Instrukcja obsługi Hilti TE 7-C

Hilti maszyna wiertnicza TE 7-C

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Hilti TE 7-C (16 stron) w kategorii maszyna wiertnicza. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/16

TE 7-C

English

English 1

1 Information about the documentation

1.1 About this documentation

• Read this documentation before initial operation or use. This is a prerequisite for safe, trouble-free

handling and use of the product.

• Observe the safety instructions and warnings in this documentation and on the product.

• Always keep the operating instructions with the product and make sure that the operating instructions

are with the product when it is given to other persons.

1.2 Explanation of signs used

1.2.1 Warnings

Warnings alert persons to hazards that occur when handling or using the product. The following signal words

are used in combination with a symbol:

DANGER! Draws attention to imminent danger that will lead to serious personal injury or fatality.

WARNING! Draws attention to a potential hazard that could lead to serious personal injury or

fatality.

CAUTION! Draws attention to a potentially dangerous situation that could lead to minor personal

injury or damage to the equipment or other property.

1.2.2 Symbols in the documentation

The following symbols are used in this document:

Read the operating instructions before use

Instructions for use and other useful information

1.2.3 Symbols in the illustrations

The following symbols are used in illustrations:

These numbers refer to the corresponding illustrations found at the beginning of these operating

instructions.

The numbering reflects the sequence of operations shown in the illustrations and may deviate

from the steps described in the text.

Item reference numbers are used in the and refer to the numbers used inoverview illustrations

the product overview section.

These characters are intended to specifically draw your attention to certain points when handling

the product.

1.3 Product-dependent symbols

1.3.1 Symbols

The following symbols are used:

Drilling without hammer action

Drilling with hammering action (hammer drilling)

Chiseling

Chisel positioning

Rated speed under no load

Revolutions per minute

Protection class II (double-insulated)

Specyfikacje produktu

Marka:	Hilti
Kategoria:	maszyna wiertnicza
Model:	TE 7-C
Źródło zasilania:	Prąd przemienny
Wysokość produktu:	215 mm
Szerokość produktu:	86 mm
Głębokość produktu:	343 mm
Waga produktu:	3400 g
Poziom ciśnienia akustycznego:	89 dB
Energia uderzenia:	2.6 J
Średnica wiertła w betonie (max):	16 mm
Średnica wiertła w metalu (max):	16 mm
Średnica wiertła w drewnie (max):	16 mm
Bieg wsteczny:	Tak
Poziom wibracji (wiercenie udarowe):	17 m/s²