Instrukcja obsługi Fetco HWD-2102
Fetco
Dozownik wody
HWD-2102
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Fetco HWD-2102 (12 stron) w kategorii Dozownik wody. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/12
FETCO®, and Driven To Innovation™ are trademarks or trade names of Food Equipment Technologies Company.
© 2012 Food Equipment Technologies Company May-2012
NOTICE TO INSTALLER: Please leave this book with the machine.
www.fetco.com
www.fetco.com
www.fetco.com
www.fetco.com www.fetco.com
Model:
Model:
Model:
Model: Model:
f Hot Water Dispenser HWD_2102
Hot Water Dispenser HWD_2102
Hot Water Dispenser HWD_2102
Hot Water Dispenser HWD_2102 Hot Water Dispenser HWD_2102
With
With
With
With With Portion
Portion
Portion
Portion Portion Control
Control
Control
Control Control
USERS GUIDE-Preliminar
y
Edition
®
2
FETCO Hot Water Dispenser HWD_2102
FETCO Hot Water Dispenser HWD_2102
FETCO Hot Water Dispenser HWD_2102
FETCO Hot Water Dispenser HWD_2102 FETCO Hot Water Dispenser HWD_2102
Contact Information
FETCO ®
Food Equipment Technologies Company
600 Rose Road
Lake Zurich • IL USA • • 60047-0429
Internet: www.fetco.com
Phone: (800) 338-2699 (US & Canada)
(847) 719-3000
Fax: (847) 719-3001
Email: sales@fetco.com
techsupport@fetco.com
Description & Features
The following are the factory settings—and range of variables that are adjustable:
Temperature Control: Water temperature is factory set at maximum 97°C/208°F
(Temperature selectable 50-97°C/122°-208°F)
Portion Control: Delivery volume factory set to deliver up to maximum 21fl.oz/630cc.
(Portion control selectable 5-53fl.oz/158-1575cc by timer adjustment)
Operating Instructions
Operating Instructions
Operating Instructions
Operating Instructions Operating Instructions
To Start:
Follow installation and set up procedures. If desired, set custom dispense temperature; dispense time/volume interval.
1) Open water valve
2) Power unit “ON” from rear power switch. Unit will fill and heat (up to 20 minutes for a new unit).
-After unit is filled and heated
3) Ready Lamp will glow green
-Unit may be operated when Ready Lamp is “off” (after initial fill).
4) White colored backlight intensity of control panel slowly pulsates during “READY” condition
Æ the HWD_2102 should be left “ON”. The hot water tank is well insulated to control energy loss.
-The HWD_2102 is ready to dispense-
Refer to control panel layout diagram for HWD_2102 hot water dispenser on Page 3
To dispense
1) Touch UNLOCK/DISPENSE pad for 1-3 seconds to unlock and activate dispensing system
-Border of UNLOCK/DISPENSE pad will change: briefly turn pink and blink signaling activation
2) Remove finger from pad
-Border of UNLOCK/DISPENSE pad will glow steady red: ready to dispense
3) Touch center of UNLOCK/DISPENSE pad to dispense. Keep finger on pad until dispense is complete.
-Dispense automatically stops when time out is complete, or if finger is removed.
Æ Dispense is unlocked and functioning only when Border of UNLOCK/DISPENSE pad is steady red.
Multiple dispenses are possible when the light bordering the UNLOCK/DISPENSE pad is steady and red colored
Lift finger and reactivate after portion by retouching pad for next dispense portion. Finger must be on pad to dispense.
The UNLOCK/DISPENSE pad rapidly flashes red if finger remains on it after dispensing and no water is dispensed.
If finger remains on the UNLOCK/DISPENSE pad more than 10 seconds while rapidly flashing red-the controls “lock out”
and READY LIGHT & HEATING LIGHT will flash rapidly to show a fault state. All controls are disabled during fault state.
To clear Fault State:
Switch machine “OFF” for about ten seconds, and then toggle back “ON” (Control Reset)
After controls initiate, hot water tank level and temperature are checked- then the “READY” light will activate .
Æ This will take approximately 2 minutes for filled and heated unit; up to 20-30 minutes for a new and empty unit.
3
CONTROL PANEL LAYOUT DIAGRAM FOR HWD_2102 HOT WATER DISPENSER
Power Lamp
(Unit is energized)
Ready Lamp
-Dispense will operate when lit,
-Temperature is low when not lit
Heating Lamp
For hot water tank
(is “ON” when heater is activated)
Touch Function Selector
selects and activates selected option
Border of UNLOCK/DISPENSE pad will:
glow white when ready to unlock
-after unlocking by tap of finger-
glow steady red when ready to dispense
flash rapidly to show a fault state
Silicone Tap for hot water dispenser
t∫f Touch Function Selector Technology
Operating Principles
The HWD_2102 delivers precision temperature water at selected temperatures. The green “READY” lamp must
be lit. Unit will dispense water if green “READY” lamp ins not lit.
Unit is factory calibrated at the optimum dispense portion of 21.3fl.oz/630cc (16 sec).
Hot water is drawn from the faucet, the fill valve cycles on and off to replenish the hot water tank.
The dispense valve faucet e bumper over the tap. is protected by a silicon
When dispensing water at a rate that exceeds the unit’s capacity to heat, the ready light will go off to show that
the selected preset temperature is not available. Always observe the “READY” lamp
When the “READY” lamp is lit – proper dispense temperature is enabled.
When heating or reheating, the green “READY” light will turn off and the “HEATING” light will display
Æ After exceeding the maximum optimum dispense portion of 21.3fl.oz/630cc the water supply in the hot
water tank begins do become depleted. The “READY” lamp will turn off. Dispenser faucet does not “lockout”.
This may allow less heated water to dispense. For the highest selected dispense when “READY” lamp is lit.
Æ When the HWD_2102 is powered on (or controller reset)- the controls check and adjust tank level and temperature.
This will take approximately 2 minutes for filled and heated unit; up to 20-30 minutes for a new and empty unit.
Specyfikacje produktu
| Marka: | Fetco |
| Kategoria: | Dozownik wody |
| Model: | HWD-2102 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Fetco HWD-2102, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Dozownik wody Fetco
16 Września 2024
15 Września 2024
13 Września 2024
13 Września 2024
12 Września 2024
10 Września 2024
Instrukcje Dozownik wody
- Dozownik wody Caso
- Dozownik wody Philips
- Dozownik wody Brentwood
- Dozownik wody Hoover
- Dozownik wody Westinghouse
- Dozownik wody Orbegozo
- Dozownik wody Haier
- Dozownik wody Honeywell
- Dozownik wody Emerio
- Dozownik wody Klarstein
- Dozownik wody Güde
- Dozownik wody NewAir
- Dozownik wody SodaStream
- Dozownik wody Bartscher
- Dozownik wody Healthy Choice
- Dozownik wody Princess
- Dozownik wody Waring Commercial
- Dozownik wody Omega
- Dozownik wody Breville
- Dozownik wody Hiberg
- Dozownik wody Hitachi
- Dozownik wody Avanti
- Dozownik wody Korona
- Dozownik wody Avalon
- Dozownik wody Igloo
- Dozownik wody Elba
- Dozownik wody Royal Sovereign
- Dozownik wody Buffalo
- Dozownik wody Oasis
- Dozownik wody Bunn
- Dozownik wody Primo
- Dozownik wody Elkay
- Dozownik wody Petkit
- Dozownik wody SPT
- Dozownik wody Hatco
- Dozownik wody InSinkErator
- Dozownik wody Bloomfield
- Dozownik wody Crathco
- Dozownik wody Aarke
- Dozownik wody Cal-Mil
- Dozownik wody Primo Water
- Dozownik wody Perlick
- Dozownik wody SodaKING
- Dozownik wody BIBO
- Dozownik wody Imarflex
Najnowsze instrukcje dla Dozownik wody
15 Października 2024
9 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024