Instrukcja obsługi Indesit IDVL 75 BRS.9 UK

Indesit Suszarki do ubrań IDVL 75 BRS.9 UK

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Indesit IDVL 75 BRS.9 UK (16 stron) w kategorii Suszarki do ubrań. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/16
1
English
Contents
Installation, 2
Warnings, 4
Care and maintenance, 6
Description of the tumble dryer, 7
How to carry out a drying cycle, 9
Programmes and options, 10
Laundry, 13
Troubleshooting, 14
Assistance, 15
GB
Instruction manual
TUMBLE DRYER
This symbol reminds you to read this
instruction manual.
! Keep this manual at hand for immediate reference whenever
necessary. Always store this manual close to the tumble dryer and
remember to pass it on to any new owners when selling or tran-
sferring the appliance, so they may familiarise with the warnings
and suggestions herein contained.
! Read these instructions carefully: the following pages contain
important information on installation and useful suggestions for
operating the appliance.
www.indesit.com
2
GB
Installation
10
m
m
15 mm
15 mm
15 mm
15 mm
B
A
Where to install the tumble dryer
If the dryer is installed below a worktop,
ensure there are 10 mm
between the upper pa-
nel of the dryer and any
objects above it, and 15
mm between the sides
of the machine and the
walls or furniture units
adjacent to it. This ensu-
res adequate air circu-
lation. Make sure the air
inlets on the rear panel are not blocked or
obstructed.
Ventilation
This appliance gently dries laundry by taking in cold, clean
and relatively dry air, heating it and passing it through the
fabric. To facilitate the drying process, damp air is expelled
at the rear, through a ventilation hose. When the dryer is in
use, there has to be adequate ventilation to avoid a back
flow of gases into the room from appliances burning other
fuels, including open fires.
Mobile ventilation system
When using the tumble dryer with the mobile ventilation
system, a ventilation hose must be connected. The hose
should be securely fastened to the ventilation hole at
the rear of the appliance (see “Description of the tumble
dryer”). We recommend the hose is connected to an outlet
near the tumble dryer, if possible. If it cannot be installed
in a permanent spot, the tumble dryer will still function
perfectly well if the ventilation hose is passed through a
partially-opened window.
Make sure you do not point the ventilation hose towards
the air inlet, which is located on the rear of the appliance.
The ventilation hose should not exceed a maximum
length of 2.4 metres; it should also be shaken frequently
to remove any fluff, dust or water deposits inside it. Make
sure you do not crush the hose. The hose supplied has an
oval section to aid installation.
Fixed ventilation kit
We recommend the ventilation hose is connected to a
ventilation for windows or doors, available from the kit
retailer which originally sold you the appliance or from your
local spare parts stockist.
Wall ventilation hole
1. Leave an opening in the wall.
2. Make the hose as short and
straight as possible, in order
to prevent any moisture from
condensing and leaking back
into the appliance.
3. The hole in the wall must
also be straight and pointing
downwards, so that the flow of
air coming out is not impeded.
Areas A and B should be checked frequently, to prevent
the accumulation of fluff or debris, particularly if the tumble
dryer is used very often. The hose adaptor must be fitted
correctly, in order to prevent damp air from coming back
into the room.
Ventilation hole
The ventilation hole should be directly behind the dryer in
order to keep the hose as short as possible.
Make sure you do not push the tumble dryer too far
backwards, as this could lead to the ventilation hose being
crushed, bent or even disconnected.
There should be no cuts, kinks or “U”-shaped bends
in the hose, as these could impede ventilation or trap
condensation.
The end of the hose must be facing downwards, in order to
prevent the hot, damp air from forming condensation in the
room or the tumble dryer.
Make sure that the tumble dryer is adequately ventilated,
and that the end of the ventilation hose is not pointing
towards the air inlet pipe on the rear of the appliance.
The ventilation hose must always be fitted to ensure
optimum performance.
The hose will need to be
expanded to be fitted and
clamped.
Make sure that the ventilation
hose, air inlet vents, and outlets
are not obstructed or blocked.
Do not let the tumble dryer
recirculate exhaust air.
Improper use of the tumble
dryer may result in fire hazards.
Ventilation
The air emitted by the tumble dryer must not be expelled in
the same duct as used for the fumes produced by different
appliances which burn gas or other fuels.
Do not discharge the exhaust air into an extraction system
or any duct with an extractor fan. This will affect the way
the thermal controls operate and can result in a fire hazard.
Make sure that the room in which the
tumble dryer is installed is not damp, and
that it is adequately ventilated.
We do not recommend that the dryer is
installed in a cupboard but the dryer must
never be installed behind a lockable door,
a sliding door or a door with a hinge on the
opposite side to that of the dryer door.
The appliance must be installed with the
rear surface placed against a wall.
GB
3
Electrical connections
Before plugging the appliance into the so-
cket, check the following:
Make sure your hands are dry.
The socket must have an earth connec-
tion.
The socket must be able to withstand the
machine’s maximum power output as indi-
cated on the rating plate (see Description of
the tumble dryer).
The power supply voltage must fall within
the values indicated on the rating plate (see
Description of the tumble dryer).
Do not use extension leads. Do not pull
the power supply cable. Do not use multiple
plug adaptors if the appliance is fitted with a
plug. For appliances with fitted plug, if the
plug is not suitable for you socket outlet,
contact a qualified technician.
The dryer must not be installed outdoors,
even if the space is sheltered.
Once installed, the dryer’s electrical wire
and plug must be within reach.
The power cord must not be bent or
squashed.
If the plug being replaced is a non-
rewirable type, then the cut-off plug must be
disposed of safely. DO NOT leave it where it
can be inserted into a socket and create a
shock hazard.
The electric cord must be regularly
checked. If the supply cord is damaged, it
must be replaced by service agent. see (
Service).
The manufacturer denies any
responsibility should any of these rules not
be followed.
If in doubt about any of the above consult
a qualified electrician.
Levelling the tumble dryer
The tumble dryer should be installed level in order to
operate correctly.
After installing the tumble dryer in its permanent position
make sure it is level; check its side-to-side levelling first,
followed by front-to-back.
If the tumble dryer is not perfectly level, use a wooden
block to support it while you adjust the two front feet, up
down as necessary.
Before you start your dryer
Once the tumble dryer is installed, clean the inside of the
drum before operating it and remove any dirt accumulated
during transportation.


Specyfikacje produktu

Marka: Indesit
Kategoria: Suszarki do ubrań
Model: IDVL 75 BRS.9 UK

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Indesit IDVL 75 BRS.9 UK, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Suszarki do ubrań Indesit

Instrukcje Suszarki do ubrań

Najnowsze instrukcje dla Suszarki do ubrań

Maytag

Maytag MGD7100DC Maxima Instrukcja

15 Października 2024
Bosch

Bosch WTA4000 Instrukcja

15 Października 2024
Bauknecht

Bauknecht TRKP 7950 Instrukcja

15 Października 2024
Simpson

Simpson SDV656HQWA Instrukcja

15 Października 2024
Siemens

Siemens WT45W450NL Instrukcja

15 Października 2024
White Knight

White Knight C36AW Instrukcja

14 Października 2024
Nordland

Nordland ELD 9613 Instrukcja

14 Października 2024
Speed Queen

Speed Queen AG5419 Instrukcja

14 Października 2024