Instrukcja obsługi Indesit OS 1A 100 2 UK.1

Indesit ZAMRAŻARKI OS 1A 100 2 UK.1

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Indesit OS 1A 100 2 UK.1 (12 stron) w kategorii ZAMRAŻARKI. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/12

INSTRUCTIONS FOR USE

A. Lid handle

B. Lock (if provided)

C. Seal

D. Defrost water drain plug (if present)

E. Control panel

F. Basket (if present)

G. Condenser (located at the rear)

INSTALLATION

• Please refer to the chapter “BEFORE USING THE

APPLIANCE”.

• Unpack the appliance.

• Remove the 4 protection pieces inserted between lid

and appliance.

• Ensure that the defrosting water drainage plug (if provided)

is correctly positioned (4).

• For best operation of the appliance and in order to avoid

damage when the lid is opened, leave a space of at least 7

cm from the rear wall and 7 cm at the sides.

• Fit the accessories (if provided).

• Clean the inside of the appliance before using it.

1. Thermostat: it can be used to adjust the internal

temperature of the appliance.

2. Red LED (if provided): Indicates that the appliance

temperature is not suciently low.

3. Green LED (if provided): indicates that the appliance is on.

4. Yellow/orange illuminated button (if provided):

activates/deactivates the fast freeze function.

IMPORTANT: when using the product as a cooler please

check that the fast freeze function is not activated in order

to avoid bottle cracking.

The exact conguration of the controls may vary according

to the model.

Switching on the appliance

• The appliance is factory set for optimum freezer operation

at a temperature of -18°C.

• Plug in the appliance.

• The green LED lights up (if provided).

• Also the red LED (if provided) will switch on because the

temperature inside the appliance is not yet suciently low

for food storage. The red LED will normally switch o within

the rst six hours after the appliance is switched on.

• After connecting the appliance to the mains supply and

when the optimal temperature has been reached, ensure

that the fast freeze button is not pressed (the yellow LED, if

provided, is o ).

• Place food inside the product only when the red LED (if

provided) has switched o .

Note: As the seal is tight, the appliance lid cannot be

reopened immediately after closing. Wait a few minutes before

re-opening the lid of the appliance.

Temperature Adjustment

Use the thermostat to select the ideal storage temperature.

This product could be used both as freezer and as cooler.

• To use the product as freezer set thermostat in position

“freezer”. In this case the product must be used to store

frozen food, to freeze fresh food and to make ice.

Internal temperature could be set between -14°C and

-22°C (depending on the environmental conditions, this

CO Small

range may vary slightly)

• To use the product as cooler set thermostat in position

“cooler”. In this case the product must be used to store fresh

food and beverages.

Internal temperature could be set between 0°C and

+6°C (depending on the environmental conditions, this

range may vary slightly)

• To turn o the product set thermostat in OFF position.

In this case the product is already connected to power

supply.

IMPORTANT: when using the product as a cooler please

check that the fast freeze function is not activated in order

to avoid bottle cracking.

WHEN THE APPLIANCE IS NOT IN USE

Disconnect the appliance from the mains power supply, then

empty, defrost (if necessary) and clean it. Leave the door

open, so that air can circulate inside the compartments. This

will prevent the formation of mould and bad odours and an

oxidation (blackening) of internal walls.

COOLER USE

Before switching from freezer use to cooler use please:

1. check that frozen food is not present inside the cavity to

avoid unwanted food defrosting.

2. defrost and clean the product to avoid water stagnation on

the bottom.

Note: In the case of high levels of humidity, it is possible that

inside the appliance condensation may form on both the walls

and the bottom of the compartment. This is absolutely natural

and does not jeopardise the operation of the appliance in any

way.

In this case, we recommend closing any liquid lled containers

(e.g.: sauce pans full of stock), wrapping foods with a high

liquid content (e.g.: vegetables).

IMPORTANT: when using the product as a cooler please

check that the fast freeze function is not activated in order

to avoid bottle cracking.

FREEZER USE

Before putting frozen food inside the cavity please check

that the product is set as freezer (see “Temperature

adjustment” paragraph) and red light doesn’t light up.

BEFORE SWITCHING FROM COOLER USE TO FREEZER

USE PLEASE CHECK THAT FOOD OR BOTTLES ARE NOT

PRESENT INSIDE THE CAVITY TO AVOID UNWANTED

FOOD FROSTING OR BOTTLE CRACKING.

Refer to the table on the appliance (if provided).

Classication of frozen foods

Put the frozen products into the appliance and classify them;

the storage date should be indicated on the packs, to allow use

within expiry dates.

Advice for storing frozen food

When purchasing frozen food products:

• Ensure that the packaging is not damaged (frozen food in

damaged packaging may have deteriorated).

If the package is swollen or has damp patches, it may not

have been stored under optimal conditions and defrosting

may have already begun.

• When shopping, leave frozen food purchases until last and

transport the products in a thermally insulated cool bag.

• Once at home, place the frozen foods immediately in the

appliance.

• Avoid, or reduce temperature variations to the minimum.

Respect the best-before date on the package.

• Always observe the storage information on the package.

Note:

Eat fully or partially defrosted foods immediately.

Do not refreeze unless the food is cooked after it has

thawed. Once cooked, the thawed food can be refrozen.

If there is a long power failure:

• Do not open the appliance lid except to place ice packs

(if provided) over the frozen foods on the right and

left of the appliance. This will slow down the rise in

temperature.

FROZEN FOOD STORAGE

FREEZING FOOD

Before freezing food inside the cavity please check that the

product is set as freezer (see “Temperature adjustment”

paragraph) and red light doesn’t light up.

Preparation of fresh food for freezing

• Before freezing, wrap and seal fresh food in: aluminium foil,

cling lm, air and water-tight plastic bags, polyethylene

containers with lids, provided they are suitable for freezing

foods.

• Food must be fresh, mature and of prime quality in order to

obtain high quality frozen food.

• Fresh vegetables and fruit should preferably be frozen

as soon as they are picked to maintain the full original

nutritional value, consistency, colour and avour.

• Always leave hot food to cool before placing in the

appliance.

Freezing fresh food

• Place foods to be frozen in direct contact with the walls of

appliance:

A. foods to be frozen,

B. foods already frozen.

• Avoid placing foods to be frozen in direct contact with food

already frozen.

• For best and fastest freezing, foods should be split into

small portions; this will also be useful when the frozen items

are to be used.

1. At least 24 hours before

storing fresh food in the

appliance, press the fast

freeze button.

2. Place the food to be

frozen and keep the lid of

the appliance closed for

24 hours. The fast freeze

function automatically

deactivates after about 50

hours.

DEFROSTING THE APPLIANCE

The appliance should be defrosted

when the thickness of ice on the walls

reaches 5-6 mm.

• Disconnect the appliance from the

mains power supply.

• Remove the packs of food from

the appliance and wrap them close

together in newspaper and store

in a very cool place or thermally

insulated bag.

• Leave the appliance lid open.

• Remove the internal defrost water drain plug (depending

on model).

• Remove the external defrost water drain plug (depending

on model) and reposition it as shown in the gure.

• Place a bowl beneath the drainage channel to collect the

residual water. If available, use the divider.

• Speed up defrosting by using a spatula to detach the ice

from the appliance walls.

• Remove the ice from the bottom of the appliance.

• In order to avoid permanent damage to the appliance

interior, do not use pointed or sharp metal instruments for

removing the ice.

• Do not use abrasive products or heat up the interior

articially.

• Dry the interior of the appliance thoroughly.

• On completion of the defrosting, ret the plug.

CHANGING THE LID LIGHT BULB if provided)

• Disconnect the appliance from the

mains power supply.

• Remove the diuser by following

the sequence of steps shown in the

gure.

• Unscrew the light bulb and replace

it with an identical bulb of the same

wattage and voltage.

• Ret the diuser and plug in the appliance.

AFTERSALES SERVICE

Before contacting After-Sales Service:

1. See if you can solve the problem yourself.

2. Switch the appliance on again to see if the problem has

been solved. If it has not, disconnect the appliance from the

power supply and wait for about an hour before switching

on again.

3. If the problem persists after this course of action, contact

After- Sales Service.

TROUBLESHOOTING GUIDE

1. The red LED (if provided) remains alight.

• Is there a power failure?

• Is defrosting in progress?

• Is the appliance lid properly closed?

• Is the appliance positioned near a heat source?

• Is the thermostat setting correct?

• Are the ventilation grille and condenser clean?

2. The appliance is too noisy.

• Is the appliance perfectly horizontal?

• Is the appliance in contact with other furniture or objects

that may cause vibrations?

• Has the packaging been removed from under the

appliance?

Note: gurgling noises from the refrigerating circuit after the

compressor cuts out are perfectly normal.

3. The green LED (if provided) is o and the appliance is

not working.

• Is there a power failure?

• Is the plug properly inserted in the socket?

• Is the electric cable intact?

4. The green LED (if provided) is o and the appliance is

working.

• The green LED is not working. Contact the After Sales

Service for a replacement.

5. The compressor runs continuously.

• Have hot foods been put in the appliance?

• Has the appliance lid been left open for a long time?

• Is the appliance positioned in a very warm room or near

heat sources?

• Is the thermostat setting correct?

Specyfikacje produktu

Marka:	Indesit
Kategoria:	ZAMRAŻARKI
Model:	OS 1A 100 2 UK.1

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Indesit OS 1A 100 2 UK.1, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje ZAMRAŻARKI Indesit

Indesit OS 1A 100 2 UK.1 Instrukcja

11 Października 2024

Indesit UI8 F1C W UK Instrukcja

7 Października 2024

Indesit UIAA 12 (UK).1 Instrukcja

9 Sierpnia 2024

Indesit DCF 1A 300 UK.1 Instrukcja

6 Lipca 2024

Indesit I55ZM 112 W Instrukcja

4 Lipca 2024

Indesit UIA 12 F S 1 EX Instrukcja

3 Lipca 2024

Instrukcje ZAMRAŻARKI

Najnowsze instrukcje dla ZAMRAŻARKI

New World NWCF142L Instrukcja

15 Października 2024

Orima ORA 18560 CNFX Instrukcja

15 Października 2024

AEG ATB68E7NU Instrukcja

15 Października 2024

Smeg CLE200LF Instrukcja

15 Października 2024

Upo F1186 Instrukcja

15 Października 2024

Westinghouse WFM0900WC Instrukcja

14 Października 2024

Frigor CIF 45 Instrukcja

14 Października 2024

Electrolux EC3201AOW Instrukcja

14 Października 2024

AEG ABE6821VNF Instrukcja

14 Października 2024

Juno JCG08820S9 Instrukcja

14 Października 2024