Instrukcja obsługi Louroe Electronics Verifact K

Louroe Electronics mikrofon Verifact K

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Louroe Electronics Verifact K (4 stron) w kategorii mikrofon. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
VERIFACT K
MICROPHONE
INSTALLATION AND OPERATING INSTRUCTIONS
Page 1 of 4 K_mic_inst_12/14
6955 VALJEAN AVE, VAN NUYS, CA 91406
PH: (818)994-6498 / FAX: (818)994-6458
/ www.louroe.com
techsupport@louroe.com
®
®
® ®
®
DESCRIPTION
The Verifact Model K is a dynamic line level microphone
with a directional pattern. The modified pattern is one in
which the audio pick up is more from the front of the
microphone and less from the sides and back. It is especially
designed for areas with excessive background noise or
where the ambient sound level is high. The V ®
erifact Model
K is pre-amplified, produces line level output and is
compatible with all Louroe audio base stations and interface
adapters.
When mounting, position the V ®
erifact K so that microphone
element is facing the desired area of coverage. Microphone
functions best when it is mounted close to the area to the
monitored, 3’ - 8’ away. A vibration pad is included and may
the use if the microphone wii be subject to vibration (eg:
transportation vehicles)
SPECIFICATIONS
Frequency Response
Output
Current Drain
100 Hz to 15 kHz
Line Level (0 dB, 600W @1kHz)
10 mA
Supply voltage 12 Vdc
Weight
Shipping Weight
2.5 oz
1 lb
Dimensions 4 3/8”L x 2 “W x 1 3/4”H
Type Dynamic, -58dBV@ 94dB SPL
Polar Pattern Modified Directional
IMPORTANT NOTICE
When this equipment is used as part of an
audio monitoring system, the law requires
that the public be given notice of AUDIO
MONITORING ON THE PREMISES. A
decal notice is included with each
microphone shipped.
Federal Law References:
Federal Regulations, US Code, Title 18.
Crime and Criminal Procedure, Sec 2510.
AUDIO
MONIT ORING
On
Th ese P remises
®
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: sales@louroe.com
(818)
WARRANTY
LOUROE ELECTRONICS warrants that at the time of shipment products manufactured by LOUROE ELECTRONICS to be free of defects in material and workmanship.
Should a defect appear within two year (24 months) from date of shipment, LOUROE ELECTRONICS will, at its sole discretion, repair or replace the defective equipment.
This equipment shall not be accepted for repair or return without prior notification by LOUROE ELECTRONICS .
This warranty does not extend to any Louroe product that has been subjected to improper or incorrect installation, misuse, accident, or in violation of installation
instructions provided by LOUROE ELECTRONICS.
Returned shipments to LOUROE ELECTRONICS shall be at customer’s expense. LOUROE ELECTRONICS will return the equipment prepaid via best way.
®
®
®
®
®
®
CONNECTION TO A LOUROE BASE STATION OR TO IF-1, IF-4, IF-8 INTERFACE ADAPTER
After microphone connection has been made, run cable to the Louroe Base Station or Interface Adapter. All
Louroe Base Stations and Interface Adapters have a corresponding terminal block (A, B, C) for each zone.
Make connections to the terminal block from microphone wire, matching A to A, B to B and C to C. If using
cable from other manufacturers with a different color code, make certain that wire colors are properly matched
between microphone and base station.
CONNECTION TO A LOUROE MICROPHONE MIXER (RN-2 or MLA-6)
Refer to Installation Instructions for the specified mixer.
IF VERIFACT K MICROPHONE IS BEING CONNECTED DIRECTLY TO AN AUDIO RECEIVER
OTHER THAN A LOUROE BASE STATION OR (DVR, IP NETWORK
CAMERA, ETC), CONNECT AS FOLLOWS (See interconnection diagram on the last page)
1. Apply 12Vdc power to terminals A and C.
(A is positive, C is negative)
2. Connect Terminal B (audio out) and Terminal C of Verifact K Microphone to the recorder or audio receiving
device using single conductor cable, 22 gauge with a drain wire. See interconnection diagramshielded
using different types of plugs on last page. The black wire is used instead of the drain wire (bare) for color
coding purposes only.
INTERFACE ADAPTER
MICROPHONE CONNECTION
On the bottom of the Verifact K housing is a 3- pin terminal block
marked A, B, C:
A = 12Vdc (positive) Red Wire
B = Audio Out Black Wire
C = Ground (negative) Bare Wire
Using recommended wiring:
1 - Connect RED wire to terminal A
2 - Connect BLACK wire to terminal B
3 - Connect Bare wire to terminal C
INSTALLATION AND OPERATING INSTRUCTIONS
Page 2 of 4
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: sales@louroe.com
(818)
®
USING THE VIBRATION PAD
Remove sensitivity switch cover from the vibration pad. Peel off the paper from the adhesive back of the pad.
Before sticking the pad to the back to the Verifact K. make sure it is position so that the Sensitivity switch
opening lines up with the switch cutout on the pad. See the picture below for proper mounting of pad.
VERIFACT K
WITH
VIBRATION PAD
SENSITIVITY SWITCH OPENING
®
®
®
®
®
K_mic_inst_12/14
VERIFACT K MICROPHONE CONNECTION
TO A LOUROE™ BASE STATION
OR
IF-1, IF-4, IF-8 AUDIO INTERFACE ADAPTER
SENSITIVITY SWITCH
N = Normal
L = Low
Position L lowers the gain by 11dB
and is used when there is excessive
background noise, or if less audio
output is desired.
To Receiving Device
(Base Station, Interface Adapter or Mixer)
INSTALLATION AND OPERATING INSTRUCTIONS
Page 3 of 4
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: sales@louroe.com
(818)
®
A B C
L N
VERIFACT K
®
BARE
BARE
BARE
BAREBARE
BLACK
BLACK
BLACK
BLACKBLACK
RED
RED
RED
REDRED
A
A
A
AA B
B
B
BB C
C
C
CC
BLACK
BLACK
BLACK
BLACKBLACK BARE
BARE
BARE
BAREBARE
RED
RED
RED
REDRED
2 Conductor cable, 22 shielded
gauge with a 24 gauge drain wire
NOTE: Unshielded cable is not
satisfactory for audio systems
WIRING REQUIREMENTS
West Penn 452 or equivalent
SENSITIVITY SWITCH CUTOUT
®
K_mic_inst_12/14

Specyfikacje produktu

Marka: Louroe Electronics
Kategoria: mikrofon
Model: Verifact K

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Louroe Electronics Verifact K, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje mikrofon Louroe Electronics

Louroe Electronics

Louroe Electronics Verifact B Instrukcja

10 Marca 2025
Louroe Electronics

Louroe Electronics Verifact C Instrukcja

10 Marca 2025
Louroe Electronics

Louroe Electronics Verifact K Instrukcja

10 Marca 2025
Louroe Electronics

Louroe Electronics C-ML Instrukcja

10 Marca 2025
Louroe Electronics

Louroe Electronics Verifact L-DT Instrukcja

10 Marca 2025
Louroe Electronics

Louroe Electronics DV-ML Instrukcja

10 Marca 2025
Louroe Electronics

Louroe Electronics D-ML Instrukcja

10 Marca 2025
Louroe Electronics

Louroe Electronics Verifact AGC Instrukcja

10 Marca 2025

Instrukcje mikrofon

Najnowsze instrukcje dla mikrofon

Comica

Comica Vimo C2 Instrukcja

12 Marca 2025
Elgato

Elgato Wave Desk Stand Instrukcja

4 Marca 2025
Bogen

Bogen GCU250 Instrukcja

1 Marca 2025
Bogen

Bogen MGN19A Instrukcja

1 Marca 2025
Bogen

Bogen GDU150 Instrukcja

1 Marca 2025
Audio-Technica

Audio-Technica ATM355 Instrukcja

1 Marca 2025
Neumann

Neumann SM 69 Instrukcja

28 Lutego 2025
Bogen

Bogen SCU250 Instrukcja

27 Lutego 2025
Neumann

Neumann TLM 170 Instrukcja

27 Lutego 2025
Countryman

Countryman B6 Instrukcja

15 Stycznia 2025