Instrukcja obsługi Hamilton Beach 10090


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Hamilton Beach 10090 (20 stron) w kategorii Żelazo. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/20
Travel Iron/Steamer
Fer à vapeur de voyage
840124300
English .................................................. 2
USA: 1-800-851-8900
Français .............................................. 12
Canada : 1-800-267-2826
Español .............................................. 23
En México 01-800-71-16-100
Le invitamos a leer cuidadosamente este
instructivo antes de usar su aparato.
Plancha de vapor para viaje
READ BEFORE USE
À LIRE AVANT UTILISATION
LEA ANTES DE USAR
840124300 ENv02.qxd 3/16/04 9:28 AM Page 1
3
SAVE THESE INSTRUCTIONS
OTHER CONSUMER SAFETY INFORMATION
This product is intended for household use only.
This appliance is equipped with a polarized plug. This type of plug
has one blade wider than the other. The plug will fit into an electrical
outlet only one way. This is a safety feature intended to help reduce
the risk of electrical shock. If you are unable to insert the plug into
the outlet, try reversing the plug. If the plug should still fail to fit,
contact a qualified electrician to replace the obsolete outlet. Do
not attempt to defeat the safety purpose of the polarized plug by
modifying the plug in any way.
Use the travel iron/steamer on an ironing board. Ironing on any other
surface may damage that surface.
Do not iron or vertical steam clothes that are being worn.
Do not use vertical steam in the direction of people or pets.
SPECIAL INSTRUCTIONS
1. To avoid a circuit overload, do not operate another high wattage appliance on
the same circuit.
2. If an extension cord is absolutely necessary, a 10-ampere cord should be used.
Cords rated for less amperage may overheat. Care should be taken to arrange
the cord so that it cannot be pulled or tripped over.
When using your travel iron/steamer, basic safety precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
1. Use travel iron/steamer only for its intended use.
2. Verify that the voltage in your home corresponds to that of your appliance.
3. To protect against risk of electric shock, do not immerse the travel
iron/steamer in water or other liquids.
4. To reduce the risk of contact with hot water emitting from steam vents, check
appliance before each use by holding soleplate pointed away from body and
operating steam button.
5. The travel iron/steamer should always be turned to OFF ( O ) before plugging
or unplugging from outlet. Never yank cord to disconnect from outlet; instead,
grasp plug and pull to disconnect.
6. Do not allow cord to touch hot surfaces. Let travel iron/steamer cool com-
pletely before putting away. Loop cord loosely around travel iron/steamer
when storing.
7. Always disconnect travel iron/steamer from electrical outlet when filling with
water or emptying and when not in use.
8. Do not operate travel iron/steamer with a damaged cord or if the travel
iron/steamer has been dropped or damaged. To avoid the risk of electric
shock, do not disassemble the travel iron/steamer. Call our toll-free customer
service number for information on examination and repairt. Incorrect
reassembly can cause a risk of electric shock when the travel iron/steamer is
used.
9. Close supervision is necessary for any appliance being used by or near chil-
dren. Do not leave travel iron/steamer unattended while connected or on an
ironing board.
10. Burns can occur from touching hot metal parts, hot water, or steam. Use cau-
tion when you turn travel iron/steamer upside down – there may be hot water
in the reservoir.
11. Be sure dual voltage selector is in correct voltage position before operating.
Before plugging in, read the information about dual voltage operation con-
tained in the instruction section of this manual.
12. This appliance was set at the factory to operate at 120 volts. Refer to
Operating Instructions of this manual for conversion to 240 voltoperation.
IMPORTANT SAFETY INSTRUCTIONS
2
wCAUTION
Burn Hazard
Use caution when filling a hot travel iron/steamer
with water.
Never apply or remove brush attachment when travel
iron/steamer is hot.
Never rotate handle when travel iron/steamer is hot.
840124300 ENv02.qxd 3/16/04 9:28 AM Page 2
5
Before First Use
Use ordinary tap water. If you have extremely hard water,
alternate between tap water and distilled water for use in
travel iron/steamer.
During first use of travel iron/steamer, it may appear to smoke.
This will stop and does not indicate a defect or hazard.
Many irons/steamers spit or sputter during the first few
uses with tap water. This happens as the steam chamber
becomes conditioned. This will stop after a few uses.
Steam vents should be cleared before first use. Prepare
travel iron/steamer for steam ironing, then iron over an old
cloth for a few minutes while pressing the steam button.
1. Brush Attachment
2. Steam Brush
3. Lint Pad
4. Brush Attachment
Lock
5. Brush Attachment Grips
6. Dual Voltage Switch
7. Handle/Water Tank
8. Handle Release/Lock
9. Steam Button
10. Water Tank Plug
11. Temperature Control Dial
12. Power Light
13. Travel iron/steamer Soleplate
Water Cup and Storage Bag not shown.
Make sure the unit is unplugged. Insert small screwdriver or
plug blade into the slot on the dual voltage selector switch
and rotate as follows:
For 120 volts: switch should be turned to the right
(clockwise).
For 240 volts: switch should be turned to the left
(counterclockwise). If using 240 volts, you must use
an appropriate adapter plug.
NOTE: Damage to unit and garments may occur if unit is
operated at 240V with switch set to 120V.
4
Parts and Features
To Dry Iron
1. With travel iron/steamer unplugged, press Handle Release
Button and rotate handle 180 degrees until it locks and is
parallel or “in line” with travel iron/steamer body.
2. Make sure dual voltage selector switch is set to correct
voltage and then plug travel iron/steamer into power supply.
3. Turn Temperature Control Dial to
desired temperature. With travel iron/
steamer resting on side position, allow
three minutes for travel iron/steamer to
reach desired temperature. Do not pre-
heat travel iron/steamer with soleplate
facing down.
4. To turn travel iron/steamer off, turn
Temperature Control Dial to OFF (O).
5. Unplug travel iron/steamer. Allow to cool completely
before returning handle to storage position and placing
travel iron/steamer in storage bag.
To Change Voltage
840124300 ENv02.qxd 3/16/04 9:28 AM Page 4


Specyfikacje produktu

Marka: Hamilton Beach
Kategoria: Żelazo
Model: 10090

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Hamilton Beach 10090, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Żelazo Hamilton Beach

Instrukcje Żelazo

Najnowsze instrukcje dla Żelazo

TriStar

TriStar ST-8137AH Instrukcja

15 Października 2024
Imetec

Imetec E9801 Instrukcja

15 Października 2024
Tefal

Tefal AquaTurbo FV8210 Instrukcja

11 Października 2024
Bomann

Bomann CB 740 Instrukcja

10 Października 2024
Sunbeam

Sunbeam Compact 2630-33 Instrukcja

10 Października 2024
Laurastar

Laurastar LIFT 510 Instrukcja

10 Października 2024
Conair

Conair GlideLite GI305 Instrukcja

9 Października 2024
Ufesa

Ufesa GS1600 Instrukcja

9 Października 2024
Ufesa

Ufesa SV1200 Instrukcja

9 Października 2024
Ufesa

Ufesa Compact2Go GS1800 Instrukcja

9 Października 2024