Instrukcja obsługi Insignia NS-IMP26WH2
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Insignia NS-IMP26WH2 (2 stron) w kategorii kostkarka. Ta instrukcja była pomocna dla 17 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/2
PACKAGE CONTENTS
• Portable ice maker
• Ice basket (pre-installed)
• Ice shovel
• Quick Setup Guide
FEATURES
• Stores up to 1.5 lbs. (.68 kg) of ice
• Quick production cycle creates ice every 6 to 13 minutes
• Auto-detect prevents ice from overowing when the basket is full
• Two ice cube sizes help create the perfect drink
• Removable ice basket gives you convenient access
• Water recycling system with reservoir lets you place your ice maker anywhere
IMPORTANT SAFETY INFORMATION
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not operate your ice maker with a damaged cord.
• Your ice maker requires a standard 110-120volt, 60Hz electrical outlet with a three-prong ground.
• Connect to a properly polarized outlet only. No other appliance should be plugged into the same outlet.
Make sure that the plug is fully inserted into the outlet.
• Do not run the power cord over carpeting or other heat insulators. Do not cover the cord. Keep the cord
away from trac areas, and do not submerge in water.
• We do not recommend the use of an extension cord because it may overheat and become a risk of re.
If you must use an extension cord, use No.14 AWG minimum size and rated no less than 1875 watts.
• Unplug your ice maker before cleaning or making any repairs or servicing.
• Exercise caution and use reasonable supervision when your ice maker is used near children.
• Do not use your ice maker outdoors.
• Place your ice-maker away from direct sunlight and make sure that there is at least 4 inches (10 cm) of
space between the back and sides of your ice maker and surrounding walls.
• Do not use any other liquid besides water to make ice cubes.
• Do not clean your ice maker with ammable uids. The fumes can create a re hazard or explosion.
• Do not tip over.
• If your ice maker is brought in from outside storage in winter, wait a few hours for it to warm up to room
temperature before plugging it in.
• To avoid a hazard due to instability of your ice maker, it must be placed on an even or at surface.
WARNING: This appliance must be grounded.
Before using your new product, please read these instructions to prevent any damage.
OVERVIEW
Control panel
UNPACKING YOUR ICE MAKER
Remove the exterior and interior packaging. Make sure that you unpack the
ice basket and ice shovel. If any parts are missing, contact Best Buy customer
service.
Note: Make sure that your ice maker is positioned so that the plug is accessible.
QUICK SETUP GUIDE
Portable
Ice Maker
NS-IMP26SL0 / NS-IMP26RD2 /
NS-IMP26MT2 / NSIMP26WH2
Ice maker
POWER indicator
Lights when your ice
maker is turned on.
ON/OFF button
Press to turn your ice
maker on or o.
ICE FULL indicator
Lights when the ice
basket is full.
ADD WATER indicator
Lights when you need
to add water.
SELECT button
Press to select the
ice cube size:
SMALL or LARGE
Ice cube size
Lights to indicate the
selected ice cube size.
Ice shovel
Use to remove ice from the basket.
Ventilation opening
Provides cooling. Do not block.
Water drain plug
Unplug to drain water.
Ice basket
Holds ice.
Cover
Lift to remove ice.
Ice scoop
Moves ice into the ice basket.
Ice full sensor
Senses when the ice maker is full.
V6 ENGLISH 23-0039
CLEANING AND MAINTENANCE
To clean your ice maker, follow the instructions in steps 3-5 in SETTING UP YOUR ICE
MAKER.
• Clean the ice maker at least once a week or every three days if your water quality
is poor.
CAUTION: Do not use bleach or vinegar to clean the internal components.
TIPS FOR SAVING ENERGY
• Locate your ice maker in the coolest area of the room, away from heat
producing appliances or heating ducts.
• Make sure that your ice maker is suciently ventilated, with adequate air
circulation behind it.
TROUBLESHOOTING
The ADD WATER indicator is on.
• Turn o your ice maker, open the cover, then remove the ice basket. Add water
up to the MAX line. Replace the basket, then close the cover. Turn on your ice
maker.
The ICE FULL indicator is on.
• Remove ice from the ice basket.
Ice cubes stick together.
• The ice cycle is too long for the room temperature. Stop your ice maker, and
restart it when the ice blocks melt. Select the small size ice cube selection.
• The water temperature may be too cold. Change the water in the inner tank.
The best water temperature is between 45°F ~ 90°F (7°C ~ 32°C).
The ice making cycle is normal, but no ice is made.
• The room temperature or water temperature may be too high. The room
temperature should be 50°F ~ 105°F (10°C ~ 40°C). The water temperature
should be 45°F ~ 90°F (7°C ~ 32°C).
• The refrigerant liquid may have leaked. Contact a qualied service technician
for repair.
• The pipe in the cooling system may be blocked. Contact a qualied service
technician for repair.
The ice maker will not stop.
• Direct sunlight or sunlight reection can cause the sensor to malfunction.
Move your ice maker.
My ice maker is noisy.
• Your ice maker makes noise during the freezing cycle and when it is dumping
ice. This is normal.
SPECIFICATIONS
Dimensions (H×W×D): 12.6 × 8.7 × 12.3 in. (32 × 22.1 × 31.2 cm)
Net weight: 15.7 lbs. (7.1 kg)
Protection type: 1
Power: 115V/60Hz
Wattage: 120W (25°C), 140W (40°C)
Ice making current: 1.7A
Ice harvest current: 2.0A
Refrigerant: R600 a/21 g
Design pressure:
High side: 290 psig
Low side: 88 psig
Enclosure: Silver, red, mint, or white
Ice cube weight:
Small: .25 oz. (7 g)
Large: .32 oz. (9 g)
Reservoir capacity: 2.11 qt. (2.0 l)
ONE-YEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
For customer service, call 1-877-467-4289 (U.S. and Canada)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2023 Best Buy. All rights reserved.
SETTING UP YOUR ICE MAKER
1 Place your ice maker on a level surface in a location where your ice maker is
protected from direct sunlight and other sources of heat (such as a stove,
furnace, or radiator).
2 Make sure that there is at least 4 inches (10 cm) of space between the back
and sides of your ice maker and the surrounding walls.
3 Clean the interior with diluted detergent, warm water, and a soft cloth, then
rinse with clear water.
4 Take out the ice basket and clean it.
5 Unplug the water drain cap to remove all water. Replace the water drain plug
before lling with water.
6 Before using your ice maker for the rst time, run two to three cycles of ice
and dispose of them to help remove any plastic odor or residue from the
manufacturing and shipping process.
USING YOUR ICE MAKER FOR THE FIRST TIME
WARNINGS:
• Your ice maker must be grounded. Do not defeat the safety purpose of the
grounding-type plug. A grounding-type plug has two blades and a third grounding
prong. The third prong is provided for your safety. If the provided plug does not t into
your outlet, consult an electrician for replacement of the obsolete outlet.
• Before plugging in your ice maker, wait one hour for the refrigerant uid to settle.
1 Make sure that the water drain plug is in place and secure.
2 Open the cover, remove the ice basket, then pour drinking water into the
reservoir. Make sure that the water level is below the MAX line.
WARNING: Fill with drinking water only
3 Replace the ice basket, then close the cover.
4 Plug the power cord into a power outlet.
5 Press the ON/OFF button. The power indicator lights.
6 Press the SELECT button to select the ice cube size. If the room temperature is
lower than 60°F (16°C), we recommend that you select the small cube size to
keep ice from sticking together.
Notes:
• When the ice basket is full, your ice maker automatically stops making ice and the ICE
FULL indicator lights.
• After ice is made and goes into the ice basket, the ice begins to melt. To save the ice,
remove it from the basket and freeze it. Otherwise, the ice melts, the water goes back
into the reservoir, and your ice maker recycles the water to make ice again.
• The ice making cycle lasts 6 to 13 minutes, depending on the selected ice cube size and
the ambient temperature. If the room is extremely hot, the cycle may take longer.
• While your ice maker is on, check the water level periodically. If the water level is too low,
your ice maker stops automatically and the ADD WATER indicator light will illuminate.
Turn o your ice maker, then ll the reservoir to the level mark. Wait at least three minutes
for the refrigerant liquid inside the compressor to settle, then turn on your ice maker.
• Change the water in the water reservoir every 24 hours to ensure that the water is fresh
and the ice tastes good.
• If your ice maker is not in use, drain all water left in the tank.
MAX line
Specyfikacje produktu
| Marka: | Insignia |
| Kategoria: | kostkarka |
| Model: | NS-IMP26WH2 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Insignia NS-IMP26WH2, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje kostkarka Insignia
30 Maja 2024
Instrukcje kostkarka
- kostkarka Hoshizaki
- kostkarka Hendi
- kostkarka Emerio
- kostkarka CDA
- kostkarka Klarstein
- kostkarka Arendo
- kostkarka Witt
- kostkarka KitchenAid
- kostkarka NewAir
- kostkarka Kenmore
- kostkarka Frigidaire
- kostkarka Rotel
Najnowsze instrukcje dla kostkarka
12 Września 2024
4 Września 2024
4 Września 2024
4 Września 2024
29 Czerwca 2024
30 Maja 2024
30 Maja 2024
30 Maja 2024
30 Maja 2024
30 Maja 2024