Instrukcja obsługi Halstead iHeat 35c

Halstead Kotły centralnego ogrzewania iHeat 35c

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Halstead iHeat 35c (8 stron) w kategorii Kotły centralnego ogrzewania. Ta instrukcja była pomocna dla 12 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/8

These instructions should be left with the user

User Instructions

iHeat 25c

iHeat 30c

iHeat 35c

Combination Condensing Boilers

G.C. NUMBER

iHeat 25c N° 47-260-16

iHeat 30c N° 47-260-17

iHeat 35c N° 47-260-18

222 © Halstead Boilers Ltd 2008

Dear Customer

Your boiler has been designed to meet and exceed the very

latest standards in gas central heating technology, and if

cared for, will give years of reliable use and efficiency.

Please therefore take some time to read these instructions

carefully.

Do’s and Don’t’s

●DoDo

DoDo

Do ensure that the system pressure is periodically

checked

●DoDoDoDoDo ensure that you know how to isolate the appliance in

an emergency

●DoDo

DoDoDo ensure that you are familiar with the appliance

controls

●DoDoDoDoDo ensure that your installer has completed the appliance

log book section

●Do notDo not

Do notDo notDo not attempt to remove the appliance casing or gain

internal access

●Do notDo not

Do notDo not

Do not hang clothes etc. over the appliance

●Do notDo not

Do notDo notDo not forget to have the appliance serviced annually.

This booklet is an integral part of the appliance. It is

therefore necessary to ensure that the booklet is handed

to the person responsible for the property in which the

appliance is located/installed. A replacement copy can be

obtained from the customer services.

C o n t en t sC o n t en t s

C o n t en t sC o n t en t sC o n t en t s

I n t r o d u c t i o nI n t r o d u c t i o n

I n t r o d u c t i o n P a g eP a g e

P a g eP a g e

P a g e

Dear customer 2

Do’s and don’t’s 2

Things you should knowThings you should know

Things you should know P a g eP a g e

P a g eP a g e

P a g e

1.1 Gas appliances 3

1.2 Electrical supply 3

1.3 Guarantee registration card 3

1.4 Appliance log book (UK only) 3

1.5 How does it work? 3

1.6 Dimensions 3

1.7 Clearances required 3

1.8 Frost protection system 3

1.9 Status indicators 3

1.10 Digital display 4

Getting startedGetting started

Getting startedGetting startedGetting started P a g eP a g e

P a g eP a g eP a g e

2.1 Before switching on 5

2.2 Appliance controls 5

2.3 Lighting the boiler 5

2.4 Adjusting the CH temperature 5

2.5 Adjusting the DHW temperature 5

How to...ow to...

ow to...ow to...

ow to... P a g eP a g e

P a g eP a g e

P a g e

3.1 Top-up the system 6

3.2 Reset the appliance 6

3.3 Shut down the system for short periods 6

3.4 Shut down the system for long periods 6

3.5 Care for the appliance 6

WWWWWhahahahahattttt if if if if if............... Page Page Page Page Page

4.1 I suspect a gas leak 7

4.2 I have to frequently to top-up the system 7

4.3 The fault light is on 7

4.4 The appliance is due its annual service 7

4.5 I need to call an engineer 7

4.6 I need to extend the warranty 7

S e t t i n gS e t t i n g

S e t t i n g P a g eP a g e

P a g eP a g e

P a g e

5.1 Mechanical clock 7

IntroductionIntroductionIntroductionIntroductionIntroduction

1.11.1

1.1 Gas appliancesGas appliances

Gas appliancesGas appliances

Gas appliances

Gas Safety (Installations and Use) Regulations (UK).

In the interests of your safety and that of others it is a

legal requirement that all gas appliances are installed and

correctly maintained by a competent person and in accord-

ance with the latest regulations.

1.21.2

1.21.21.2 Electrical supplyElectrical supply

Electrical supplyElectrical supplyElectrical supply

Please ensure that this appliance has been properly con-

nected to the electrical supply by means of a double pole

isolator or un-switched socket, and that the correct size of

fuse (3 AMP) has been fitted.

Warning: this appliance must be earthed!

1.31.31.31.31.3 Guarantee registration cardGuarantee registration cardGuarantee registration cardGuarantee registration cardGuarantee registration card

Please take the time to fill out your guarantee registration

card. The completed warranty card should be posted within

30 days of installation.

1.41.41.41.41.4 Appliance Benchmark LogbookAppliance Benchmark LogbookAppliance Benchmark LogbookAppliance Benchmark LogbookAppliance Benchmark Logbook

See rear of booklet for full terms and conditions of your

iHeiHe

iHe aa

att

lifetime guarantee.

A logbook section can be found at the rear of the appliance

installation booklet. This important document must be

completed during the installation/commissioning of your

boiler. All CORGI registered installers carry a CORGI ID card,

and have a registration number. These details should be

recorded in the Benchmark logbook section within the

installation booklet. You can check your installers details

by calling CORGI direct on 01256 372300. Failure to install

and commission the appliance in accordance with the

manufacturers instructions may invalidate the warranty.

This does not affect your statutory rights.

1.51.5

1.5 How does it work?How does it work?

How does it work?How does it work?

How does it work?

Your iHeiHeiHeiHeiHeaaaaattttt boiler supplies heated water to your radiators

and hot water to your hot water taps.

The central heating is controlled via a time clock and any

thermostats that your installer may have fitted. The boiler

will light when it receives a request from the time clock via

any thermostat that may be installed, or whenever a hot

water outlet (tap) is opened.

Your iHeiHe

iHeiHe

iHe aa

att

t boiler lights electronically and does not have a

pilot light.

In the unlikely event of a fault developing with your boiler,

the supply of gas to the burner will be terminated

automatically.

1.81.8

1.8 Frost protection systemFrost protection system

Frost protection systemFrost protection system

Frost protection system

The iHeatiHeatiHeatiHeatiHeat is equipped with a built-in frost protection

system, this enables the boiler to over-ride the time controls

– even if switched off – and operate the burner and/or

pump, should the temperature drop below 6

0C for the main

and below 4°C for the DHW line. In particular the burner

will be in ON status until the main temperature reaches

35°C for CH appliance and 55°C for DHW appliance.

Please note that the frost protection system isPlease note that the frost protection system is

Please note that the frost protection system is

designed to protect the appliance only, should frostdesigned to protect the appliance only, should frost

designed to protect the appliance only, should frostdesigned to protect the appliance only, should frostdesigned to protect the appliance only, should frost

protection be required for the heating system,protection be required for the heating system,protection be required for the heating system,protection be required for the heating system,protection be required for the heating system,

additional controls may be required.additional controls may be required.additional controls may be required.additional controls may be required.additional controls may be required.

When the frost protection system has been activated, ‘AF’‘AF’‘AF’‘AF’‘AF’

is displayed on the appliance LED display (see picture).

N ON O

N ON ON OTT

TTT EE

EEE

The frost protection system is reliant on the appliance having

a permanent electrical supply, and being in a non-fault

condition.

1.91.91.91.91.9 Appliance status indicatorsAppliance status indicatorsAppliance status indicatorsAppliance status indicatorsAppliance status indicators