Instrukcja obsługi Indesit IWC 81051 C ECO(EU)

Indesit pralka IWC 81051 C ECO(EU)

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Indesit IWC 81051 C ECO(EU) (60 stron) w kategorii pralka. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/60

Contents

Installation, 2-3

Unpacking and levelling

Connecting the electricity and water supplies

The first wash cycle

Technical data

Description of the washing machine

and starting a wash cycle, 4-5

Control panel

Indicator lights

Starting a wash cycle

Wash cycles, 6

Table of wash cycles

Personalisation, 7

Setting the temperature

Setting the spin speed

Functions

Detergents and laundry, 8

Detergent dispenser drawer

Bleach cycle

Preparing the laundry

Garments requiring special care

Load balancing system

Precautions and tips, 9

General safety

Disposal

Care and maintenance, 10

Cutting off the water or electricity supply

Cleaning the washing machine

Cleaning the detergent dispenser drawer

Caring for the door and drum of your appliance

Cleaning the pump

Checking the water inlet hose

Troubleshooting, 11

Service, 12

IWC 81051

Instructions for use

WASHING MACHINE

English,1

Français,13

FIT

Italiano, 25

Espańol,37

Portuguęs,49

Levelling the machine correctly will provide it with stability,

help to avoid vibrations and excessive noise and prevent it

from shifting while it is operating. If it is placed on carpet or

a rug, adjust the feet in such a way as to allow a sufficient

ventilation space underneath the washing machine.

Connecting the electricity and water

supplies

Connecting the water inlet hose

1. Connect the supply pipe

by screwing it to a cold

water tap using a ¾ gas

threaded connection (see

figure).

Before performing the con-

nection, allow the water to

run freely until it is perfectly

clear.

2. Connect the inlet hose

to the washing machine by

screwing it onto the corre-

sponding water inlet of the

appliance, which is situa-

ted on the top right-hand

side of the rear part of the

appliance . (see figure)

3. Make sure that the hose is not folded over or bent.

! The water pressure at the tap must fall within the values

indicated in the Technical details table (see next page).

! If the inlet hose is not long enough, contact a specialised

shop or an authorised technician.

! Never use second-hand hoses.

! Use the ones supplied with the machine.

! This instruction manual should be kept in a safe place for

future reference. If the washing machine is sold, transferred

or moved, make sure that the instruction manual remains

with the machine so that the new owner is able to familiari-

se himself/herself with its operation and features.

! Read these instructions carefully: they contain vital infor-

mation relating to the safe installation and operation of the

appliance.

Unpacking and levelling

Unpacking

1. Remove the washing machine from its packaging.

2. Make sure that the washing machine has not been

damaged during the transportation process. If it has been

damaged, contact the retailer and do not proceed any

further with the installation process.

3. Remove the 4 protective

screws (used during tran-

sportation) and the rubber

washer with the correspon-

ding spacer, located on the

rear part of the appliance

( ).see figure

4. Close off the holes using the plastic plugs provided.

5. Keep all the parts in a safe place: you will need them

again if the washing machine needs to be moved to ano-

ther location.

! Packaging materials should not be used as toys for

children.

Levelling

1. Install the washing machine on a flat sturdy floor, without

resting it up against walls, furniture cabinets or anything

else.

2. If the floor is not perfectly

level, compensate for any

unevenness by tightening

or loosening the adjusta-

ble front feet ( ); see figure

the angle of inclination,

measured in relation to the

worktop, must not exceed

2°.

Installation

65 - 100 cm

Connecting the drain hose

Connect the drain hose,

without bending it, to a drai-

nage duct or a wall drain

located at a height between

65 and 100 cm from the

floor;

alternatively, rest it on

the side of a washbasin

or bathtub, fastening the

duct supplied to the tap

( ). The free end see figure

of the hose should not be

underwater.

! We advise against the use of hose extensions; if it is

absolutely necessary, the extension must have the same

diameter as the original hose and must not exceed 150 cm

in length.

Electrical connections

Before plugging the appliance into the electricity socket,

make sure that:

• the socket is earthed and complies with all applicable

laws;

• the socket is able to withstand the maximum power load

of the appliance as indicated in the Technical data table

(see opposite);

• the power supply voltage falls within the values indicated

in the Technical data table (see opposite);

• the socket is compatible with the plug of the washing

machine. If this is not the case, replace the socket or the

plug.

! The washing machine must not be installed outdoors,

even in covered areas. It is extremely dangerous to leave

the appliance exposed to rain, storms and other weather

conditions.

! When the washing machine has been installed, the elec-

tricity socket must be within easy reach.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

! The power supply cable must only be replaced by autho-

rised technicians.

Warning! The company shall not be held responsible in the

event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before you use

it for the first time, run a wash cycle with detergent and no

laundry, using the wash cycle .2

Technical data

Model IWC 81051

Dimensions

width 59.5 cm

height 85 cm

depth 60 cm

Capacity from 1 to 8 kg

Electrical

connections

please refer to the technical data plate

fixed to the machine

Water connection

maximum pressure 1 MPa (10 bar)

minimum pressure 0.05 MPa (0.5 bar)

drum capacity 62 litres

Spin speed up to 1000 rotations per minute

Test wash cycles

in accordance

with directives

1061/2010 and

1015/2010

Programme 2: Cotton standard 60°C;

Programme 3: Cotton standard 40°C.

This appliance conforms to the following

EC Directives:

- 2004/108/EC dated 03/05/89 (Electro-

magnetic Compatibility)

- 2002/96/EC

- 2006/95/EC Low Voltage)

Specyfikacje produktu

Marka:	Indesit
Kategoria:	pralka
Model:	IWC 81051 C ECO(EU)
Kolor produktu:	Biały
Typ kontroli:	Buttons, Rotary
Wbudowany wyświetlacz:	Nie
Długość przewodu:	1.7 m
Położenie urządzenia:	Wolnostojący
Częstotliwość wejściowa AC:	50 Hz
Napięcie wejściowe AC:	220 - 240 V
Wysokość produktu:	850 mm
Szerokość produktu:	595 mm
Głębokość produktu:	600 mm
Waga produktu:	73400 g
Szerokość opakowania:	640 mm
Wysokość opakowania:	890 mm
Głębokość opakowania:	650 mm
Kolor drzwiczek:	Biały
Ilość programów piorących:	16
Opóźniony start czasomierza:	Tak
Prąd:	10 A
Pobór wody na cykl:	- l
Tryb wyłączenia:	1 W
Wskaźnik pozostałego czasu:	Tak
Klasa efektywności energetycznej (stara):	A+
Pranie zużywające energię:	1.236 kWh
Typ ładowania:	Od przodu
Zawias drzwiczek:	Lewy
Kategoria prania:	A
Pojemność znamionowa:	8 kg
Maksymalna prędkość obrotu:	1000 RPM
Klasa wirowania (suszenia):	C
Minutnik:	Tak
Poziom hałasu (pranie):	61 dB
Pozostała wilgoć:	62 %
Poziom hałasu (wirowanie):	74 dB
Programy prania:	Hygiene/anti-allergy, Black, Eco, Jeans/denim, Quick, Sport, Delicate/silk
Pojemność bębna:	62 l
Czas cyklu (max):	187 min
Regulowana prędkość obrotów:	Tak
Zabezpieczenie przed przepełnieniem:	Tak
Roczne zużycie energii pranie:	223 kWh
Roczne zużycie wody pranie:	10532 l
Pobór mocy:	1850 W
Waga wraz z opakowaniem:	75000 g
System równoważenia balansu:	Tak
Tworzywo bębna:	Stal nierdzewna
Wypełniony wodą:	Zimny
Kąt otwierania drzwi:	150 °
Tworzywo rury:	Plastik