Instrukcja obsługi Louroe Electronics AOP-SP70

Louroe Electronics Konwerter audio/wideo AOP-SP70

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Louroe Electronics AOP-SP70 (8 stron) w kategorii Konwerter audio/wideo. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/8
Page 1 of 8 aopsp70_ inst_3/15
DESCRIPTION
MODEL AOP-SP70 AUDIO CONVERSION UNIT
Model AOP-SP70 is usually paired with the TLO to convert the signals of Model
TLO for compatibility with the receiving device for providing two-way audio. The
AOP-SP70 drives the audio signals into the audio input and output of the IP
Camera, etc, for transmission over the network and to an existing computer (or
other devices) at the receiving site. Person at the receiving site hears the audio
through the computer speaker or through a headphone. For talkback to the
remote site (TLO location), the computer’s microphone is used to transmit audio
back through the network to the AOP-SP70. It is then amplified and sent out to
the speaker portion of the remote TLO. The AOP-SP70 provides power to the
TLO and contains adjustments for microphone gain and speaker volume. A 12Vdc
power supply is included with the AOP-SP70.
MODEL TLO OUTDOOR SPEAKER/MICROPHONE
Model TLO is a two-way speaker and microphone and re-entry horn for high
volume penetration. Weatherized for outdoor applications, the microphone and
speaker horn are all within one housing. In operation, the TLO together with the
AOP-SP70 provides hands-free bi-directional audio communication with the audio
receiving device (DVR, IP Camera, etc.).
MODEL AOP-SP70
Speakerphone Conversion Unit MODEL TLO
Outdoor Speaker/Microphone
WIRING REQUIREMENTS
3 Conductor consisting of:
+
2 Conductor , 20 gauge shielded
with 22 gauge drain
+
1 Conductor , 20 gauge unshielded
All in the same jacket
West Penn 358 or equivalent
WIRING REQUIREMENTS
4 Conductor consisting of:
+
2 Conductor , 20 gauge shielded
with 22 gauge drain (microphone
connection)
+
2 Conductor , 18 gauge unshielded
(speaker connection)
All in the same jacket
West Penn 356 or equivalent
FOR AOP-SP70
FOR TLO
AOP-SP70
SPEAKERPHONE CONVERTER
INSTALLATION AND OPERATING INSTRUCTIONS
6955 VALJEAN AVE, VAN NUYS, CA 91406
PH: (818)994-6498 / FAX: (818)994-6458
/ www.louroe.com
techsupport@louroe.com
®
LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: sales@louroe.com
(818)
WIRING REQUIREMENTS
4 Conductor consisting of:
+
2 Conductor , 20 gauge shielded
with 22 gauge drain (microphone
connection)
+
2 Conductor , 18 gauge unshielded
(speaker connection)
All in the same jacket
West Penn 356 or equivalent
SPEAKER CONNECTION OF TLO
MICROPHONE CONNECTION OF TLO
Speaker connection is located near the rear of the TLO and has a plexiglass window. Remove window and
connect the speaker portion of West Penn 356 ( and wires) to the two terminal screws marked 1 green white
and 2.
Green speaker wire goes to position 1 (positive)
White speaker wire goes to position 2 (negative)
The short cable extending from the back of the TLO is the microphone connection and consists of three wires:
red, black bare and . Using recommended wiring (West Penn 356 or equivalent), make microphone
connections using 20 gauge wire nuts and matching wire with , with and wire with red red black black bare
bare wire. See diagram next page.
see diagram below
Color code may vary if using wiring from other manufacturers
POWER TAP SETTINGS OF TLO
Located above the speaker connection of TLO is a set screw with a dial numbered 1 through 7. Using a small
screw driver, adjust the set screw to correspond to the proper power tap as shown below.
I Louroe Model TLO connected to Louroe AOP-SP70
conversion unit for interfacing with a DVR or IP Network Camera, use: #2 3.8W
Setting Wattage
12
1
2
3 5
6
7
Speaker connection
(WHITE-negative)
Speaker connection
(GREEN-positive)
1 through 7
power tap settings
set screw
WIRING CONNECTIONS TO MODEL TLO
COLOR CODE FOR RECOMMENDED CABLE
Red - 12Vdc Power
Black - Audio Output
Bare - Ground
Green - Speaker Positive
White - Speaker Ground
}
}
Microphone Portion
Speaker Portion
INSTALLATION AND OPERATING INSTRUCTIONS
Page 2 of 8
LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: sales@louroe.com
(818)
aopsp70_ inst_3/15
WIRING DIAGRAM OF MODEL TLO OUTDOOR SPEAKER/MICROPHONE
POSITIONING TLO
After TLO has been mounted to desired structure (wall, pole, etc.), horn should be tilted in a downward position.
This will protect the microphone element from water damage.
See page 5
for connection diagram
12
1
2
3 5
6
7
RED
(12Vdc)
BLACK
(audio output)
BARE
(ground) MOUNTING
ARM
WEST PENN 356
MICROPHONE
CONNECTION {
Microphone connection
using three wire nuts
Red wire to red = 12Vdc
Black wire to black = Audio Output
Bare wire to bare = Ground
(C) BARE
(A) RED
(B) BLACK
To
Louroe AOP-SP70
Audio Conversion Unit
Green = speaker (positive)
White = speaker (negative)
Speaker terminal screws
green wire to #1 (positive)
white wire to #2 (ground)
Speaker Connections
green - positive
white - ground
1
2
MICROPHONE
CABLE
MICROPHONE PC BOARD
AND HOUSING
INSTALLATION AND OPERATING INSTRUCTIONS
Page 3 of 8
LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: sales@louroe.com
(818)
aopsp70_ inst_3/15

Specyfikacje produktu

Marka: Louroe Electronics
Kategoria: Konwerter audio/wideo
Model: AOP-SP70

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Louroe Electronics AOP-SP70, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Konwerter audio/wideo Louroe Electronics

Louroe Electronics

Louroe Electronics AOP-SP70 Instrukcja

10 Marca 2025

Instrukcje Konwerter audio/wideo

Najnowsze instrukcje dla Konwerter audio/wideo

Recom

Recom R-78AA6.5-0.5SMD Instrukcja

10 Marca 2025
Recom

Recom R-78AA3.3-1.0SMD Instrukcja

10 Marca 2025
Recom

Recom R-78AA15-0.5SMD Instrukcja

10 Marca 2025
Recom

Recom R-78AA9.0-0.5SMD Instrukcja

10 Marca 2025
Recom

Recom R-78C15-1.0 Instrukcja

10 Marca 2025
Recom

Recom R-78AA3.3-0.5SMD Instrukcja

10 Marca 2025
Recom

Recom R-78E3.3-0.5 Instrukcja

10 Marca 2025
Recom

Recom RBE-0505S Instrukcja

10 Marca 2025
Recom

Recom RS6-2405S Instrukcja

10 Marca 2025
Recom

Recom R-78E15-0.5 Instrukcja

10 Marca 2025