Instrukcja obsługi Juniper SSG-140-SH

Juniper Niesklasyfikowane SSG-140-SH

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Juniper SSG-140-SH (82 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/82
Juniper Networks, Inc.
1194 North Mathilda Avenue
Sunnyvale, CA 94089
USA
408-745-2000
www.juniper.net
Part Number: 530-015643-01 Revision 05
Security Products
SSG 140 Hardware Installation and Configuration Guide
2
Copyright Notice
Copyright © 2008 Juniper Networks, Inc. All rights reserved.
Juniper Networks, the Juniper Networks logo, NetScreen, and ScreenOS are registered trademarks of Juniper Networks, Inc. in the United States and
other countries. All other trademarks, service marks, registered trademarks, or registered service marks in this document are the property of Juniper
Networks or their respective owners. All specifications are subject to change without notice. Juniper Networks assumes no responsibility for any
inaccuracies in this document or for any obligation to update information in this document. Juniper Networks reserves the right to change, modify,
transfer, or otherwise revise this publication without notice.
FCC Statement
The following information is for FCC compliance of Class A devices: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. The equipment generates, uses, and can radiate radio-frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference, in which case users will be required to correct the interference at their own expense.
The following information is for FCC compliance of Class B devices: The equipment described in this manual generates and may radiate radio-frequency
energy. If it is not installed in accordance with Juniper Networks’ installation instructions, it may cause interference with radio and television reception.
This equipment has been tested and found to comply with the limits for a Class B digital device in accordance with the specifications in part 15 of the FCC
rules. These specifications are designed to provide reasonable protection against such interference in a residential installation. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for help.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Caution: Changes or modifications to this product could void the user's warranty and authority to operate this device.
Disclaimer
THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT SHIPPED
WITH THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED
WARRANTY, CONTACT YOUR JUNIPER NETWORKS REPRESENTATIVE FOR A COPY.
Table of Contents 3
Table of Contents
About This Guide 5
Organization .................................................................................................... 6
Conventions.....................................................................................................6
Web User Interface Conventions ..............................................................6
Command Line Interface Conventions ...................................................... 7
Requesting Technical Support ..........................................................................7
Self-Help Online Tools and Resources........................................................ 7
Opening a Case with JTAC .........................................................................8
Feedback ......................................................................................................... 8
Chapter 1 Hardware Overview 9
Front Panel ...................................................................................................... 9
Port Descriptions ..................................................................................... 10
Device Status LEDs .................................................................................. 11
Ethernet Port LEDs ..................................................................................12
Reset Pinhole...........................................................................................12
USB Port..................................................................................................12
Back Panel ..................................................................................................... 13
Physical Interface Module Slots ...............................................................13
Power Switch........................................................................................... 14
AC Power Appliance Inlet ........................................................................ 14
Fuse Cover............................................................................................... 14
Chapter 2 Installing and Connecting the Device 15
Before You Begin ........................................................................................... 16
Installing Equipment ...................................................................................... 16
Organizing Interface Cables ........................................................................... 18
Connecting Power..........................................................................................18
Powering the Device On and Off.................................................................... 18
Connecting the Device to a Network .............................................................. 18
Chapter 3 Configuring the Device 21
Accessing the Device......................................................................................22
Using a Console Connection .................................................................... 22
Using the WebUI ..................................................................................... 24
Using Telnet ............................................................................................ 24
Default Device Settings .................................................................................. 25
Basic Device Configuration ............................................................................ 26
Admin Name and Password ....................................................................26
Administrative Access ............................................................................. 27
Interface IP Address ................................................................................ 27
Management Services..............................................................................27

Specyfikacje produktu

Marka: Juniper
Kategoria: Niesklasyfikowane
Model: SSG-140-SH

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Juniper SSG-140-SH, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Niesklasyfikowane Juniper

Juniper

Juniper SA6500 Instrukcja

1 Października 2024
Juniper

Juniper SA6500FIPS Instrukcja

1 Października 2024
Juniper

Juniper SA4500 Instrukcja

1 Października 2024
Juniper

Juniper SRX210-RMK Instrukcja

1 Października 2024
Juniper

Juniper SRX100 Instrukcja

1 Października 2024
Juniper

Juniper SA2500 Instrukcja

1 Października 2024
Juniper

Juniper Uplink Module Instrukcja

1 Października 2024
Juniper

Juniper SSG-140-SH Instrukcja

1 Października 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024
Husqvarna

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024
Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024