Instrukcja obsługi Hotpoint SE1032X

Hotpoint piekarnik SE1032X

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Hotpoint SE1032X (16 stron) w kategorii piekarnik. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/16
SE1032X
Contents
Installation, 2
Positioning
Electrical connection, 3
Data plate
Description of the appliance, 4
Overall view
Control panel
Start-up and use, 5
Control panel lock
DEMO mode
Setting the clock
Setting the timer
Starting the oven
Cooking modes, 6-9
Manual cooking modes
Automatic cooking modes
Programming cooking
Practical cooking advice
Cooking advice table
Precautions and tips, 10
General safety
Disposal
Respecting and conserving the environment
Care and maintenance, 11-12
Switching the appliance off
Cleaning the appliance
Cleaning the oven door
Replacing the light bulb
Assembling the sliding rack kit
Guarantee, 13
After Sales Service, 14
Operating Instructions
OVEN
English,1
GB
GB
2
GB
Before operating your new appliance please read
this instruction booklet carefully. It contains
important information concerning the safe operation,
installation and maintenance of the appliance.
Please keep these operating instructions for future
reference. Make sure that the instructions are kept
with the appliance if it is sold, given away or moved.
Positioning
Keep all packaging materials out of the reach of
children. It may present a choking or suffocation
hazard (see Precautions and tips).
The appliance must be installed by a qualified
person in compliance with the instructions provided.
Incorrect installation may cause harm to people and
animals or may damage property.
Built-in appliance
Use the appropriate cabinet to ensure that the
appliance functions properly.
The panels adjacent to the oven must be made of
heat-resistant material.
Cabinets with a veneer exterior must be
assembled with glues which can withstand
temperatures of up to 100°C.
To install the oven under counter a (see diagram)
or in a kitchen unit , the cabinet must have the
following dimensions:
The appliance must not come into contact with
electrical parts once it has been installed.
The indications for consumption given on the data
plate have been calculated for this type of installation.
Ventilation
To ensure adequate ventilation is provided, the back
panel of the cabinet must be removed. It is
advisable to install the oven so that it rests on two
strips of wood, or on a completely flat surface with
an opening of at least 45 x 560 mm (see diagrams).
Centring and fi ing x
Position the 4 tabs on the side of the oven so that
they are lined up with the 4 holes on the outer frame.
Adjust the tabs according to the thickness of the
cabinet side panel, as shown below:
20 mm thick: take off the
removable part of the tab (see
diagram).
18 mm thick: use the first
groove, which has already
been set in the factory (see
diagram).
16 mm thick: use the second
groove (see diagram).
Secure the appliance to the cabinet by opening the
oven door and inserting 4 screws into the 4 holes on
the outer frame.
All parts which ensure the safe operation of the
appliance must not be removable without the aid of
a tool.
560 mm.
45 mm.
595 mm.
595 mm.
24 mm.
545 mm.
5 mm.
567 mm.
23 mm.
593 mm.
45 mm.
558 mm.
547
m m
. m
in.
I sn tallation
GB
3
TABLE OF CHARACTERISTICS
Dimensions width 34 .5 cm
height 32 cm
depth 40 cm
Volume 56 l
Electrical
connections
voltage: 220-240V ~ 50 60/ H z
maximum power absorbed
2800 W
ENERGY LABEL
Directive 2002/40/EC on the
label of electric ovens.
Regulation EN 50 043
Declared energy
consumption for Forced
convection Class
heating mode: Gratin
This conforms appliance to
the following European
Economic Community
directives: 2006/95/ EEC
dated 12 12 06 ow/ / L(
V oltage) and subsequent
amendments
2004 108/ /EEC dated
15 12 04/ / (Electromagnetic
Compatibility) and
subsequent amendments -
93/68/ EEC dated /22 07/93
and subsequent
amendments.
2002 and/96/EEC
subsequent amendments.
12 2008 stand-by7 /5 /off
mode.
Electrical Connection
Electrical connection
The electrical connection to the mains must be made
on the appliance. The power voltage and frequency
are as indicated on the rating plate.
! THIS APPLIANCE MUST BE EARTHED.
Connectin er cag h p t e ow supply ble
To open the terminal board:
Using a screwdriver, press on the tabs situated
on each side of the terminal board cover.
Pull open the terminal board cover.
To connect the power supply cable, proceed as
follows:
_Unscrew the cable clamp screw and the contact
screws L N- - .$
Fasten the wires beneath the screwheads using
the following colour scheme: Blue n (N) Brow ( )L
Y wello -Green$
Fasten the power supply cable in the
corresponding cable clamp and close the cover.
Electrical Connection :
V F 3oltage requency: 2 0
V N-1+ 50Hz
Fuse Section: 16A
Supply cable:
3x1.5mm2
You can connect your oven to the system means of
a terminal board. Refer to above information for the
minimal cable sections and the calibration of the
protective elements according to the connection.
If the appliance is installed w itha junction box, an
omnipolar circuit brea erk - with a minimum contact
opening of mm - should be installed between the3
appliance and the mains.
P hower cable suppl ty connection to e electrical
m sain :
We recommend you use a power supply cable which
is long enough to allow you to take the oven out of
its recess in the event of maintenance operations
(only use AR - 05 - RR quality cables fitted withH H F
a plug conforming to the regulations in force.
The plug must be accessible at all times.
U n l p ug t ehappliance be o efore all perations, ven
w .hen rep glacin t ehoven lamp
U s gin t ehappliance wit correct eart inh uo t h g s i
h d gighly an erous.
! After connectin lianceg h t e a pp x bto t eh fle i le
ca le ti ten all cre on ter inalb, gh t eh s w s t eh m
b .oard
4 2
N L

Specyfikacje produktu

Marka: Hotpoint
Kategoria: piekarnik
Model: SE1032X

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Hotpoint SE1032X, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje piekarnik Hotpoint

Hotpoint

Hotpoint OS 89 IX Instrukcja

14 Października 2024
Hotpoint

Hotpoint HD5G00KCB Instrukcja

9 Października 2024
Hotpoint

Hotpoint PC 640 X /HA Instrukcja

7 Października 2024
Hotpoint

Hotpoint SA2540HIX Instrukcja

5 Października 2024
Hotpoint

Hotpoint SI4854HIX Instrukcja

5 Października 2024
Hotpoint

Hotpoint SI5 851 C IX Instrukcja

4 Października 2024
Hotpoint

Hotpoint G750TX Instrukcja

4 Października 2024
Hotpoint

Hotpoint RBS360DMWW Instrukcja

4 Października 2024
Hotpoint

Hotpoint FID 834 H MR HA Instrukcja

2 Października 2024
Hotpoint

Hotpoint FA2 844 H IX HA Instrukcja

29 Września 2024

Instrukcje piekarnik

Najnowsze instrukcje dla piekarnik

Wolf

Wolf M Series Instrukcja

15 Października 2024
Princess

Princess 112741 Instrukcja

15 Października 2024
Boretti

Boretti VFPNR 1202 IX Instrukcja

15 Października 2024
Ilve

Ilve MDC-120 Instrukcja

15 Października 2024
Frigidaire

Frigidaire FCWD2727AW Instrukcja

15 Października 2024
Fisher & Paykel

Fisher & Paykel CG302DLPGB4 Instrukcja

15 Października 2024
AEG

AEG IKK74545FB Instrukcja

15 Października 2024
Ilve

Ilve HCPT75D Instrukcja

15 Października 2024
Zanker

Zanker KOU65902XK Instrukcja

15 Października 2024
Hoover

Hoover PHC3B25CXHH64DCT Instrukcja

15 Października 2024