Instrukcja obsługi Hotpoint FTVFG 65B GG (UK)

Hotpoint Suszarki do ubrań FTVFG 65B GG (UK)

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Hotpoint FTVFG 65B GG (UK) (20 stron) w kategorii Suszarki do ubrań. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/20
Instruction booklet
1
Contents
Installation, 2-3
Where to put your dryer
Ventilation
Electrical connection
Levelling
Before you start using your dryer
Warnings, 4-5
General safety
To minimise the risk of fire
Maintenance and Care, 6
Switching off the electricity
Cleaning the filter after each cycle
Check the drum after each cycle
Cleaning the dryer
Dryer description, 7
The front
The back
Control panel
The Display, 8
Start and programmes, 9-13
Choosing a programme
Programmes Table
The Controls
Laundry, 14
Sorting your laundry
Wash care labels
Drying times
Troubleshooting, 15
Service, 16
Spare Parts
Recycling and Disposal
Product data, 17
GB
English
GB
FTVFG 65B
TUMBLE DRYER
This symbol reminds you to read this
booklet.
!Keep this instruction booklet on hand in order to refer
to it when necessary. Take it with you when you
move, and should you sell this appliance or pass it
on to another party, make sure that this booklet is
supplied along with the dryer so that the new owner
may be informed about warnings and suggestions on
how the appliance works.
!Read these instructions carefully; the following
pages contain important information on installation
and suggestions on how the appliance works.
To activate your free* 5 Year Parts Guarantee
Call free on 0800 519 2102
*Labour charges not included. Terms and consitions apply. Lines open 364 days a year.
Calls are free from a BT landline. Charges from other providers and mobiles may apply.
www.hotpoint.co.uk
2
GB
Installation
!Ensure that the end of the tube is not directed
toward the air intake vent at the rear of the dryer.
!The vent tube should not exceed 2.4 metres in
length and should be kept free of any possible
accumulation of fluff, lint and water by shaking it out
frequently. Always ensure that the tube is not
squashed.
Permanent venting
In conjunction with the vent tube we recommend
using a Wall/Window Vent Kit, available at a retail
location or the nearest Spare Parts Dealer.
Wall mounting
1. Leave an opening in
the wall to the left of the
dryers proposed position.
2. Keep the tube as short
and straight as possible
to prevent condensed
moisture from backing up
into the dryer.
3. Similarly, the duct in
the wall should slope
downwards towards the
outside.
Window mounting
1. With a stacked dryer
the hole in the window
should ideally be made
below the vent.
2. The tube should be
kept as short as possible.
Depending on how often you use your dryer, it is
essential that areas A and B are checked periodically
to remove lint or debris.
The vent tube adaptor must be fitted securely thus
preventing any humid air from being emitted back into
the room.
!The Dryer should not be pushed so far back that the
tube adaptor is pulled out of position or the tube is
squashed or bent.
!The tube should be kept clear of the air intake vent
and kinks or ‘U’ bends must be avoided as these will
obstruct the tube or trap condensation.
Where to put your dryer
Place your dryer at a distance from gas
ranges, stoves, heaters, or cook tops
because flames can damage the
appliance.
If you are going to
install the appliance
under a work counter,
be sure to leave a
10mm space between
the top and any other
objects on or above
the machine and a
15mm space between the sides and
lateral furnishings or walls. This is to
ensure proper air circulation. Make sure
that the back vents are not obstructed.
Make sure you put your dryer in an
environment that is not damp and has
proper air circulation throughout, the
dryer will not operate efficiently in an
enclosed space or cupboard.
!We do not recommend that the dryer is
installed in a cupboard but the dryer must
never be installed behind a lockable door,
a sliding door or a door with a hinge on
the opposite side to that of the dryer door.
!The appliance must be installed with the
rear surface placed against a wall.
Ventilation
The Dryer dries your laundry by drawing in cool, clean
and relatively dry air, heating it, and then distributing it
through the clothes as they are gently tumbled. For
optimum performance, the moist air is then blown out
through a vent tube at the back of the dryer.
When the dryer is in use, there has to be adequate
ventilation to avoid the back flow of gases into the room
from appliances burning other fuels, including open fires.
Mobile venting
A vent tube must always be fitted when the dryer is
used in conjunction with Mobile Venting.
The tube must be fitted securely into the back of the
dryer (see Dryer Description). If possible, it is always
best to connect the tube to a permanent
outlet close to the dryer. If permanent installation is
not possible, the dryer will work just as well with the
tube passing through a partly-opened window.
Minimum gap 10mm
Minimum gaps
15mm
3
GB
Installation
!Do not use extension cords.
!The power cord must not be bent or
squashed.
!The power cord should be regularly
checked. If the supply cord is damaged, it
must be replaced by the manufacturer, its
service agent or similarly qualified persons
in order to avoid a hazard. New or longer
power cords are supplied at an extra
charge by authorised dealers..
!The manufacturer denies any responsibility
should any of these rules not be followed.
!If in doubt about any of the above consult
a qualified electrician.
Levelling your dryer
The dryer must be installed level for correct operation.
When you have installed
your dryer in its final
location check that it is
level first side to side,
then front to back.
If the dryer is not level, use a
wooden block to support it while
adjusting the two front legs up or
down, until your dryer is level.
Before you start using your dryer
Once you have installed your dryer and before you
use it, clean the inside of the drum to remove any
dust that could have accumulated during transport.
Maximum load
Natural fibres : 6 kg
Open window venting
The end of the tube
should be directed
downwards, to prevent
warm moist air from
condensing in the room or
in the dryer.
!Ensure that the dryer is adequately ventilated and
that the end of the vent tube is not directed towards
the air intake duct.
!The vent tube must always be fitted for optimum
performance.
!Make sure that the vent tube and air intake vents are
not obstructed or blocked.
!The dryer must not recycle exhaust air.
!Misusing a tumble dryer may create a fire hazard.
!Do not discharge exhaust air into a flue which is
used for exhaust fumes from other appliances that
burn gas or other fuels.
!Do not discharge exhaust air into an extraction
system or any duct with an extractor fan. This will
affect the way the thermal controls operate and can
result in a fire hazard.
Electrical connections
Make sure of the following before you
insert the plug into the the electrical
socket:
Make sure your hands are dry.
The socket must have an earth connection.
The socket must be able to sustain the
machines maximum power, which is
indicated on the rating label (see Dryer
Description).
Power voltage must be within the values
indicated on the rating label (see Dryer
Description).
The socket must be compatible with the
dryers plug. Should this not be the case,
replace the plug or the socket.
!The dryer must not be installed outdoors,
even if the space is sheltered. It can be
very dangerous if it is exposed to rain or
storms.
!Once installed, the dryers electrical wire
and plug must be within easy reach.


Specyfikacje produktu

Marka: Hotpoint
Kategoria: Suszarki do ubrań
Model: FTVFG 65B GG (UK)

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Hotpoint FTVFG 65B GG (UK), zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Suszarki do ubrań Hotpoint

Instrukcje Suszarki do ubrań

Najnowsze instrukcje dla Suszarki do ubrań

Maytag

Maytag MGD7100DC Maxima Instrukcja

15 Października 2024
Bosch

Bosch WTA4000 Instrukcja

15 Października 2024
Bauknecht

Bauknecht TRKP 7950 Instrukcja

15 Października 2024
Simpson

Simpson SDV656HQWA Instrukcja

15 Października 2024
Siemens

Siemens WT45W450NL Instrukcja

15 Października 2024
White Knight

White Knight C36AW Instrukcja

14 Października 2024
Nordland

Nordland ELD 9613 Instrukcja

14 Października 2024
Speed Queen

Speed Queen AG5419 Instrukcja

14 Października 2024