Instrukcja obsługi La Crosse Technology 404-1246

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla La Crosse Technology 404-1246 (2 stron) w kategorii Klok. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/2
18 INDOOR | O UT D O OR
ATOMIC WAL L CLOC K
Model: 404-1246
DC: 083020
For information about WWVB, Atomic Time Signal visit: bit.ly/AtomicTime
Page | 1Page | 4
WARR AN T Y I N F O
La Crosse Technology, Ltd. provides a (from date of purchase) on this 1-year limited time warranty
product relating to manufacturing defects in materials & workmanship.
La Crosse Technology, Ltd
2830 S. 26th St.
La Crosse, WI 54601
For Full Warranty Details, Visit: www.lacrossetechnology.com/support
CAR E + M A I NT E N A NCE
Do not mix old and new batteries.
Do not mix Alkaline, Lithium, standard, or rechargeable batteries.
Always purchase the correct size and grade of battery most suitable for intended use.
Clean the battery contacts and also those of the device prior to battery installation.
Ensure the batteries have with correct polarity (+ / -).
Remove batteries from equipment that will not to be used for an extended period.
Promptly remove expired batteries.
FCC S TAT EM E NT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Connect the equipment into an outlet on a circuit dierent from that to which the receiver is
connected.
Increase separation between equipment & receiver.
Consult the dealer or an experienced radio/TV technician for help.
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
Operation is subject to the following two conditions:
(1 ) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
CAUTION!
The manufacturer is not responsible for any radio or TV interference caused by unauthorized changes
or modifications to this equipment. Such changes or modifications could void the user authority to
operate the equipment.
All rights reserved. This manual may not be reproduced in any form, even in part, or duplicated or
processed using electronic, mechanical or chemical process without the written permission
of the publisher.
This booklet may contain errors or misprints. The information it contains is regularly checked and
corrections are included in subsequent editions. We disclaim any responsibility for any technical error
or printing error, or their consequences. All trademarks and patents are recognized.
WARNING: This product can expose you to chemicals including styrene, which is known to the
State of California to cause cancer. For more information go to: www.P65Warnings.ca.gov
P O W E R U P
1. Remove the round Battery Cover to access the Movement.
2. Insert 1 AA battery into the Center Battery Compartment.
Optional: Insert batteries into the Extra Battery Compartments.
IMPORTANT: Be sure all batteries are of the same voltage level.
3. The hands will move to either the 4, 8, or 12 o’clock position and
stay there while it searches for the WWVB Atomic Time Signal.
Allow up to 5 nights for the clock to receive this transmission.
4. For the best reception, place the clock on an exterior wall near a
window with the front or back of it facing Fort Collins, CO.
5. Once the Atomic Time Signal is received, the clock will set to
Pacific Time. Firmly press and hold your correct Time Zone
Button until the hands begin to spin. The time will then set
correctly.
6. If you live in an area that does not follow Daylight Saving Time,
while the hands are spinning to the correct time, press the
Daylight Saving Time Button once to turn the DST setting to OFF.
Note: In certain areas, this clock may not be able to receive the
WWVB reception due to signal strength or interference. In this case,
your clock can be set manually until the Atomic Time Signal can be
received.
Manual Set Tab
Center Battery
Time Zone Buttons
Daylight Saving Time Button
(Default is DST ON)
1. Remove all batteries from the clock.
2. Press the Manual Set Tab at least 20 times and wait 15 minutes.
3. Insert at least one battery into the Center Battery Compartment.
4. Allow the hands to spin around and stop in either the 4, 8, or 12
o’clock position.
5. Hold the Manual Set Tab until your correct time is achieved.
Note: The Atomic Time Signal will override your manual setting if
the transmission is received in the future.
4
3
2
1
M A N UAL LY S E T T I ME
Ask questions, watch detailed setup videos, and provide feedback
on our social media outlets!
L E T S B E SOCI A L !
Page | 3
Page | 2
Battery Requirements: 1 AA (IEC LR6) required in movement
Optional: 2 AA (IEC LR6) for added battery life
All batteries sold separately.
Battery Life: 1 Battery - 12 months, 3 Batteries - 36 months
S P E C I F I C ATI O N S
5Optional:
Extra Battery Compartments
PT
PT
PT
PT
PTPT MT
MT
MT
MT
MTMT CT
CT
CT
CT
CTCT ET
ET
ET
ET
ETET
AA
AA
AA
+
+
+
+
++
+
+
+
+
++
-
-
-
-
--
-
-
-
-
-- 4
3
2
1
55

Specyfikacje produktu

Marka: La Crosse Technology
Kategoria: Klok
Model: 404-1246

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z La Crosse Technology 404-1246, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Klok La Crosse Technology

Instrukcje Klok

Najnowsze instrukcje dla Klok