Instrukcja obsługi JANDY AquaLink Touch

JANDY Niesklasyfikowane AquaLink Touch

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla JANDY AquaLink Touch (69 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/69
H0334000 Rev B
Operation Data
Owner's Man u al
AquaLink® TouchTM
ATTENTION
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an electrical source on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Modi cations made to this equipment, which are not authorized by the manufacturer, may void the users authority
to operate this equipment.
WARNING
FOR YOUR SAFETY - This product must be installed and serviced by a contractor who is licensed and qualified in
pool equipment by the jurisdiction in which the product will be installed where such state or local requirements
exist. In the event no such state or local requirement exists, the maintainer must be a professional with sufficient
experience in pool equipment installation and maintenance so that all of the instructions in this manual can be
followed exactly. Before installing this product, read and follow all warning notices and instructions that accompany
this product. Failure to follow warning notices and instructions may result in property damage, personal injury, or
death. Improper installation and/or operation will void the warranty.
Improper installation and/or operation can create unwanted electrical hazard which can cause serious injury,
property damage, or death.
Wired/Wireless Controller
(For use with AquaLink RS for Systems with Rev Q Firmware or later)
FOR INDOOR USE ONLY
Page 3
AquaLink
®
Touch™ Owner's Manual
NOTE Some of the features described in this Manual DO NOT apply to all AquaLink RS models.
Table of Contents
Section 1. Important Safety Instructions ..... 6
Section 2. Overview of the AquaLink Touch
Controller ...................................... 8
2.1 System Overview ..............................................8
2.2 Basic Functions .................................................9
2.2.1 Turning ON the AquaLink Touch .................9
2.2.2 Turning OFF the AquaLink Touch ................9
2.3 Battery Status for Wireless Controller ...............9
2.4 Signal Strength for Wireless Controller .............9
2.5 Maintenance Information ................................10
Section 3. Using the Home Screen Menu .. 10
3.1 Home Screen ..................................................10
3.1.1 Title Bar .....................................................10
3.1.2 Middle Info Panel ......................................10
3.1.3 Navigation Bar ........................................... 11
3.2 Dialog Boxes ................................................... 11
Section 4. Using the Menu Screen ..............11
4.1 Menu Screen ................................................... 11
4.1.1 To Display the Menu Screen ..................... 11
4.2 Schedule ......................................................... 11
4.2.1 Adding Devices to the Circuit List .............12
4.2.2 ON/OFF Times ..........................................12
4.3 Set Temperature (For Pool and Spa Only
System) ...........................................................13
4.3.1 Pool Heat ..................................................13
4.3.2 Spa Heat ...................................................13
4.3.3 Chiller ........................................................13
4.4 To Set Up Date/Time .......................................14
4.4.1 Date ...........................................................14
4.4.2 Time ..........................................................14
4.5 Customize Home ............................................14
4.5.1 Customize General, Aux and OneTouch
Items .........................................................14
4.6 Lockouts Password .........................................15
4.6.1 To Lockout Devices ...................................15
4.6.2 To Set Lockout Password ..........................15
4.6.3 How to Use the System when a Password
is Enabled .................................................15
4.7 AquaPure® ......................................................16
4.7.1 To Set Up Pool/Spa ...................................16
4.7.2 To Set Up Quick Boost ..............................16
4.7.3 To Pause, Restart and Stop Quick Boost ..17
4.7.4 Boost Setup ...............................................17
4.8 Touch Setup ....................................................17
4.8.1 Brightness .................................................18
4.8.2 Sound ........................................................18
4.8.3 Calibrate AquaLink Touch..........................18
4.8.4 Address .....................................................19
4.8.5 RF Channel (For wireless units only) ........19
4.8.6 AquaLink Touch J-Box LED Operation ......20
4.9 Program Group ...............................................20
4.9.1 A and B Groups .........................................21
4.9.2 Program Auto Switch .................................21
4.9.3 Custom Label Group .................................21
4.9.4 Custom Label ............................................21
Section 5. Using the OneTouch Menu ........ 22
5.1 OneTouch ........................................................22
5.2 Spa Mode ........................................................22
5.3 All Off ..............................................................23
Section 6. Using the Help Menu .................. 23
6.1 Help Menu .......................................................23
6.2 Help Sensors ..................................................23
6.3 Help Remotes .................................................24
6.4 Help Errors ......................................................24
Section 7. Using the Status Menu .............. 24
7.1 Status Menu ...................................................24
Section 8. Using the Photos Menu ............. 25
8.1 Creating a Slideshow ......................................25
8.2 Inserting a Memory Card ................................25
8.3 Importing and Deleting Digital Photos .............25
8.4 Slideshow Setup .............................................25
8.4.1 To Enable Slideshow .................................26
8.4.2 Image Time ...............................................26
8.4.3 Sleep Mode and Sleep Time .....................26
8.4.4 No Activity .................................................26
Section 9. Using Other Devices ON/OFF ... 27
9.1 Using Other Devices On/Off ...........................27
9.2 Filter Pump .....................................................27
9.3 Spa .................................................................28
9.4 Pool Heat ........................................................28
9.5 Spa Heat (Dual Equipment) ............................28
9.6 Solar Heat ......................................................28
9.7 Auxiliary Equipment ........................................29
9.8 Using Color Lights ...........................................29
9.9 TEMP1 / TEMP2 (Pool or Spa Only) .............30
9.9.1 To Set Up TEMP1......................................30
9.9.2 To Set Up TEMP2 (For Pool and Spa
Only System) .............................................30
9.10 Two Speed Operation (*Not Available for
Export Models*) ..............................................31
9.10.1 Two Speed Manual Operation ...................31
9.10.2 High Speed Filtration Pump ......................31
9.10.3 Low Speed Filtration Pump .......................31


Specyfikacje produktu

Marka: JANDY
Kategoria: Niesklasyfikowane
Model: AquaLink Touch

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z JANDY AquaLink Touch, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Niesklasyfikowane JANDY

JANDY

JANDY Erosion Feeder Instrukcja

4 Października 2024
JANDY

JANDY PSB110 Instrukcja

3 Października 2024
JANDY

JANDY JS100-SM Instrukcja

3 Października 2024
JANDY

JANDY SFTM24-2.0 Instrukcja

3 Października 2024
JANDY

JANDY JS60-SM Instrukcja

3 Października 2024
JANDY

JANDY SFSM-60 Instrukcja

3 Października 2024
JANDY

JANDY AquaSwitch Instrukcja

22 Września 2024
JANDY

JANDY AquaPalm Instrukcja

22 Września 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024