Instrukcja obsługi Indesit IWTE 61451 ECO EU

Indesit pralka IWTE 61451 ECO EU

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Indesit IWTE 61451 ECO EU (72 stron) w kategorii pralka. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/72

Contents

Installation, 2-3

Unpacking and levelling

Electric and water connections

The first wash cycle

Technical data

Description of the washing machine, 4-5

Control panel

Display

How to open and shut the drum

Running a wash cycle, 6

Wash cycles and options, 7

Table of wash cycles

Wash options

Detergents and laundry, 8

Detergent dispenser drawer

Preparing the laundry

Special wash cycles

Load balancing system

Precautions and tips, 9

General safety

Disposal

Care and maintenance, 10

Cutting off the water or electricity supply

Cleaning the washing machine

Caring for the door and drum of your appliance

Cleaning the pump

Checking the water inlet hose

How to clean the detergent dispenser

Troubleshooting, 11

Service, 12

IWTE 61451

Instructions for use

WASHING MACHINE

English, 1

Nederlands, 13

Norsk, 61

Dansk, 49

Svenska, 25

Suomi, 37

Installation

! Keep this instruction manual in a safe place for future refe-

rence. Should the appliance be sold, transferred or moved,

make sure the instruction manual accompanies the washing

machine to inform the new owner as to its operation and

features.

! Read these instructions carefully: they contain vital infor-

mation on installation, use and safety.

Unpacking and levelling

Unpacking

1. Unpack the washing

machine.

2. Check whether the

washing machine has been

damaged during transport.

If this is the case, do not

install it and contact your

retailer.

3. Remove the four protec-

tive screws and the rubber

washer with the respective

spacer, situated on the rear

of the appliance (see figure).

4. Seal the gaps using the plastic plugs provided.

5. Keep all the parts: you will need them again if the washing

machine needs to be moved to another location.

Warning: should the screws be re-used, make sure you

fasten the shorter ones at the top.

! Packaging materials are not children’s toys.

Levelling

1. Install the washing machine on a flat sturdy floor, without

resting it up against walls, furniture cabinets or other.

2. If the floor is not perfectly

level, compensate for any

unevenness by tightening or

loosening the adjustable front

feet ; the angle of (see figure)

inclination, measured accor-

ding to the worktop, must not

exceed 2°.

Levelling your appliance correctly will provide it with sta-

bility and avoid any vibrations, noise and shifting during

operation.

If it is placed on a fitted or loose carpet, adjust the feet in

such a way as to allow enough room for ventilation bene-

ath the washing machine.

Putting your appliance in place and moving it.

If your washing machine is

equipped with a special set

of retractable wheels you

can easy move it. To lower

the wheels and thus move

the appliance effortlessly,

just pull the lever, situated

on the left-hand side

beneath the base. Once the

appliance is in the required

position, put the lever back

in place. The washing machine is now firmly in place (see

figure).

Electric and water connections

Connecting the water inlet hose

1. Connect the supply pipe

by screwing it to a cold

water tab using a ¾ gas

threaded connection (see

figure).

Before performing the con-

nection, allow the water to

run freely until it is perfectly

clear.

2. Connect the other end of

the water inlet hose to the

washing machine,

screwing it onto the ap-

pliance’s cold water inlet,

situated on the top right-

hand side on the rear of the

appliance

(see figure).

3. Make sure there are no

kinks or bends in the hose.

! The water pressure at the tap must be within the va-

lues indicated in the Technical details table (on the next

page).

! If the water inlet hose is not long enough, contact a spe-

cialist store or an authorised serviceman.

! Never use hoses that have already been used.

Connecting the drain hose

Connect the drain hose,

without bending it, to a drai-

nage duct or a wall drain

located at a height between

65 and 100 cm from the

floor;

alternatively, rest it on

the side of a washbasin

or bathtub, fastening the

duct supplied to the tap

( ). The free end see figure

of the hose should not be

underwater.

! We advise against the use of hose extensions; if it is

absolutely necessary, the extension must have the same

diameter as the original hose and must not exceed 150 cm

in length.

Electrical connections

Before plugging the appliance into the electricity socket,

make sure that:

• the socket is earthed and complies with all applicable

laws;

• the socket is able to withstand the maximum power load

of the appliance as indicated in the Technical data table

(see opposite);

• the power supply voltage falls within the values indicated

in the Technical data table (see opposite);

• the socket is compatible with the plug of the washing

machine. If this is not the case, replace the socket or the

plug.

! The washing machine must not be installed outdoors,

even in covered areas. It is extremely dangerous to leave

the appliance exposed to rain, storms and other weather

conditions.

! When the washing machine has been installed, the elec-

tricity socket must be within easy reach.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

! The power supply cable must only be replaced by autho-

rised technicians.

Warning! The company shall not be held responsible in the

event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before you use

it for the first time, run a wash cycle with detergent and no

laundry, setting the 90°C programme without a pre-wash

cycle.

65 - 100 cm

Technical data

Model IWTE 61451

Dimensions

width 59,5 cm

height 85 cm

depth 60 cm

Capacity from 1 to 6 kg

Electrical

connections

please refer to the technical data plate

fixed to the machine

Water connection

maximum pressure 1 MPa (10 bar)

minimum pressure 0.05 MPa (0.5 bar)

drum capacity 42 litres

Spin speed up to 1400 rotations per minute

Test wash cycles

in accordance

with directives

1061/2010 and

1015/2010

Programme : Cotton standard 60°C;

Programme : Cotton standard 40°C.

This appliance conforms to the following

EC Directives:

- 2004/108/CE (Electromagnetic Compa-

tibility)

- 2002/96/EC

- 2006/95/EC Low Voltage)

Specyfikacje produktu

Marka:	Indesit
Kategoria:	pralka
Model:	IWTE 61451 ECO EU
Kolor produktu:	Biały
Wbudowany wyświetlacz:	Tak
Typ wyświetlacza:	LCD
Położenie urządzenia:	Wolnostojący
Wysokość produktu:	850 mm
Szerokość produktu:	400 mm
Głębokość produktu:	600 mm
Waga produktu:	63000 g
Szerokość opakowania:	460 mm
Wysokość opakowania:	960 mm
Głębokość opakowania:	660 mm
Ilość programów piorących:	16
Opóźniony start czasomierza:	Tak
Opóźniony start:	24 h
Pobór wody na cykl:	- l
Wskaźnik pozostałego czasu:	Tak
Klasa efektywności energetycznej (stara):	A+
Pranie zużywające energię:	1.029 kWh
Typ ładowania:	Od góry
Zawias drzwiczek:	W górę
Kategoria prania:	A
Pojemność znamionowa:	6 kg
Maksymalna prędkość obrotu:	1400 RPM
Klasa wirowania (suszenia):	B
Poziom hałasu (pranie):	61 dB
Poziom hałasu (wirowanie):	78 dB
Programy prania:	Hygiene/anti-allergy, Black, Hand/wool, Jeans/denim, Quick, Sport, Delicate/silk
Pojemność bębna:	42 l
Zabezpieczenie przed przepełnieniem:	Tak
Roczne zużycie energii pranie:	196 kWh
Roczne zużycie wody pranie:	9045 l
System równoważenia balansu:	Tak
funkcja Rinse Plus:	Tak