Instrukcja obsługi Hoover H-PURIFIER 500 HHP55CA011

Hoover oczyszczacz powietrza H-PURIFIER 500 HHP55CA011

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Hoover H-PURIFIER 500 HHP55CA011 (25 stron) w kategorii oczyszczacz powietrza. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/25
GB
1
REFRIGERATOR/FREEZER COMBINATION
RFA52 xx
NRFAA50 x
NRFAA50 x
AFAA 52 x AI
Contents
Installation, 2-4
Positioning and connection
Door reversal
Description of the appliance, 5
Overall view
Start-up and use, 6-7
Starting the appliance
Using the refrigerator to its full potential
Using the freezer to its full potential
Maintenance and care, 8
Switching the appliance off
Cleaning the appliance
Avoiding mould and unpleasant odours
Replacing the light bulb
Precautions and tips, 9
General safety
Disposal
Respecting and conserving the environment
Troubleshooting, 10
Guarantee, 11
After Sales Service,12
Operating Instructions
English
GB
2
GB
Installation
Your appliance is supplied with a 13amp fused plug that
can be plugged into a 13amp socket for immediate use.
Before using the appliance please read the instructions
below.
WARNING:
THIS APPLIANCE MUST BE EARTHED.
Replacing fuse covers:
When replacing a faulty fuse, a 13amp ASTA approved
fuse to BS 1362 should always be used and the fuse
cover re-fitted.
If the fuse cover is lost, the plug must not be used until a
replacement is obtained.
Replacement fuse covers:
If a replacement fuse cover is fitted, it must be of the
correct colour as indicated by the coloured marking or the
colour that is embossed in words on the base of the plug.
Changing the plug:
Removing the plug
If your appliance has a non-rewireable moulded plug and
you should wish to remove it to add a longer cable or
to re-route the mains cable through partitions, units etc.
please ensure that either:
- The plug is replaced by a fused 13amp re-
wireable plug bearing the BSI mark of
approval.
or
- The mains cable is wired directly into a
13amp cable outlet, controlled by a
switch (in compliance with BS 5733)
which is accessible without moving the
appliance.
Disposing of the plug
Cut off and dispose of the supplied plug if it does not
fit your socket. The cable should be cut as close as
possible to the moulded plug.
Remove the fuse.
WARNING:
To avoid a shock hazard do not insert the discarded
plug into a socket anywhere else.
Before placing your new appliance into operation please
read these operating instructions carefully. They contain
important information for safe use, for installation and for
care of the appliance.
Please keep these operating instructions for future
reference. Pass them on to possible new owners of the
appliance.
Positioning and connection
Positioning
1. Place the appliance in a well-ventilated humidity-free
room.
2. Do not obstruct the rear fan grills. The compressor and
condenser give off heat and require good ventilation to
operate correctly and save energy.
3. Leave a space of at least 10 cm between the top part of
the appliance and any furniture above it, and at least 5 cm
between the sides and any furniture/side walls.
4. Ensure the appliance is away from any sources of heat
(direct sunlight, electric stove, etc.).
5. In order to maintain the correct distance between the
appliance and the wall behind it, fit the spacers supplied
in the installation kit, following the instructions provided.
Levelling
1. Install the appliance on a level and rigid floor.
2. If the floor is not perfectly horizontal, make the necessary
adjustments by tightening or loosening the single foot at
the front of the appliance.
Electrical connections
After the appliance has been transported, carefully place it
vertically and wait at least 3 hours before connecting it to the
electricity mains. Before inserting the plug into the electrical
socket ensure the following:
the law.
appliance, which is indicated on the data plate located on
the bottom left side of the fridge (e.g. 150 W).
indicated on the data plate located on the bottom left side
(e.g. 220-240V).
If the socket is incompatible with the plug, ask an
authorised technician to replace it (see Assistance). Do
Once the appliance has been installed, the power supply
cable and the electrical socket must be easily accessible.
The cable must not be bent or compressed.
The cable must be checked regularly and replaced by
authorised technicians only (see Assistance).
The manufacturer declines any liability should these
safety measures not be observed.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR 5 YEAR PARTS GUARANTEE ON 08448 24 24 24


Specyfikacje produktu

Marka: Hoover
Kategoria: oczyszczacz powietrza
Model: H-PURIFIER 500 HHP55CA011

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Hoover H-PURIFIER 500 HHP55CA011, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje oczyszczacz powietrza Hoover

Instrukcje oczyszczacz powietrza

Najnowsze instrukcje dla oczyszczacz powietrza

Ulsonix

Ulsonix AIRCLEAN 20G Instrukcja

15 Października 2024
Winix

Winix AUS-5500 Instrukcja

14 Października 2024
Gorenje

Gorenje H08WB Instrukcja

9 Października 2024
Ufesa

Ufesa PF4500 Instrukcja

9 Października 2024
Ufesa

Ufesa PF3500 Instrukcja

9 Października 2024
Samsung

Samsung AX32BG3100GB Instrukcja

9 Października 2024
GE

GE AHG50LE Instrukcja

9 Października 2024
Miele

Miele PAC 1200 Instrukcja

9 Października 2024