Instrukcja obsługi IHome iB50

IHome Słuchawki iB50

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla IHome iB50 (3 stron) w kategorii Słuchawki. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/3

Limited Lifetime Warranty

iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product

to be free from defects in workmanship and materials, under normal use and conditions, for the lifetime of the product

from the date of original purchase.

Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally

purchased. Should this fail to resolve the matter and service still be required by reason of any defect or malfunction

during the warranty period, SDI Technologies will repair or, at its discretion, replace this product without charge (except

for a $10.00 charge for handling, packing, return UPS/postage, and insurance). This decision is subject to verification

of the defect or malfunction upon delivery of this product to the Factory Service Center listed below. The product must

include proof of purchase, including date of purchase. The fee for service without proof of purchase is $20.00.

Before returning this product for service, please first replace the batteries (if applicable) with fresh ones, as exhausted

or defective batteries are the most common cause of problems encountered.

If service is still required:

1. Remove the batteries (if applicable) and pack the unit in a well padded, heavy corrugated box.

2. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of purchase, if within

the warranty period.

3. Enclose a check or money order payable to the order of SDI Technologies, for the sum of $10.00 ($20.00 without

proof of purchase).

4. Send the unit prepaid and insured, to the Factory Service Center listed below.

Consumer Repair Department

SDI Technologies Inc.

1330 Goodyear Drive

El Paso, TX 79936-6420

Disclaimer of Warranty

NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover

(i) products which have been damaged by negligence or willful actions, misuse or accident, or which have been

modified or repaired by unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive heat;

(iii) damage to digital media players, CD’s or tape cassettes (if applicable); (iv) the cost of shipping this product to the

Factory Service Center and its return to the owner.

This warranty is valid only in the United States of America and does not extend to owners of the product other than

to the original purchaser. In no event will SDI Technologies or any of its affiliates, contractors, resellers, their officers,

directors, shareholders, members or agents be liable to you or any third party for any consequential or incidental

damages, any lost profits, actual, exemplary or punitive damages. (Some states do not allow limitations on implied

warranties or exclusion of consequential damages, so these restrictions may not apply to you.) This warranty gives

you specific legal rights, and you may also have other rights which vary from state to state.

Your acknowledgement and agreement to fully and completely abide by the above mentioned disclaimer of warranty

is contractually binding to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase

of your SDI Technologies product.

iB50-030612-A

Printed in China

Questions? Visit www.ihomeaudio.com or call 1-800-288-2792 Toll Free.

Model: iB50

The Home iB50 headphones include Active Noise Cancellation circuitry designed to reduce or eliminate

certain background noises, such as airplane engine noise, to give you a quieter, more enjoyable listening

experience. When the ANC circuit is switched ‘On’, a microphone inside each earpiece ‘listens’ for

extraneous noise that is not part of your music, and the ANC circuit then generates an opposite sound

wave designed to eliminate or greatly reduce the extraneous noise. The ANC circuit is powered by two

“AAA” batteries, included.

Using your iHome iB50 Headphones

Installing The Batteries

Although the headphones can be used

without batteries, the Active Noise Cancel-

lation circuit will not operate unless the

batteries are properly installed.

Note: The ANC On/Off switch was set to

the ‘Off’ position at our factory.

Over Ear Active Noise

Cancelling Headphones

with Volume Control

Left Headphone

Mute Button

Cable Jack On/Off Button

LED ANC ‘On’

Indicator

Connect The Detachable Cable

Connect the detachable headphone cable to the jack on the

bottom of the L earpiece. The cable should be connected with

the in-line volume control closest to the L earpiece as shown.

Make sure that the plug is fully inserted into the jack. If the plug is

not fully inserted the sound may be intermittent, or you may only

hear sound from one of the earpieces.

Note: The volume control on the cable was set at ‘Maximum’ at

our factory.

Connect the other end of the detachable cable to the headphone jack of your external music source such

as an iPod, iPhone, iPad, MP3 player, personal CD player, etc. Again, make sure that the plug on the

detachable cable is fully inserted into the headphone jack of your external music source.

Listening to Music

• Before putting on your headphones, we recommend that you rotate the volume control on the

headphone cable counter-clockwise until it is approximately half way between the Minimum and

Maximum levels.

• Begin playback of your external music source and adjust the volume level of your external device

to approximately 50% of maximum volume.

• Place the iB50 headphones on your head according to the L and R markings on the earpieces.

When worn properly the detachable cable will be on your left side. Slide the L and R earpieces

up or down to achieve the most comfortable fit.

• Adjust the volume controls on the headphone cable and your external device to a comfortable

listening level. Note: If one control is set too high and the other is set too low, the sound may be

distorted.

• To reduce or eliminate extraneous noise, such as the engine roar in an airplane cabin, slide the

ANC On/Off switch the ‘On’ position. The ANC LED indicator turns red when the ANC circuit is

‘On’.

• When you are finished listening slide the ANC switch to the ‘Off’ position to extend the life of the

batteries. The ANC LED indicator goes ‘Off’. Also remember to shut off the power of your external

music source.

Using The Mute Button (Only When ANC is 'On')

Depress the Mute button on the L earpiece to temporarily shut off the sound so that you can hear

someone speaking to you without removing the headphones. Release the Mute button to resume

normal operation.

Using the 2-Prong Airline Adapter

Some older aircraft have audio/visual systems that use dual

headphone jacks in the armrests of their seats. To use your iB50

headphones with this type of A/V system, insert the plug of the

headphone cable into the jack of the included 2-prong adapter as

shown and insert the 2-prong adapter into the dual jacks in the

armrest of your seat.

Travel Pouch

To keep your headphones clean, store them in the included travel pouch when not in use. The L and

R earpieces fold flat for convenient storage.

Replacing the Batteries

The two “AAA” batteries should provide over 60 hours of continuous operation with the ANC circuit

‘On’. If you notice that the ANC circuit is no longer providing any noticeable noise reduction, or that

the ANC LED indicator does not turn ‘On’, it’s time to replace the batteries.

We recommend that you use a well-known brand of alkaline batteries for longest life and best

performance.

Follow the ‘Installing The Batteries’ instructions above to replace the batteries.

The battery compartment is located inside the R earpiece. To open the battery compartment cover, press

with your thumb at the top of the cover as shown to release the locking tab and slide the cover downward

to remove it.

Insert the two “AAA” batteries into the battery compartment as

shown. Be sure to install the batteries in the correct polarity (+/-)

according to the markings in the battery compartment. If the

batteries are inserted incorrectly the ANC circuit will not operate.

After installing the batteries, replace the battery compartment

cover and make sure it is completely flat against the earpiece with

no gap at the bottom.

Batteries information

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbone-zinc) or

rechargeable (nickel-cadmium) batteries.

Specyfikacje produktu

Marka:	IHome
Kategoria:	Słuchawki
Model:	iB50
Kolor produktu:	Czarny
Typ produktu:	Słuchawki
Wysokość produktu:	193 mm
Szerokość produktu:	180 mm
Głębokość produktu:	75.2 mm
Styl noszenia:	Opaska na głowę
Technologia łączności:	Przewodowa
Budowa słuchawek:	Supra fonetyczny
System akustyczny:	Zamknięty
Odłączany przewód:	Tak
Pokrowiec:	Tak
Mikrofon z redukcją szumów:	Tak