Instrukcja obsługi Hotpoint Ariston AQD970D 49 EU/B

Hotpoint Ariston Kombinacje pralko-suszarki AQD970D 49 EU/B

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Hotpoint Ariston AQD970D 49 EU/B (84 stron) w kategorii Kombinacje pralko-suszarki. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/84
EN
1
English,1
! This symbol reminds you to read this instruction manual.
Contents
Installation, 2-3
Unpacking and levelling
Connecting the electricity and water supplies
Technical data
Description of the machine, 4-5
Touch control panel
How to run a wash cycle or a drying
cycle, 6
Wash cycles and options, 7
Table of wash cycles
Wash options
Detergents and laundry, 8
Detergent
Preparing the laundry
Washing recommendations
Load balancing system
Precautions and advice, 9
General safety
Disposal
Opening the porthole door manually
Care and maintenance, 10
Cutting off the water and electricity supplies
Cleaning the machine
Cleaning the detergent dispenser drawer
Caring for your appliance drum
Cleaning the pump
Checking the water inlet hose
Trouble shooting, 11
Assistance, 12
EN
WASHER-DRYER
AQUALTIS
AQD970D 49
Instructions for
installation and use
Polski,13
PL
Česky,37
CZ
Slovensky,25
SK
Magyar,49 Română,61
RO
UA
Українська,73
HU
EN
2
Installation
! This instruction manual should be kept in a safe place for
future reference. If the Washer-dryer is sold, given away or
moved, please ensure the manual is kept with the machine,
so that the new owner may benefit from the advice
contained within it.
! Read these instructions carefully: they contain vital
information relating to the safe installation and operation of
the appliance.
! Inside the pack containing this manual, you will also find
the guarantee and all the details necessary for installation.
Unpacking and levelling
Unpacking
1. Once you have removed all the packaging from the
Washer-dryer, make sure it has not been damaged during
transportation.
If it has been damaged, contact the retailer and do not
proceed any further with the installation process.
2. Remove the 4 protective
screws (used during
transportation) and the
corresponding spacer,
located on the rear part of
the appliance ( ). see figure
3. Close off the holes using the plastic plugs supplied in the
pack.
4. Keep all the parts in a safe place; they will be needed
again if the Washer-dryer is moved to another location, to
prevent the inside of the appliance being damaged.
! Packaging materials should not be used as toys for
children.
Levelling
1. Place the Washer-dryer on a flat sturdy floor, without
resting it up against walls or cabinets.
2. If the floor is uneven, the
front feet of the machine
may be adjusted until
it reaches a horizontal
position (the angle of
inclination must not exceed
2 degrees).
! If the appliance is levelled correctly, it will be more stable
and much less likely to cause vibrations and noise while it
is operating, particularly during the spin cycle.
! If it is placed on carpet or a rug, adjust the feet in such a
way as to allow a sufficient ventilation space underneath
the Washer-dryer.
Connecting the electricity and water
supplies
Connecting the water inlet hose
! Before connecting the inlet hose to the water supply, run
the water until it is perfectly clear.
1. Connect the inlet hose
to the machine by screwing
it onto the cold water inlet
of the appliance, which is
situated on the top right-
hand side of the rear part of
the appliance . (see figure)
2. Connect the inlet hose
by screwing it to a cold
water tap using a 3/4 gas
threaded connection (see
figure).
3. Make sure that the hose is not folded over or bent.
! The water pressure at the tap must fall within the values
indicated in the Technical data table (see next page).
! If the inlet hose is not long enough, contact a specialised
shop or an authorised technician.
! Never use second-hand or old inlet hoses; use the
products supplied with the machine.
EN
3
Connecting the drain hose
Connect the drain hose to
drain duct piping or a wall
drain located between 65
and 100 cm above the floor,
making sure it is not bent
at all.
Alternatively, rest the
drain hose on the side of
a washbasin or bathtub,
fastening the duct supplied
to the tap (see figure).
The free end of the hose
should not be underwater.
! We advise against the use of hose extensions; if it is
absolutely necessary, the extension must have the same
diameter as the original hose and must not exceed 150 cm
in length.
Electrical connections
Before plugging the appliance into the electricity socket,
make sure that:
• the socket is earthed and complies with all applicable
laws;
• the socket is able to withstand the maximum power load
of the appliance as indicated in the Technical data table
(see opposite);
• the power supply voltage falls within the values indicated
in the Technical data table (see opposite);
• the socket is compatible with the plug of the appliance.
If this is not the case, have the socket or the plug
replaced.
! The machine must not be installed outdoors, even in
covered areas. It is extremely dangerous to leave the
appliance exposed to rain, storms and other weather
conditions.
! The mains socket must remain within easy reach after the
Washer-dryer has been installed.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable and plug must only be replaced
by authorised technicians.
Warning! The company shall not be held responsible in the
event that these regulations are not respected.
65 - 100 cm
Technical data
Model AQD970D 49
Dimensions
width 59.5 cm
height 85 cm
depth 64.5 cm
Capacity from 1 to 9 kg for the wash programme
from 1 to 7 kg for the drying programme
Electrical
connections
please refer to the technical data plate
fixed to the machine
Water connections
maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 71 litres
Spin speed up to 1400 rotations per minute
Energy rated
programmes
according to
regulation
EN 50229
Wash: programme ; temperature 60°C;
using a load of 9 kg.
Drying: the smaller load must be dried by
selecting the “EXTRA” dryness level. The
load must consist of 2 sheets, 1 pillowcase
and 1 hand towel;
the remainder of the load must be dried by
selecting the “EXTRA” dryness level.
This appliance conforms to the following
EC Directives:
- 2004/108/EC (Electromagnetic Compatibility)
- 2006/95/EC (Low Voltage)
- 2002/96/EC

Specyfikacje produktu

Marka: Hotpoint Ariston
Kategoria: Kombinacje pralko-suszarki
Model: AQD970D 49 EU/B

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Hotpoint Ariston AQD970D 49 EU/B, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Kombinacje pralko-suszarki Hotpoint Ariston

Hotpoint Ariston

Hotpoint Ariston RD 966 JGD UK Instrukcja

7 Sierpnia 2024
Hotpoint Ariston

Hotpoint Ariston AQD1071D 69 EU/A Instrukcja

7 Sierpnia 2024
Hotpoint Ariston

Hotpoint Ariston AQD970D 49 EU/B Instrukcja

6 Sierpnia 2024
Hotpoint Ariston

Hotpoint Ariston FDG 8640BS EU Instrukcja

1 Lipca 2024

Instrukcje Kombinacje pralko-suszarki

Najnowsze instrukcje dla Kombinacje pralko-suszarki

Whirlpool

Whirlpool FWDD117168SBS EX Instrukcja

14 Stycznia 2025
Summit

Summit SPWD2201SS Instrukcja

13 Stycznia 2025
Edy

Edy WD 985 Instrukcja

13 Stycznia 2025
Indesit

Indesit IWDC 6143 (UK) Instrukcja

14 Października 2024
Summit

Summit SPWD2200W Instrukcja

13 Października 2024
Bosch

Bosch WVD24520EU Instrukcja

13 Października 2024
Indesit

Indesit WIDXL 146 (UK) Instrukcja

12 Października 2024
Indesit

Indesit WIDXE 146 S (UK) Instrukcja

12 Października 2024
Indesit

Indesit EWDC 7145 S FR Instrukcja

12 Października 2024
Indesit

Indesit PWDE 8148 S (UK) Instrukcja

11 Października 2024