Instrukcja obsługi Indesit IDVL 75 B R (UK)

Indesit Suszarka bębnowa IDVL 75 B R (UK)

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Indesit IDVL 75 B R (UK) (16 stron) w kategorii Suszarka bębnowa. Ta instrukcja była pomocna dla 11 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/16

Instruction manual

TUMBLE DRYER

English

IDVL 75B R

Contents

Installation, 2

Where to install the tumble dryer

Ventilation

Electrical connections

Levelling the tumble dryer

Before you start your dryer

Warnings, 4

General safety

Saving energy and respecting the environment

Care and maintenance, 6

Disconnecting the power supply

Cleaning the filter after each cycle

Checking the drum after each cycle

Cleaning the tumble dryer

Description of the tumble dryer, 7

Features

Control panel

How to carry out a drying cycle, 9

Starting and selecting a programme

Programmes and options, 10

Programme chart

Special programmes

Options

Opening the door

Laundry, 13

Sorting laundry

Care labels

Drying times

Troubleshooting, 14

Assistance and Guarantee, 15

Spare parts

Information on recycling and disposal

! This symbol reminds you to read this

instruction manual.

! Keep this manual at hand for immediate reference whenever

necessary. Always store this manual close to the tumble dryer and

remember to pass it on to any new owners when selling or tran-

sferring the appliance, so they may familiarise with the warnings

and suggestions herein contained.

! Read these instructions carefully: the following pages contain

important information on installation and useful suggestions for

operating the appliance.

www.indesit.co.uk

Installation

15 mm

Where to install the tumble dryer

•

Install the dryer far

from gas ranges, stoves,

radiators or hobs, as

flames may damage it.

If the dryer is installed

below a worktop, ensure

there are 10 mm betwe-

en the upper panel of the

dryer and any objects

above it, and 15 mm

between the sides of the machine and the

walls or furniture units adjacent to it. This en-

sures adequate air circulation. Make sure the

air inlets on the rear panel are not blocked or

obstructed.

•

You should also make sure that the room

in which the tumble dryer is installed is not

damp, and that it is adequately ventilated.

•

! We do not recommend that the dryer is

installed in a cupboard but the dryer must

never be installed behind a lockable door,

a sliding door or a door with a hinge on the

opposite side to that of the dryer door.

•

The appliance must be installed with the !

rear surface placed against a wall.

Ventilation

This appliance gently dries laundry by taking in cold, clean

and relatively dry air, heating it and passing it through the

fabric. To facilitate the drying process, damp air is expelled at

the rear, through a ventilation hose. When the dryer is in use,

there has to be adequate ventilation to avoid a back flow

of gases into the room from appliances burning other fuels,

including open fires.

Mobile ventilation system

When using the tumble dryer with the mobile ventilation

system, a ventilation hose must be connected. The hose

should be securely fastened to the ventilation hole at the

rear of the appliance

(see “Description of the tumble dryer”).

We recommend the hose is connected to an outlet near

the tumble dryer, if possible. If it cannot be installed in a

permanent spot, the tumble dryer will still function perfectly

well if the ventilation hose is passed through a partially-

opened window.

Make sure you do not point the ventilation hose towards

the air inlet, which is located on the rear of the appliance.

The ventilation hose should not exceed a maximum length

of 2.4 metres; it should also be shaken frequently to remove

any fluff, dust or water deposits inside it. Make sure you do

not crush the hose.

Fixed ventilation system

We recommend the ventilation hose is connected to a

ventilation system for windows or doors, available from the

retailer which originally sold you the appliance or from your

local spare parts stockist.

Wall ventilation hole

1. Leave an opening in the wall

to the left of the tumble dryer

installation site.

2. Make the hose as short and

straight as possible, in order

to prevent any moisture from

condensing and leaking back

into the appliance.

3. The hole in the wall must

also be straight and pointing

downwards, so that the flow of air coming out is not

impeded.

Areas and should be checked frequently, to prevent A B

the accumulation of fluff or debris, particularly if the tumble

dryer is used very often. The hose adaptor must be fitted

correctly, in order to prevent damp air from coming back into

the room.

Window ventilation hole

The ventilation hole should

be directly behind the dryer in

order to keep the hose as short

as possible.

! Make sure you do not

push the tumble dryer too

far backwards, as this could

lead to the ventilation hose

being crushed, bent or even

disconnected.

! There should be no cuts, kinks or “ ”-shaped bends U

in the hose, as these could impede ventilation or trap

condensation.

Ventilation through an open window

The end of the hose must be

facing downwards, in order to

prevent the hot, damp air from

forming condensation in the

room or the tumble dryer.

! Make sure that the tumble dryer is adequately ventilated,

and that the end of the ventilation hose is not pointing

towards the air inlet pipe on the rear of the appliance.

! The ventilation hose must always be fitted to ensure

optimum performance.

! Make sure that the ventilation hose and the air inlet vents

are not obstructed or blocked.

! Do not let the tumble dryer recirculate exhaust air.

! Improper use of the tumble dryer may result in fire hazards.

! The air emitted by the tumble dryer must not be expelled in

the same duct as used for the fumes produced by different

appliances which burn gas or other fuels.

! Do not discharge the exhaust air into an extraction system

or any duct with an extractor fan. This will affect the way the

thermal controls operate and can result in a fire hazard.

Electrical connections

Before plugging the appliance into the so-

cket, check the following:

• Make sure your hands are dry.

• The socket must have an earth connec-

tion.

• The socket must be able to withstand the

machine’s maximum power output as indica-

ted on the rating plate (see Description of the

tumble dryer).

• The power supply voltage must fall within

the values indicated on the rating plate (see

Description of the tumble dryer).

• The socket must be compatible with the

dryer’s plug. Should this not be the case,

replace the plug or the socket.

! DO NOT USE EXTENSION CORDS.

! The dryer must not be installed outdoors,

even if the space is sheltered. It can be very

dangerous if exposed to rain or storms.

! Once installed, the dryer’s electrical wire

and plug must be within reach.

! The power cord must not be bent or

squashed.

! If the plug being replaced is a non-rewirable

type, then the cut-off plug must be disposed

of safely. DO NOT leave it where it can be

inserted into a socket and create a shock

hazard.

! The electric cord must be regularly

checked. If the supply cord is damaged, it

must be replaced by the manufacturer, its

service agent or similarly qualified persons in

order to avoid a hazard. (see Service). New or

longer power cords are supplied at an extra

charge by authorized dealers.

! The manufacturer denies any responsibility

should any of these rules not be followed.

! If in doubt about any of the above

consult a qualified electrician.

Levelling the tumble dryer

The tumble dryer should be installed level in order to

operate correctly.

After installing the tumble dryer in its permanent position,

make sure it is level; check its side-to-side levelling first,

followed by front-to-back.

If the tumble dryer is not perfectly level, use a wooden

block to support it while you adjust the two front feet, up

or down as necessary.

Before you start your dryer

Once the tumble dryer is installed, clean the inside of the

drum before operating it and remove any dirt accumulated

during transportation.

Specyfikacje produktu

Marka:	Indesit
Kategoria:	Suszarka bębnowa
Model:	IDVL 75 B R (UK)

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Indesit IDVL 75 B R (UK), zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Suszarka bębnowa Indesit

Indesit YT M11 92B X Instrukcja

7 Stycznia 2025

Indesit YT M11 82SS X Instrukcja

7 Stycznia 2025

Indesit C YD A81 WWGL UK Instrukcja

7 Stycznia 2025

Indesit YT M11 82B X UK Instrukcja

2 Stycznia 2025

Indesit BI WDIL 861485 UK Instrukcja

30 Grudnia 2025

Indesit IDV 75 B K (UK) Instrukcja

14 Października 2024

Indesit YT M11 82 X UK Instrukcja

14 Października 2024

Indesit Ecotime IWDC 65125 S UK Instrukcja

9 Października 2024

Indesit BI WDIL 75148 UK Instrukcja

8 Października 2024

Indesit BDE 86436 WV UK Instrukcja

8 Października 2024

Instrukcje Suszarka bębnowa

Najnowsze instrukcje dla Suszarka bębnowa

Bauknecht trkk 7846 Instrukcja

15 Stycznia 2025

AEG T8DEN86CS Instrukcja

15 Stycznia 2025

Candy GCS 91013A2 Instrukcja

15 Stycznia 2025

Zanussi ZDP7204PZ Instrukcja

15 Stycznia 2025

Bauknecht TRKA Koblenz 4590 Instrukcja

15 Stycznia 2025

Bauknecht trkk 6840 Instrukcja

15 Stycznia 2025

AEG-Electrolux Lavatherm 310 Instrukcja

14 Stycznia 2025

Hotpoint NWXR483GGWW Instrukcja

14 Stycznia 2025

Zanussi ZDC82B4SW Instrukcja

14 Stycznia 2025

Bauknecht trk advance Instrukcja

14 Stycznia 2025