Instrukcja obsługi Fellowes Powershred 465Ms

Fellowes Niszczarka do papieru Powershred 465Ms

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Fellowes Powershred 465Ms (8 stron) w kategorii Niszczarka do papieru. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/8

Quality Office Products Since 1917

POWERSHRED® 465Ms

Please read these instructions before use.

Do not discard: keep for future reference.

Veuillez lire ces instructions avant d’utiliser l’appareil.

Ne pas jeter : conserver aﬁn de consulter les directives

ultérieurement, en cas de besoin.

Lea estas instrucciones antes del uso.

No las deseche: consérvelas como referencia futura.

A. SafeSense

Technology

B. CD entry

C. See safety instructions

D. Paper/card entry

E. Pull-out bin

F. Window

G. Casters

H. ON/OFF switch

1. OFF

2. ON

Will shred: Paper, credit cards, CD/DVDs and staples

Will not shred: Adhesive labels, continous form paper, transparencies, newspaper,

cardboard, laminates, paper clips, file folders, X-rays or plastic other than noted above

Paper shred size:

Micro-Cut .................................................................. 1/8 in. x 13/32 in. (3mm x 10mm)

Card/CD shred size:

Strip-Cut ................................................................................................19/32 in. (15mm)

Maximum:

Sheets per pass ........................................................................................................... 12*

Cards/CDs per pass ....................................................................................................... 1*

Paper entry width ............................................................................ 8-15/16 in. (227mm)

CD entry width .................................................................................... 4-7/8 in. (124mm)

* 8.5 in. p2-x11 in., 20lb., paper at 120V, 60 Hz(75g) , 5.8Amps; heavier paper, humidity or

other than rated voltage may reduce capacity. Maximum recommended daily usage rates:

500 sheets per day; 25 credit cards; 10 CDs. 12 sheets per pass to avoid jams.

Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging

between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.

CAPABILITIES

ENGLISH

Model 465Ms

KEY

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

• Operation, maintenance, and service requirements are covered in the instruction         

manual. Read the entire instruction manual before operating shredders.

• Keep away from children and pets. Keep hands away from paper entry. Always set             

to off or unplug when not in use.

• Keep foreign objects gloves, jewelry, clothing, hair, etc. away from shredder  –     –   

openings. If object enters top opening, switch to Reverse ( ) to back out object.

• Never use aerosol products, petroleum based lubricants or other flammable         

products on or near shredder. Do not use canned air on shredder.

• Do not use if damaged or defective. Do not disassemble shredder.         

Do not place near or over heat source or water.

• This shredder has an ON/OFF Switch (H) that must be in the ON            () position to

operate shredder. In case of emergency, move switch to OFF (O) position. This

action will stop shredder immediately.

• Avoid touching exposed cutting blades under shredder head.      

• Shredder must be plugged into properly grounded wall outlet or socket of the    a        

voltage and amperage designated on the label. The grounded outlet or socket

must be installed near the equipment and easily accessible. Energy converters,

transformers, or extension cords should not be used with this product.

• FIRE HAZARD Do NOT shred greeting cards with sound chips or batteries. –         

• For indoor use only.   

• Unplug shredder before cleaning or servicing.     

I. Control Panel and LEDs

1. Overheat (red)

2. SafeSense

indicator (yellow)

3. ON/OFF (blue)

4. Reverse

5. Forward

ADvANCED PRODUCT FEATURES

SafeSense® Technology

Stops shredding immediately when

hands touch the paper opening.

SilentShred™ Technology

SilentShred™ noise quality

shreds without noisy disruptions.

PAPER OR CD/CARD

BASIC SHREDDING OPERATION

Continuous operation:

Up to 12-minutes maximum

NOTE: Shredder runs briefly

after each pass to clear entry.

Continuous operation beyond

12-minutes will trigger

25-minute cool down period.

SAFESENSE® TECHNOLOGY

Stops shredding immediately when hands touch the paper opening.

For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

TO CLEAN THE SENSORS

CLEANING UTO-S NFRARED ENSORS A TART I S

Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors

may become blocked by paper dust causing the motor to run even if there is no paper present.

(Note: two paper detection sensors are located in the center of the paper entry).

All micro-cut shredders require oil for peak performance. If not oiled, a

machine may experience diminished sheet capacity, intrusive noise when

shredding, and could ultimately stop running. To avoid these problems, we

recommend you oil your shredder each time you empty your waste bin.

OILING SHREDDER

* Only use a non-aerosol vegetable oil in long

nozzle container such as Fellowes 35250

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE

Locate Auto-start

infared sensor

Using cotton swab, wipe

away any contamination

from the paper sensors

Dip cotton swab in

rubbing alcohol

Press and hold forward

( ) 2-3 seconds

*Apply oil across entry

Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.

Turn OFF (O) and

unplug shredder

TROUBLESHOOTING

Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This

indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about

the continuous operation and recovery time for this shredder.

SafeSense

Indicator: If hands are too close to the paper entry, the SafeSense

indicator will illuminate and the shredder will stop shredding.

Plug in and

turn ON (I)

Feed paper/card

straight into paper

entry and release

Hold CD at edge, feed

into center of entry and

release