Instrukcja obsługi Indesit WITXL 125 (EE)

Indesit pralka WITXL 125 (EE)

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Indesit WITXL 125 (EE) (60 stron) w kategorii pralka. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/60
1
GB
WASHING MACHINE
WITXL 125
Instructions for use
Contents
Installation, 2-3
Unpacking and levelling
Electric and water connections
The first wash cycle
Technical details
Washing machine description, 4-5
Control panel
How to open and shut the drum
Leds
Starting and Programmes, 6
Briefly: how to start a programme
Programme table
Personalisations, 7
Setting the temperature
Setting the spin cycle
Functions
Detergents and laundry, 8
Detergent dispenser
Bleach cycle
Preparing your laundry
Special items
Precautions and advice, 9
General safety
Disposal
Saving energy and respecting the environment
Care and maintenance, 10
Cutting off the water or electricity supply
Cleaning your appliance
Caring for your appliance door and drum
Cleaning the pump
Checking the water inlet hose
Cleaning the detergent dispenser
Troubleshooting, 11
Service, 12
Before calling for Assistance
English, 1
GB
БЪЛГАРСКИ, 13
BG GR
ΕΛΛΗΝΙΚΑ, 25
ITUK
Italiano, 49
Українська, 37
2
GB
! Keep this instruction manual in a safe place for future refe-
rence. Should the appliance be sold, transferred or moved,
make sure the instruction manual accompanies the washing
machine to inform the new owner as to its operation and
features.
! Read these instructions carefully: they contain vital infor-
mation on installation, use and safety.
Unpacking and levelling
Unpacking
1. Unpack the washing
machine.
2. Check whether the
washing machine has been
damaged during transport.
If this is the case, do not
install it and contact your
retailer.
3. Remove the four protec-
tive screws and the rubber
washer with the respective
spacer, situated on the
rear of the appliance (see
figure).
4. Seal the gaps using the
plastic plugs provided.
5. Keep all the parts: you will need them again if the washing
machine needs to be moved to another location.
Warning: should the screws be re-used, make sure you fasten
the shorter ones at the top.
! Packaging materials are not children’s toys.
Levelling
1. Install the washing machine
on a flat sturdy floor, without
resting it up against walls,
furniture cabinets or other.
2. If the floor is not perfectly
level, compensate for any
unevenness by tightening or lo-
osening the adjustable front feet
(see figure); the angle of inclina-
tion, measured according to the
worktop, must not exceed 2°.
Levelling your appliance correctly will provide it with stability
and avoid any vibrations, noise and shifting during operation.
If it is placed on a fitted or loose carpet, adjust the feet in
such a way as to allow enough room for ventilation beneath
the washing machine.
Putting your appliance in place and moving it.
If your washing machine
is equipped with a special
set of retractable wheels
you can easy move it.
To lower the wheels and
thus move the appliance
effortlessly, just pull the
lever, situated on the left-
hand side beneath the
base. Once the appliance
is in the required position,
put the lever back in place. The washing machine is now
firmly in place . (see figure)
Electric and water connections
Connecting the water inlet hose
1. Connect the supply
pipe by screwing it to a
cold water tab using a ¾
gas threaded connection
(see figure).
Before performing the
connection, allow the
water to run freely until it is
perfectly clear.
2. Connect the other end of
the water inlet hose to the
washing machine,
screwing it onto the applian-
ce’s cold water inlet, situated
on the top right-hand side
on the rear of the appliance
(see figure).
3. Make sure there are
no kinks or bends in the
hose.
! The water pressure at the tap must be within the values
indicated in the Technical details table
(on the next page).
! If the water inlet hose is not long enough, contact a
specialist store or an authorised serviceman.
! Never use hoses that have already been used.
Installation
3
GB
Connecting the drain hose
Connect the drain hose,
without bending it, to a
draining duct or a wall
drain situated between 65
and 100 cm from the floor;
alternatively, place it over
the edge of a basin, sink
or tub, fastening the duct
supplied to the tap (see
figure). The free end of
the hose should not be
underwater.
! We advise against the use of hose extensions; in case
of absolute need, the extension must have the same
diameter as the original hose and must not exceed 150
cm in length.
Electric connection
Before plugging the appliance into the mains socket,
make sure that:
• the socket is earthed and in compliance with the
applicable law;
• the socket is able to sustain the appliance’s
maximum power load indicated in the Technical
details table ;(on the right)
• the supply voltage is included within the values i
ndicated on the Technical details table
(on the right);
• the socket is compatible with the washing
machine’s plug. If this is not the case, replace
the socket or the plug.
! The washing machine should not be installed in an ou-
tdoor environment, not even when the area is sheltered,
because it may be very dangerous to leave it exposed to
rain and thunderstorms.
! When the washing machine is installed, the mains so-
cket must be within easy reach.
! Do not use extensions or multiple sockets.
! The power supply cable must never be bent or dange-
rously compressed.
! The power supply cable must only be replaced by an
authorised serviceman.
Warning! The company denies all liability if and when
these norms are not respected.
The first wash cycle
Once the appliance has been installed, and before you
use it for the first time, run a wash cycle with detergent
and no laundry, setting the 90°C programme without a
pre-wash cycle.
65 - 100 cm
Technical details
Model WITXL 125
Dimensions
40 cm wide
85 cm high
60 cm deep
Capacity from 1 to 6 kg
Electric
connections
Please refer to the technical data plate
fixed to the machine.
Water
connections
maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 42 litres
Spin speed up to 1200 rpm
Control
programmes
according to
1061/2010
directive
programme 2; temperature 60°C and
40°C.
This appliance is compliant with
the following European Community
Directives:
- 2004/108/CE (Electromagnetic
Compatibility)
- 2006/95/CE (Low Voltage)
- 2002/96/CE

Specyfikacje produktu

Marka: Indesit
Kategoria: pralka
Model: WITXL 125 (EE)

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Indesit WITXL 125 (EE), zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje pralka Indesit

Indesit

Indesit W 144 XS Instrukcja

15 Stycznia 2025
Indesit

Indesit WN860WSK Instrukcja

15 Stycznia 2025
Indesit

Indesit lna 1000 Instrukcja

15 Stycznia 2025
Indesit

Indesit wia 600 Instrukcja

15 Stycznia 2025
Indesit

Indesit wite 127 Instrukcja

14 Stycznia 2025
Indesit

Indesit IM 712B MY TIME UA Instrukcja

14 Stycznia 2025
Indesit

Indesit IM 602B MY TIME UA Instrukcja

14 Stycznia 2025
Indesit

Indesit XWD 61452 Instrukcja

13 Stycznia 2025
Indesit

Indesit IM 762 MY TIME EE Instrukcja

9 Stycznia 2025
Indesit

Indesit MTWSA 61294 WK EE Instrukcja

30 Grudnia 2025

Instrukcje pralka

Najnowsze instrukcje dla pralka

Samsung

Samsung p 1453 gw Instrukcja

15 Stycznia 2025
Bauknecht

Bauknecht WA Black 714 BW BK Instrukcja

15 Stycznia 2025
Beko

Beko WTV8814MMC1 Instrukcja

15 Stycznia 2025
Daewoo

Daewoo DWD-FD1441 Instrukcja

15 Stycznia 2025
Beko

Beko WMY71464STR1 Instrukcja

15 Stycznia 2025
Whirlpool

Whirlpool AWE 6720 Instrukcja

15 Stycznia 2025
Whirlpool

Whirlpool WGD7000D Instrukcja

15 Stycznia 2025
AEG-Electrolux

AEG-Electrolux l 88819 Instrukcja

15 Stycznia 2025
AEG-Electrolux

AEG-Electrolux L88489FL Instrukcja

15 Stycznia 2025
Beko

Beko wmd 26145 Instrukcja

15 Stycznia 2025