ANC-GMH1 Instrukcja

17 Września 2024
Metra

Metra 99-7421 Instrukcja

17 Września 2024
Metra

Metra Axxess ANC-CHH2 Instrukcja

17 Września 2024
Metra

Metra 99-8725B Instrukcja

17 Września 2024
Metra

Metra Axxess ANC-GMH2 Instrukcja

17 Września 2024
Metra

Metra AX-GMCL2 Instrukcja

29 Maja 2024
Metra

Metra 99-8153 Instrukcja

29 Maja 2024

Instrukcje nieskategoryzowany

Najnowsze instrukcje dla nieskategoryzowany

Asko

Asko DBI644MIB.S.TW/1 Instrukcja

28 Października 2024
Asko

Asko DFS233IB.S.TW/1 Instrukcja

28 Października 2024
Emko

Emko EZM-9920 Instrukcja

27 Października 2024
Emko

Emko ESM-3712-H Instrukcja

27 Października 2024
Emko

Emko ATS-10 Instrukcja

27 Października 2024
Emko

Emko EAOM-11.2 Instrukcja

27 Października 2024
Emko

Emko EPM-3790 Instrukcja

27 Października 2024
Emko

Emko EPM-7790 Instrukcja

27 Października 2024
Livarno Lux

Livarno Lux IAN 108340 Instrukcja

27 Października 2024
Livarno Lux

Livarno Lux HG06009A-BS Instrukcja

27 Października 2024