Instrukcja obsługi Kodak i3400

Kodak skaner i3400

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Kodak i3400 (47 stron) w kategorii skaner. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/47

Safety

User Precautions

• Place the scanner on a sturdy, level work surface capable of supporting 20.4 kg (45 lbs) and leave adequate clearance on all

sides of the scanner. When relocating the scanner, it is recommended that two people lift the scanner and use safe lifting

techniques.

• Do not install the scanner in a location subject to dust, humidity or steam. This may cause electrical shock or a fire. Only use

the scanner indoors in a dry location.

• Make sure the electrical power outlet is located within 1.52 meters (5 feet) of the scanner and is easily accessible.

• When disconnecting equipment from the electric socket, be sure to grasp the plug, not the cord.

• Be sure the power cord is securely plugged into the wall outlet. Failure to do so may cause electrical shock or fire.

• Do not damage, knot, cut or modify the power cord or use a damaged power cord. This may cause electrical shock or fire.

• The scanner requires a dedicated and properly grounded power outlet. Do not use an extension cord or power strip with the

scanner.

• Leave sufficient space around the power outlet so it can be easily unplugged in case of an emergency.

• Do not disassemble, service or modify the scanner except as explained in the User’s Guide.

• Do not move the scanner with the power cord and interface cable attached. This may cause damage to the cord/cable.

Remove the power cord from the wall outlet before moving or relocating the scanner.

• Follow the Kodak recommended cleaning procedures. Do not use air, liquid or gas spray cleaners. These cleaners displace

dust, dirt and debris to other locations within the scanner, which may cause the scanner to malfunction.

• Material Safety Data Sheets (MSDS) for chemical products are available on the Kodak website at: www.kodak.com/go/msds.

When accessing the MSDSs from the website, you will be required to provide the catalog number of the consumable you

want the Material Safety Data Sheet for. See the section entitled, “Supplies and consumables” later in this guide for supplies

and catalog numbers.

Users and their employers need to observe the common sense precautions applicable to the operation of any machinery. These

include, but are not limited to, the following:

• Do not wear loose clothing, unbuttoned sleeves, etc.

• Do not wear loose jewelry, bracelets, bulky rings, long necklaces, etc.

• Hair length should be kept short, using a hair net if needed, or tying long hair up in a bundle.

• Remove all other loose objects from the area that could be drawn into the machine.

• Take sufficient breaks to maintain mental alertness.

• Use only the recommended cleaning supplies.

• Do not use canned/compressed air.

Supervisors should review their employee practices and make compliance with these precautions a part of the job description

for operation of the scanner or any mechanical device.

Warning labels

CAUTION: Moving parts, avoid contact.

Environmental information

• The Kodak i3200/i3400 Scanner is designed to meet worldwide environmental requirements.

• In the USA, go to www.kodak.com/go/recycle for information on how to return this product for recycling or resuse.

• Guidelines are available for the disposal of consumable items that are replaced during maintenance or service; follow local

regulations or contact Kodak locally for more information.

• The product packaging is recyclable.

•Kodak i3200/i3400 Scanners are Energy Star compliant and shipped from the factory with the default time set to 15 minutes.

European Union

This symbol indicates that when the last user wishes to discard this product, it must be sent to appropriate

facilities for recovery and recycling. Please contact your local Kodak representative or refer to www.kodak.com/

go/recycle for additional information on the collection and recovery programs available for this product.

Please consult www.kodak.com/go/REACH for information about the presence of substances included on the candidate list

according to article 59(1) of Regulation (EC) No. 1907/2006 (REACH).

Acoustic emission

Maschinenlärminformationsverordnung – 3, GSGV

Der arbeitsplatzbezogene Emissionswert beträgt <70 dB(A).

[Machine Noise Information Ordinance — 3, GSGV

The operator-position noise emission value is <70 dB(A).]

EMC statements

United States: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part

15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for additional suggestions.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to

operate the equipment. Where shielded interface cables have been provided with the product or specified additional

components or accessories elsewhere defined to be used with the installation of the product, they must be used in order to

ensure compliance with FCC regulation.

Korea: As this equipment has obtained EMC registration for household use, it can be used in an area including residential

areas.

Japan: This is a Class B product based on the standard of the Voluntary Control Council for interference by information

Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may cause radio

interference. Install and use the equipment according to the instruction manual.

Specyfikacje produktu

Marka:	Kodak
Kategoria:	skaner
Model:	i3400
Kolor produktu:	Black, Grey
Wbudowany wyświetlacz:	Tak
Częstotliwość wejściowa AC:	50 - 60 Hz
Wysokość produktu:	238 mm
Szerokość produktu:	431.8 mm
Głębokość produktu:	371 mm
Waga produktu:	15800 g
Certyfikat środowiskowy (zrównoważonego rozwoju):	ENERGY STAR
Tryb wyłączenia:	0.5 W
Port USB:	Tak
Obsługiwane systemy operacyjne Mac:	Mac OS X 10.10 Yosemite, Mac OS X 10.7 Lion, Mac OS X 10.8 Mountain Lion, Mac OS X 10.9 Mavericks
Typ ekranu:	LCD
Zakres temperatur (eksploatacja):	15 - 35 °C
Zakres wilgotności względnej:	15 - 80 %
Ekran dotykowy:	Nie
Kod zharmonizowanego systemu (HS):	84716070
Pobór mocy w trybie czuwania:	2.8 W
Pobór mocy:	75 W
Obsługiwany systemy operacyjne Linux:	Ubuntu 14.04
Napięcie:	100-240 V
Maksymalna temperatura termometru zwilżonego (wet bulb temp.) Podczas eksploatacji (w °f):	59 - 95 °F
Typ skanera:	Skaner ADF
Technologia skanowania:	Dual CCD
Typ zasilacza:	Prąd przemienny
Maksymalny rozmiar papieru ISO (seria A):	A3
Dołączone oprogramowanie:	Capture Pro Limited Edition, Asset Management, NewSoft Presto! PageManager
Podwójne skanowanie:	Tak
Optyczna rozdzielczość skanowania:	600 x 600 DPI
Głębokość koloru wyjścia:	24 bit
Wyjściowa głębokość skali szarości:	8 bit
Pojemność automatycznego podajnika papieru:	250 ark.
Standardowe interfejsy:	USB 2.0, USB 3.2 Gen 1 (3.1 Gen 1)
Wersja USB:	3.2 Gen 1 (3.1 Gen 1)
Typ przetwornika obrazu:	Dual CCD
Minimalna ilość pamięci RAM:	4000 MB
Poziomy skali szarości:	256
Maksymalny format skanowania:	305 x 4100 mm
Skanowanie w kolorze:	Tak
Skanowanie kliszy:	Nie
Prędkość skanowania ADF (cz/b, A4):	90 stron/min
Prędkość skanowania ADF (kolor, A4):	90 stron/min
Prędkość skanowania duplex ADF (kolor, A4):	180 ipm
Formaty plików (scanner):	BMP, JPG, PDF, RTF, TIFF
Maksymalny dzienny cykl pracy:	20000 stron(y)
Sterowniki skanera:	ISIS, TWAIN, WIA
Gramatura nośników do automatycznego podajnika papieru:	34 - 413 g/m²
Wykrywanie sklejonych stron:	Tak
Obsługiwane nośniki skanowania:	Business Card, Plain paper
Obsługa liniowych kodów kreskowych (1D):	Codabar, Code 128, Code 25 (IR 2 of 5), EAN-13, EAN-8, U.P.C.
Połączenie z PC:	USB 2.0
Źródło światła:	LED
Poziom głośności skanowania:	60 dB
List:	Tak
Prędkość skanowania duplex ADF (cz/b, A4):	180 ipm
Czarnobiałe skanowanie:	Skala szarości