Instrukcja obsługi Marantec Comfort TU500
Marantec
Otwieracz do bramy garażowej
Comfort TU500
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Marantec Comfort TU500 (40 stron) w kategorii Otwieracz do bramy garażowej. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/40
COMFORT TU
TU500, TU800
Gear-motor for sliding gates
Getriebe für Schiebegitter
Motoriduttori per scorrevoli
Motoreducteur pour coulissants
Motorreductores para rejas correderas
Motorredutores para portões de correr
Napęd silnikowy do bram przesuwnych
Motoriduttore interrato
Under grounded gear motor
Motoreducteur enterré
Motorreductor interrado
Unrterflur-Drehtorantrieb
Motorredutor interrado
Podziemny motoreduktor
UNDER
Istruzioni ed avvertenze per l’installazione e l’uso
Instructions and warnings for installation and use
Instrucciones y advertencias para su instalación y uso
Anleitungen und Hinweise zu Installation und Einsatz
Instruções e advertências para a instalação e utilização
Instructions et avertissements pour l’installation et l’usage
Management
System
ISO 9001:2008
www.tuv.com
ID 9105043769
2
EN
INDEX
1
2
3
7
4
5
6
Safety warnings
2.1
2.2
4.1
4.2
4.3
4.4
4.5
5.1
5.2
Product overview
Product description
Set panel and technical characteristics
Preliminary checks
EC Declaration of Conformity
Installing the product
Installing
Fixing
Rack assembling
Limit switch xing
Manual running
Testing and commissioning
Testing
Commissioning
Figures
pag. 3
pag. 4
pag. 4
pag. 4
pag. 5
pag. 39
pag. 5
pag. 5
pag. 6
pag. 6
pag. 6
pag. 6
pag. 6
pag. 6
pag. 6
pag. 37
3
EN
1 - SAFETY WARNINGS
ORIGINAL INSTRUCTIONS - important safety instructions. Fol-
low the instructions since incorrect installation can lead to se-
vere inquiry! Save these instructions.
Read the instructions carefully before proceeding with installation.
The design and manufacture of the devices making up the
product and the information in this manual are compliant with
current safety standards. However, incorrect installation or
programming may cause serious injury to those working on or
using the system. Compliance with the instructions provided
here when installing the product is therefore extremely impor-
tant.
If in any doubt regarding installation, do not proceed and contact the
Marantec Technical Service for clarications.
Under European legislation, an automatic door or gate system
must comply with the standards envisaged in the Directive
2006/42/EC (Machinery Directive) and in particular standards
EN 12453; EN 12635 and EN 13241-1, which enable declaration
of presumed conformity of the automation system.
Therefore, nal connection of the automation system to the electri-
cal mains, system testing, commissioning and routine maintenance
must be performed by skilled, qualied personnel, in observance of
the instructions in the “Testing and commissioning the automation
system” section.
The aforesaid personnel are also responsible for the tests required
to verify the solutions adopted according to the risks present, and for
ensuring observance of all legal provisions, standards and regula-
tions, with particular reference to all requirements of the EN 12453
standard which establishes the test methods for testing door and
gate automation systems.
Before starting installation, perform the following checks and
assessments:
ensure that every device used to set up the automation system is
suited to the intended system overall. For this purpose, pay special
attention to the data provided in the “Technical specications” sec-
tion. Do not proceed with installation if any one of these devices is
not suitable for its intended purpose;
check that the devices purchased are sucient to guarantee system
safety and functionality;
perform a risk assessment, including a list of the essential safety
requirements as envisaged in Annex I of the Machinery Directive,
specifying the solutions adopted. The risk assessment is one of the
documents included in the automation system’s technical le. This
must be compiled by a professional installer.
Considering the risk situations that may arise during instal-
lation phases and use of the product, the automation system
must be installed in compliance with the following safety pre-
cautions:
never make modications to any part of the automation system other
than those specied in this manual. Operations of this type can only
lead to malfunctions. The manufacturer declines all liability for da-
mage caused by unauthorised modications to products;
if the power cable is damaged, it must be replaced by the manufac-
turer or its after-sales service, or in all cases by a person with similar
qualications, to prevent all risks;
do not allow parts of the automation system to be immersed in water
or other liquids. During installation ensure that no liquids are able to
enter the various devices;
should this occur, disconnect the power supply immediately and
contact a Marantec Service Centre. Use of the automation system in
these conditions may cause hazards;
never place automation system components near to sources of heat
or expose them to naked lights. This may damage system compo-
nents and cause malfunctions, re or hazards;
The drive shall be disconnected from its power source during
cleaning, maintenance and when replacing parts. If the discon-
nect device is not in a visible location, ax a notice stating:
“MAINTENANCE IN PROGRESS”:
connect all devices to an electric power line equipped with an
earthing system;
the product cannot be considered to provide eective protection
against intrusion. If eective protection is required, the automation
system must be combined with other devices;
the product may not be used until the automation system “commis-
sioning” procedure has been performed as specied in the “Automa-
tion system testing and commissioning” section;
the system power supply line must include a circuit breaker device
with a contact gap allowing complete disconnection in the conditions
specied by class III overvoltage;
use unions with IP55 or higher protection when connecting hoses,
pipes or cable glands;
the electrical system upstream of the automation system must com-
ply with the relevant regulations and be constructed to good wor-
kmanship standards;
this appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervi-
sion or instruction concerning use of the appliance in a safe way and
understand the hazards involved;
before starting the automation system, ensure that there is no-one
in the immediate vicinity;
before proceeding with any cleaning or maintenance work on the
automation system, disconnect it from the electrical mains;
special care must be taken to avoid crushing between the part ope-
rated by the automation system and any xed parts around it;
children must be supervised to ensure that they do not play with the
equipment.
that the drive cannot be used with a driven part incorporating a wi-
cket door unless the drive can only be operated with the wicket door
in the safe position;
The automation system component packaging material must
be disposed of in full observance of current local waste dispo-
sal legislation.
Marantec reserves the right to amend these instructions if ne-
cessary; they and/or any more recent versions are available at
www.marantec.com
Frequently examine the installation for imbalance where ap-
plicable and signs of wear or damage to cables, springs and
mounting.
Do not use if repair or adjustment is necessary.
ATTENTION !
ATTENTION !
ATTENTION !
ATTENTION !
ATTENTION !
Specyfikacje produktu
Marka: | Marantec |
Kategoria: | Otwieracz do bramy garażowej |
Model: | Comfort TU500 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Marantec Comfort TU500, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Otwieracz do bramy garażowej Marantec
30 Września 2024
30 Września 2024
26 Września 2024
26 Września 2024
25 Września 2024
25 Września 2024
25 Września 2024
25 Września 2024
25 Września 2024
25 Września 2024
Instrukcje Otwieracz do bramy garażowej
- Otwieracz do bramy garażowej Hormann
- Otwieracz do bramy garażowej Einhell
- Otwieracz do bramy garażowej Chamberlain
- Otwieracz do bramy garażowej Somfy
- Otwieracz do bramy garażowej LiftMaster
- Otwieracz do bramy garażowej Craftsman
- Otwieracz do bramy garażowej Abon
- Otwieracz do bramy garażowej Berner
- Otwieracz do bramy garażowej Sommer
- Otwieracz do bramy garażowej Maveo
- Otwieracz do bramy garażowej Doco
- Otwieracz do bramy garażowej Novoferm
- Otwieracz do bramy garażowej Tormatic
- Otwieracz do bramy garażowej FAAC
- Otwieracz do bramy garażowej MAC
- Otwieracz do bramy garażowej Superrollo
- Otwieracz do bramy garażowej Dickert
- Otwieracz do bramy garażowej DITEC
- Otwieracz do bramy garażowej Geba Tronic
- Otwieracz do bramy garażowej Profitech
- Otwieracz do bramy garażowej Seculux
- Otwieracz do bramy garażowej Homentry
- Otwieracz do bramy garażowej Doorsystems
- Otwieracz do bramy garażowej Novotecnica
- Otwieracz do bramy garażowej Entrematic
- Otwieracz do bramy garażowej Skylink
Najnowsze instrukcje dla Otwieracz do bramy garażowej
9 Października 2024
30 Września 2024
29 Września 2024
28 Września 2024
28 Września 2024
27 Września 2024
27 Września 2024
27 Września 2024
27 Września 2024
27 Września 2024