Instrukcja obsługi Logik L20CTH18
Logik
ogrzewacz pomieszczeń
L20CTH18
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Logik L20CTH18 (4 stron) w kategorii ogrzewacz pomieszczeń. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/4
Safety Warnings
For your continued safety and to reduce the risk of injury or electric shock, please
follow all the safety precautions listed below. Read all instructions carefully before
using the unit and keep them for future reference.
• Retain the manual. If you pass the unit onto a third party, make sure to include this
manual.
• This appliance is intended for indoor household use and similar applications such
as:
– farm houses and by clients in hotels, motels and other residential type
environments;
– bed and breakfast type environments;
– catering and similar non-retail applications.
• Make sure your home voltage matches the voltage displayed on the appliance. If
you are not sure, contact an electrician.
• Do not kink or wrap the mains cable and plug around the appliance, as this
may cause the insulation to weaken and split, particularly where it enters the
appliance.
• Ensure the mains cable is fully extended before use and arrange it so that it is not
in contact with any part of the appliance.
• Do not pull on the mains cable. Never move, carry or hang the appliance by the
mains cable.
• Always position the appliance with the mains plug in an accessible position and
avoid the use of an extension cable as it may overheat and create a potential re
risk.
• The appliance must have a minimum 50 cm clearance around all sides of the
appliance.
• Ensure that the unit is used on a stable and level surface. If the oor surface is
uneven there is a risk that the appliance could tip over. Also, excessive vibration
and noise may occur. If the appliance should be accidentally tipped over, please
immediately disconnect from the power supply.
• Do not use the appliance in wardrobes or near fabrics or clothing. Do not stand the
appliance on deep pile carpets.
• Do not use the appliance in areas where petrol, paints or other ammable
substances are used or stored.
• Do not use in very dusty areas as dust may accumulate on the heating elements
and cause overheating.
• Do not use if there are any visible signs of damage to the appliance.
• Do not operate the appliance in direct sunlight, near heat sources, humid
environments or in places near water or other liquids such as bathrooms, showers
or swimming pools.
• Do not operate with wet hands or spill water or other liquids on to the appliance,
the mains cable or plug.
• Always unplug the appliance when not in use.
• Never leave the appliance unattended when in use.
• CAUTION: Some parts can become very hot and cause burns. Particular
attention has to be given where children and vulnerable people are present.
• The heater must not be located immediately below a mains socket.
• Do not allow children to play with the appliance or sit, stand, or climb on it.
• Do not leave children alone or unattended in the area where the appliance is in
use.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualied person in order to avoid a hazard.
• This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall
not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
• Children of less than 3 years old should be kept away unless continuously
supervised.
• Children aged from 3 years and less than 8 years shall only switch on/o the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved. Children
aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
• Do not block or restrict the airow around the appliance. Position the unit so that
the air inlet and exhaust grilles are not blocked or restricted in anyway.
• Do not push any objects in the air inlet and exhaust grilles.
• Do not use the appliance with a programmer, timer or any other device that
switches the appliance on automatically. A re risk exists if the appliance is covered
or positioned incorrectly.
WARNING
In order to avoid overheating, do not cover the appliance.
IT IS HAZARDOUS FOR ANYONE OTHER THAN AUTHORISED SERVICE
PERSONNEL TO CARRY OUT SERVICING OF REPAIRS WHICH INVOLVE THE
REMOVAL OF COVERS.
TO AVOID THE RISK OF AN ELECTRICAL SHOCK DO NOT ATTEMPT REPAIRS
YOURSELF.
DSG Retail Ltd. (co. no. 504877)
1 Portal Way, London, W3 6RS, UK
The symbol on the product or its packaging indicates that this product must not be disposed
of with your other household waste. Instead, it is your responsibility to dispose of your waste
equipment by handing it over to a designated collection point for the recycling of waste
electrical and electronic equipment. The separate collection and recycling of your waste
equipment at the time of disposal will help conserve natural resources and ensure that it is
recycled in a manner that protects human health and the environment.
For more information about where you can drop o your waste for recycling, please contact
your local authority, or where you purchased your product.
All trademarks are the property of their respective owners and all rights are acknowledged.
IB-L20CTH18-180627V1
Visit Partmaster.co.uk today for the easiest way to buy electrical spares and
accessories. With over 1 million spares and accessories available we can deliver
direct to your door the very next day. Visit www.partmaster.co.uk or call 0344 800
3456 (UK customers only). Calls charged at National Rate.
Thank you for purchasing your new product.
We recommend that you spend some time reading this instruction manual in order that
you fully understand all the operational features it oers.
Read all the safety instructions carefully before use and keep this instruction manual for
future reference.
Ceramic Tower Heater
Instruction Manual
L20CHT18
This product is only suitable for well-insulated spaces or occasional use.
For general information about this appliance and handy hints and tips, please visit:
www.TeamKnowhow.com/discover 0344 561 1234 or call
Product Overview
Unpacking
Remove all items from the packaging. Retain the packaging. If you dispose of it please do so
according to local regulations.
The following items are included:
• Main Unit
• Front Base
• Rear Base
• Screw x 4
Heating Function
Position the heater upright on the oor away from curtains, furniture or wall coverings before
plugging your heater into the mains socket.
• Connect the heater to the mains socket. Be sure the mains plug ts tightly in the mains
socket. A loose t will cause overheating and damage the mains plug.
• Switch the heater on by turning the Power Dial, the power indicator will illuminate.
: The heating element is o, only the fan is operating.
The heater will blow cool air out from the air outlet.
Lo: The heater is in low heat mode.
Hi: The heater is in high heat mode.
• The heater is equipped with an oscillation feature. To obtain a wider fan and heat circulation,
turn the Power Dial to the fan and heat symbols with on top.
• Adjust the Thermostat Dial to the desired position. It is recommended to select the “Max”
position to get the heater to heat up. When the heater temperature is higher than the room
temperature, the heater will continue working, but when the room temperature is higher
than the heater temperature, the heater will turn o automatically.
• To switch the heater o, turn the Power Dial 0 to “ ” position. Remove the mains plug from
the mains socket.
Cleaning
Your heater should be cleaned regularly to prevent dirt and dust from building up which will
aect its performance. Ensure the air inlet and the air outlet are not blocked. This can be done
with a vacuum cleaner, using the brush attachment.
Hints & Tips
My heater does not work when I turn it on
• Check that your heater is plugged in and the power is turned on at the mains socket.
• The heater may be overheating. Switch it o and allow it to completely cool down for at least
30 minutes, then switch it on again.
• Check that your heater is in an upright position.
• Check if the thermostat setting is too low.
• If the heater still does not work, do not try to repair the heater yourself.
If your heater’s power is automatically cut o follow the steps
below:
1. Unplug your heater and allow it to cool down for at least 30 minutes.
2. Inspect your heater. Clean your heater, if necessary. If there is any sign of physical damage
(e.g. melting or burning of the case), do not attempt to use your heater. Please leave all
maintenance work to qualied personnel.
3. Plug in the heater and switch it on again. If it cuts o again, leave all maintenance work to
qualied personnel.
Installation
1. Lay down the unit on a at stable surface, with the rear side facing up.
2. Unscrew the mains cable guard from the rear base.
3. Fit the rear base on the unit. Guide the
mains cable through the centre of the
rear base and t it into the groove of
the rear base. Screw the mains cable
guard onto the mains cable to secure
it on the rear base.
4. Connect the front base with the rear base.
5. Fix the front and rear base onto the unit by
screwing the four screws securely.
Safety Protective Devices
Overheat Protection System
The power to the heater will automatically cut o if the temperature of the heater exceeds a
certain limit. In the event of overheating, the heater will stop operating. Switch the heater o
and allow it to completely cool for at least 30 minutes. The heater will then resume operating as
normal.
Specications
Model L20CTH18
Mains supply 220-240V ~50Hz
Power consumption 1900W
Features and specications are subject to change without prior notice.
Rear Base
Front Base
Tip-over Protective Switch
When you use the heater in an upright position on a at and stable surface, the tip-over
protective switch will be on. In the event the heater is knocked over, the heater will stop
functioning automatically.
Mains Cable
Guard
Groove
Front
Base
Rear
Base
• If items are missing or damaged, please contact Partmaster (UK only).
• Tel: 0344 800 3456 for assistance.
• It is normal for the heater to emit some smell and fumes when it is turned on for
the rst time or when turned on after not being used for a long period of time. This
smell will disappear when the heater has been turned on for a short while.
• This unit will not operate if not positioned on a at stable surface or if the
thermostat setting is too low.
• Ensure you unplug your heater from the mains socket and wait for the heater to
cool down completely before cleaning.
• Do not use any detergents or abrasives and do not allow any water to enter the
heater.
Model L20CTH18
Item Symbol Value Unit Unit Item
Heat output Type of heat input, for electric
storage local heaters only (select
one)
Nominal heat
output
Pnom 1.9 kW Manual heat charge control
with integrated thermostat
no
Minimum
heat output
(indicative)
Pmin 1.093 kW Manual heat charge control
with room and/or outdoor
temperature feedback
no
Maximum
continuous heat
output
Pmax,c 2.112 kW Electronic heat charge control
with room and/or outdoor
temperature feedback
no
Auxiliary electricity consumption Fan assisted heat output no
At nominal heat
output
elmax 0.03 kW Type of heat output/room
temperature control (select one)
At minimum heat
output
elmin 0.03 kW Single stage heat output and
no room temperature control
no
In standby mode el
SB N/A kW Two or more manual stages, no
room temperature control
no
With mechanic thermostat
room temperature control
yes
With electronic room
temperature control
no
Electronic room temperature
control plus day timer
no
Electronic room temperature
control plus week timer
no
Other control options (multiple
selections possible)
Room temperature control,
with presence detection
no
Room temperature control,
with open window detection
no
With distance control option no
With adaptive start control no
With working time limitation no
With black bulb sensor no
Contact details DSG Retail Ltd. (co. no. 504877)
1 Portal Way, London, W3 6RS, UK
Product Fiche
Thermostat Dial
Base
Power
Indicator
Air Outlet
Power Dial (with
oscillation option)
The heater cannot be switched on when it is overheating. Allow it to cool down for at
least 30 minutes and then switch it on again.
• Do not override the tip-over protective switch as this may cause a hazard.
• Using the unit on a deep pile carpet may activate the tip-over protective switch.
Specyfikacje produktu
| Marka: | Logik |
| Kategoria: | ogrzewacz pomieszczeń |
| Model: | L20CTH18 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Logik L20CTH18, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje ogrzewacz pomieszczeń Logik
24 Sierpnia 2024
24 Sierpnia 2024
24 Sierpnia 2024
24 Sierpnia 2024
24 Sierpnia 2024
24 Sierpnia 2024
24 Sierpnia 2024
Instrukcje ogrzewacz pomieszczeń
- ogrzewacz pomieszczeń Smeg
- ogrzewacz pomieszczeń Caso
- ogrzewacz pomieszczeń SilverCrest
- ogrzewacz pomieszczeń Midea
- ogrzewacz pomieszczeń Grundig
- ogrzewacz pomieszczeń Honeywell
- ogrzewacz pomieszczeń Neff
- ogrzewacz pomieszczeń Trotec
- ogrzewacz pomieszczeń ProfiCook
- ogrzewacz pomieszczeń Qlima
- ogrzewacz pomieszczeń TriStar
- ogrzewacz pomieszczeń Dimplex
- ogrzewacz pomieszczeń Blyss
- ogrzewacz pomieszczeń Zibro
- ogrzewacz pomieszczeń Edilkamin
- ogrzewacz pomieszczeń Alde
- ogrzewacz pomieszczeń Eurom
- ogrzewacz pomieszczeń Proline
- ogrzewacz pomieszczeń Bestron
- ogrzewacz pomieszczeń Profile
- ogrzewacz pomieszczeń Anslut
- ogrzewacz pomieszczeń Ernesto
- ogrzewacz pomieszczeń Eldom
Najnowsze instrukcje dla ogrzewacz pomieszczeń
20 Września 2024
15 Września 2024
15 Września 2024
15 Września 2024
15 Września 2024
15 Września 2024
11 Września 2024
11 Września 2024
11 Września 2024
10 Września 2024