Instrukcja obsługi Kyocera FS1200

Kyocera drukarka FS1200

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Kyocera FS1200 (119 stron) w kategorii drukarka. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/119
Table of Contents
FS-1200
User’s Manual
Kyocera Laser Printer
Introduction
i
Caution
NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION.
Notice on Software
SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S EMULATION MODE. The printer is
factory-set to emulate the PCL 6. The emulation mode can be changed by following the procedures described in Chapter
2.
Notice
The information in this manual is subject to change without notification. Additional pages may be inserted in future
editions. The user is asked to excuse any technical inaccuracies or typographical errors in the present edition.
No responsibility is assumed if accidents occur while the user is following the instructions in this manual. No responsi-
bility is assumed for defects in the printer's firmware (contents of its read-only memory).
This manual, any copyrightable subject matter sold or provided with or in connection with the sale of the page printer,
are protected by copyright. All rights are reserved. Copying or other reproduction of all or part of this manual, any
copyrightable subject matter without the prior written consent of Kyocera Corporation is prohibited. Any copies made
of all or part of this manual, any copyrightable subject must contain the same copyright notice as the material from which
the copying is done.
Regarding Tradenames
PRESCRIBE is a registered trademark of Kyocera Corporation. PRESCRIBE 2e, KPDL, and KIR2 (Kyocera Image
Refinement 2) are trademarks of Kyocera Corporation.
Diablo 630 is a product of Xerox Corporation. IBM Proprinter X24E is a product of International Business Machines
Corporation. Epson LQ-850 is a product of Seiko Epson Corporation.
Hewlett-Packard, PCL, and PJL are registered trademarks of Hewlett-Packard Company. Centronics is a trade name
of Centronics Data Computer Corp. PostScript is a registered trademark of Adobe Systems Incorporated. Macintosh is
a registered trademark of Apple computer, Inc. AppleTalk is a trademark of Apple Computer, Inc. Microsoft, Windows,
and MS-DOS are registered trademarks of Microsoft Corporation. PowerPC is a trademark of International Business
Machines Corporation. ENERGY STAR is a U.S. registered mark.
This Kyocera page printer uses PeerlessPrintXL to provide the HP LaserJet compatible PCL6 language emulation.
PeerlessPrintXL is a trademark of The Peerless Group, Redondo Beach, CA 90278, U.S.A.
This product was developed using the Tornado™ Real Time Operating System and Tools from Wind River Systems.
Contains UFST™ and MicroType® from Agfa Corporation.
© 1999 by Kyocera Corporation. All rights reserved, Revision 1.2., September 1999
Introduction
ii
IBM PROGRAM LICENSE AGREEMENT
THE DEVICE YOU HAVE PURCHASED CONTAINS ONE OR MORE SOFTWARE PROGRAMS ("PROGRAMS")
WHICH BELONG TO INTERNATIONAL BUSINESS MACHINES CORPORATION ("IBM"). THIS DOCUMENT
DEFINES THE TERMS AND CONDITIONS UNDER WHICH THE SOFTWARE IS BEING LICENSED TO YOU BY
IBM. IF YOU DO NOT AGREE WITH THE TERMS AND CONDITIONS OF THIS LICENSE, THEN WITHIN 14 DAYS
AFTER YOUR ACQUISITION OF THE DEVICE YOU MAY RETURN THE DEVICE FOR A FULL REFUND. IF YOU
DO NOT SO RETURN THE DEVICE WITHIN THE 14 DAYS, THEN YOU WILL BE ASSUMED TO HAVE AGREED
TO THESE TERMS AND CONDITIONS.
The Programs are licensed not sold. IBM, or the applicable IBM country organization, grants you a license for the
Programs only in the country where you acquired the Programs. You obtain no rights other than those granted you under
this license.
The term "Programs" means the original and all whole or partial copies of it, including modified copies or portions
merged into other programs. IBM retains title to the Programs. IBM owns, or has licensed from the owner, copyrights
in the Programs.
1. License
Under this license, you may use the Programs only with the device on which they are installed and transfer possession
of the Programs and the device to another party.
If you transfer the Programs, you must transfer a copy of this license and any other documentation to the other party.
Your license is then terminated. The other party agrees to these terms and conditions by its first use of the Program.
You may not:
1) use, copy, modify, merge, or transfer copies of the Program except as provided in this license;
2) reverse assemble or reverse compile the Program; or
3) sublicense, rent, lease, or assign the Program.
2. Limited Warranty
The Programs are provided "AS IS."
THERE ARE NO OTHER WARRANTIES COVERING THE PROGRAMS (OR CONDITIONS), EXPRESS OR
IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE.
Some jurisdictions do not allow the exclusion of implied warranties, so the above exclusion may not apply to you.
SUPPLEMENT TO AGREEMENT FOR SOFTWARE BUNDLING AND DISTRIBUTION FOR ALDC
3. Limitation of Remedies
IBM's entire liability under this license is the following;
1) For any claim (including fundamental breach), in any form, related in any way to this license, IBM's liability will be
for actual damages only and will be limited to the greater of:
a) the equivalent of U.S.$25,000 in your local currency; or
b) IBM's then generally available license fee for the Program
This limitation will not apply to claims for bodily injury or damages to real or tangible personal property for which IBM
is legally liable.
IBM will not be liable for any lost profits, lost savings, or any incidental damages or other economic consequential
damages, even if IBM, or its authorized supplier, has been advised of the possibility of such damages. IBM will not be
liable for any damages claimed by you based on any third party claim. This limitation of remedies also applies to any
developer of Programs supplied to IBM. IBM's and the developer's limitations of remedies are not cumulative. Such
developer is an intended beneficiary of this Section. Some jurisdictions do not allow these limitations or exclusions, so
they may not apply to you.
Introduction
v
Interface connectors
Important note on the interface connectors
Be sure to turn off printer power before connecting or disconnecting an interface cable to the printer. For
protection against static discharge which may be applied to the printer's internal electronics through the
interface connector(s), keep the optional paper handler/stacker connector (see page 1-6) which is not in use
capped using the protective cap supplied.
☛Use shielded interface cable.
Safety information
Laser safety
This printer is certified as a Class 1 laser product under the U.S. Department of Health and Human Services
(DHHS) Radiation Performance Standard according to Radiation Control for Health and Safety Act of 1968.
This means that the printer does not produce hazardous laser radiation. Since radiation emitted inside the
printer is completely confined within protective housings and external covers, the laser beam cannot escape
from the printer during any phase of user operation.
Laser notice
This printer is certified in the U.S. to conform to the requirements of DHHS 21 CFR Subchapter for Class I
(1) laser products, and elsewhere is certified as a Class I laser product conforming to the requirements of
IEC 825-1.
Caution Invisible laser radiation when open. Avoid direct exposure to beam.
Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure.
(European/Asian
countries)
(U.S.A./Canada)
Introduction
viii
The manufacturer and its merchandising companies retain the following technical documentation in antic-
ipation of the inspection that may be conducted by the authorities concerned.
User's instruction that conforms to the applicable specifications
Technical drawings
Descriptions of the procedures that guarantee the conformity
Other technical information
KYOCERA ELECTRONICS EUROPE GmbH
Mollsfeld 12
40670 Meerbusch, Germany
Phone: +49 21 59 918 0
Fax: +49 21 59 918 100
Declaration of Conformity (Australia)
Manufacturer's name: Kyocera Corporation, Printer Division
Manufacturer's address: 2-14-9 Tamagawadai, Setagaya Ward, Tokyo 158-8610, Japan
declares that the product
Product name: Page Printer
Model number: FS-1200 (as tested with enhancement optional units:
PF-20, DU-20, HS-20 and ST-20 etc.)
Description of device: This Page Printer Model FS-1200 is the 12ppm; A4 size and utilized plane paper;
laser; dry toner etc. The printer can be equipped with several enhancement optional units as a paper feeder
as PF-20, a duplexer as DU-20, a paper handler/stacker as HS-20, a bulk paper stacker as ST-20 etc.
Conforms to the following product specifications.
AS/NZS 3548: 1995 (EN 55 022:1998 Class B)
IEC60950 (EN 60 950:1992+A1+A2+A3+A4)
IEC60825-1 (EN 60 825-1:1994+A11)
The manufacturer and its merchandising companies retain the following technical documentation in antic-
ipation of the inspection that may be conducted by the authorities concerned.
User's instruction that conforms to the applicable specifications
Technical drawings
Descriptions of the procedures that guarantee the conformity
Other technical information.
Introduction
ix
The manufacturer has been employed with ISO9001 scheme. The manufacturer has been attested by JQA
and BS.
KYOCERA ELECTRONICS AUSTRALIA PTY., LTD
Unit 6, 112 Talavera Road, North Ryde NSW 2113, Australia
Phone: +61 2-9888-9999
Fax: +61 2-9888-9588
Canadian Department of Communications compliance statement
This Class B digital apparatus complies with Canadian ICES-003.
Avis de conformité aux normes du ministère des Communications du
Canada
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
ISO 7779
Maschinenlärminformationsverordnung 3. GSGV, 18.01.1991: Der höchste Schalldruckpegel beträgt 70
dB(A) oder weniger gemäß ISO 7779.
Disclaimer
We shall have no liability or responsibility to customers or any other person or entity with respect to any
liability, loss or damage caused or alleged to be caused directly or indirectly by equipment sold or furnished
by us, including but not limited to, any interruption of service, loss of business or anticipatory profits, or con-
sequential damages resulting from the use or operation of the equipment or software.

Specyfikacje produktu

Marka: Kyocera
Kategoria: drukarka
Model: FS1200

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Kyocera FS1200, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje drukarka Kyocera

Kyocera

Kyocera ECOSYS P2135dn Instrukcja

15 Października 2024
Kyocera

Kyocera TASKalfa 8052ci Instrukcja

13 Października 2024
Kyocera

Kyocera ECOSYS P2235dn Instrukcja

12 Października 2024
Kyocera

Kyocera ECOSYS MA4000wifx Instrukcja

9 Października 2024
Kyocera

Kyocera ECOSYS PA4000x Instrukcja

9 Października 2024
Kyocera

Kyocera ECOSYS PA4000wx Instrukcja

9 Października 2024
Kyocera

Kyocera FS-6530MFP/KL3/FAX Instrukcja

8 Października 2024
Kyocera

Kyocera 6530MFP Instrukcja

3 Października 2024
Kyocera

Kyocera FS-1135MFP/KL3 Instrukcja

1 Października 2024
Kyocera

Kyocera ECOSYS MA3500cix Instrukcja

26 Września 2024

Instrukcje drukarka

Najnowsze instrukcje dla drukarka

Brother

Brother DCP-L1632W Instrukcja

11 Marca 2025
Brother

Brother HL-L1232W Instrukcja

11 Marca 2025
Brother

Brother MFC-L2880DW Instrukcja

10 Marca 2025
Phoenix Contact

Phoenix Contact Topmark Neo Instrukcja

5 Marca 2025
AgfaPhoto

AgfaPhoto Realipix Pocket P Instrukcja

27 Lutego 2025
AgfaPhoto

AgfaPhoto Realipix Mini P.2 Instrukcja

27 Lutego 2025
Evolis

Evolis KC Max Instrukcja

25 Lutego 2025
Evolis

Evolis KC Prime Instrukcja

25 Lutego 2025
Evolis

Evolis KC Essential Instrukcja

25 Lutego 2025
Evolis

Evolis KM500B Instrukcja

25 Lutego 2025