Instrukcja obsługi Kent Somerset MKII

Kent Podgrzewacz Somerset MKII

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Kent Somerset MKII (12 stron) w kategorii Podgrzewacz. Ta instrukcja była pomocna dla 9 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/12
OWNERS MANUAL
Tested and approved to Australian Standards AS/NZS 2918:2018
and AS/NZS 4013/4012:2014.
Prior to installation check with your state and local authorities
regarding any specific regulations that may apply.
Please keep these instructions for future reference.
Burn hardwood only.
Pricotech proudly supports the
activities of Landcare Australia
through its membership of the
AHHA.
WOOD HEATERS
for
Kent Somerset MkII
and
Kent Country Classic MkII
FIRST THINGS FIRST...
Congratulations on your purchase of a quality wood heater. This product is designed according to strict
environmental, quality and safety standards and should give you years of trouble free home heating.
Read these instructions carefully to get the most out of your heater and to ensure safe and satisfactory heater
performance. In particular, we would like to draw your attention to these warnings.
ExclusionofLiability
Whilst every care has been taken in formulating these instructions, no responsibility whatsoever will attach to
and/or claim lie against, the manufacturer and/or the distributor of the heater as a result of any failure to follow
the whole or any part of the instructions and/or as a result of incorrect information herein and/or any omission
here from.
2
Becarefulofwhatyouburn:
*Use only dry, well seasoned hardwood.
*Do not use coal or briquettes.
*WARNING: DO NOT USE FLAMMABLE
LIQUIDS OR AEROSOLS TO START OR
REKINDLE THE FIRE.
*Do not burn garbage in the firebox as garbage
can cause a dangerous soot build up and
increase the amount of smoke your heater
produces.
*Do not burn chemically treated timber as the
poisonous gases given off could damage your
stove.
*CAUTION: THE USE OF SOME TYPES OF
PRESERVATIVE-TREATED WOOD AS FUEL
CAN BE HAZARDOUS.
*Do not place any types of builders board eg
fibro, cement sheeting (or any other materials
not specified and tested by the manufacturer)
inside the firebox.
Protect yourself and your family from
burns:
*WARNING: OPEN AIR CONTROL
BEFORE OPENING FIRING DOOR.
*The exterior surfaces of the heater will become
hot during operation. For protection of
children, the elderly or infirm, provide a
firescreen to prevent contact with the
appliance in operation.
*To protect against injury from burns, use
caution when operating the appliance. In
particular, when loading the firebox, provide
adequate protection for your hands.
Use your heater according to these
instructions:
*CAUTION: THIS APPLIANCE SHOULD BE
MAINTAINED AND OPERATED AT ALL TIMES
I N A C C O R D A N C E W I T H T H E S E
INSTRUCTIONS.
*DO NOT BURN WITH DOOR OPEN.
*CAUTION: THIS APPLIANCE SHOULD NOT
BE OPERATED WITH A CRACKED GLASS.
*Do not throw logs into the firebox. Always
place logs carefully.
*Do not overfire (allow firebox to glow red) as
this could damage your firebox.
*WARNING: ANY MODIFICATION OF
THE APPLIANCE THAT HAS NOT BEEN
APPROVED IN WRITING BY THE
TESTING AUTHORITY IS CONSIDERED
AS BREACHING AS/NZS 4013.
*The appliance or flue system should not be
modified in any way without the written
approval of the manufacturer.
The heater can get very hot, so watch
obviousfirehazards:
*Do not place clothing or other combustible
materials on top of the heater.
*WARNING: DO NOT USE FLAMMABLE
LIQUIDS OR AEROSOLS OR PLACE
THESE IN THE VICINITY OF THIS
APPLIANCE WHEN IT IS OPERATING.
*WARNING: DO NOT STORE FUEL
WI TH IN HE ATE R INS TA LL ATI ON
CLEARANCES.
*Do not store flammable liquids near the
heater.
ASSEMBLING YOUR NEW HEATER
Your heater comes almost completely assembled. There is only a simple matter of placing the bricks and brick
retainer, positioning the baffle plate and the heater is ready to be installed. The firebricks and baffle plate
MUST be installed prior to operating the appliance.
BRICK RETAINER
To hold the firebricks in place, you should now
position the brick retainer bracket over the
firebricks as shown below.
3
Somerset MkII
Country Classic MkII
A
A
A
A
C
C
A
A
A
B
B
BAFFLE PLATE
Both models have baffles with an angled lip.
Ensure the baffle is placed into the firebox with the
angled lip facing up, as shown in the diagrams
below.
When placing the baffle plate in the heater, you
may need to angle the baffle plate up on one side
to get it through the door.
You should then lift the baffle over one bracket,
push it up to the top of the firebox, and then lift it
over the other bracket.
Push the baffle plate all the way to the back of the
heater to ensure it is in the correct position.
Somerset MkII
Country Classic MkII
A
A
AA
BB
B
B
B
B
B
D
E
FIREBRICK PLACEMENT
There are two firebox sizes in the Kent range and
each has its own arrangement of firebricks. Refer
to the diagrams below for your heater. The bricks
are placed with their longest edge upright.
There will be gaps in between the firebricks. Allow
the ash to settle in between - there is no need to
remove the bricks when cleaning the firebox.
Brick Sizes
A - 200 x 119 B - 200 x 173 C - 215 x119
D - 173 x 74 E - 119 x 74

Specyfikacje produktu

Marka: Kent
Kategoria: Podgrzewacz
Model: Somerset MKII

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Kent Somerset MKII, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Podgrzewacz Kent

Kent

Kent Fairlight Instrukcja

19 Września 2024
Kent

Kent Somerset MKII Instrukcja

16 Września 2024
Kent

Kent Small Instrukcja

16 Września 2024
Kent

Kent Jindabyne Instrukcja

16 Września 2024
Kent

Kent Calisto Instrukcja

15 Września 2024
Kent

Kent Country Classic MKII Instrukcja

15 Września 2024

Instrukcje Podgrzewacz

Najnowsze instrukcje dla Podgrzewacz

Harvia

Harvia Delta D29EE HDEE290400 Instrukcja

15 Października 2024
Jotul

Jotul F 361 Instrukcja

15 Października 2024
Adler

Adler AD 7752 Instrukcja

15 Października 2024
MSW

MSW -TTEH-3000 Instrukcja

15 Października 2024
MSW

MSW IR-DRYER2000.2 Instrukcja

15 Października 2024
MSW

MSW IR-DRYER3000.1 Instrukcja

15 Października 2024
MSW

MSW IR-DRYER2000.1 Instrukcja

15 Października 2024
MSW

MSW IR-DRYER3000.2 Instrukcja

15 Października 2024
MSW

MSW -CHEH-3300 Instrukcja

15 Października 2024
MSW

MSW -CTEH-15000 Instrukcja

15 Października 2024