Instrukcja obsługi Fellowes MicroShred MS-450Cs

Fellowes Niszczarka do papieru MicroShred MS-450Cs

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Fellowes MicroShred MS-450Cs (6 stron) w kategorii Niszczarka do papieru. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/6
MS-450Cs
MS-450Cs
SafeSense
®
(yellow)
ENGLISH
Model MS-450Cs
Breakthrough Safety Technology! SafeSense® stops shredding when hands are too close to the opening.
Paper entry
Window
Pull-out bin
Shredder head
Sheet capacity icon
Ready (green)
Overheated
Indicator lights
SafeSense
®
Technology
Control switch
Card/CD entry
SafeSense
®
override switch
Active Not active
Auto-On (I) Off (0)
Disconnect power switch
See safety instructions below
Will shred: Paper, credit cards, CD/DVDs and staples
Will not shred: Continuous forms, adhesive labels, transparencies, newspaper,
cardboard, paper clips,* laminates or plastic other than noted above
Paper shred size:
Cross-Cut ..............................................................................................2 x 8mm
Card/CD shred size:
Strip-Cut .....................................................................................................8mm
*Paper clip shredding is not recommended for this shedder.
Maximum:
Sheets per pass (Cross-Cut) ..............................................................................7*
Cards/CDs per pass ...........................................................................................1
Paper width ............................................................................................ 220mm
Card/CD width ........................................................................................125mm
Continuous operation ......................................................................8-10 minutes
* A4 (70g) paper at 220-240v, 50 Hz, MS-450Cs–1.7 Amps; heavier paper, humidity or other than rated
voltage may reduce capacity. Recommended daily usage rates: 25-50 paper passes; 25 cards; 5 CDs.
Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
• AvoidtouchingexposedbladesunderCross-Cutshredderhead.
• Useonlydesignatedentryforcards.KeepfingerawayfromCDhole.
• Thegroundedsocket-outletshallbeinstalledneartheequipmentandshallbeeasily
accessible.
• PaperandCard/CDdiskscannotbeshreddedatthesametime.
2
• Keepawayfromchildrenandpets.Keephandsawayfrompaper
entry. Always unplug when not in use.
• Keepforeignobjects–gloves,jewelry,clothing,hair,etc.–away
fromshredderopenings.Ifobjectenterstopopening,switchto
Reverse()tobackoutobject.
• Neveruseaerosol,petroleumbasedorotherflammableproductsonornear
shredder. Do not use canned air on shredder.
• Donotuseifdamagedordefective.Donotopenshredderhead.Donotplace
near or over heat or water source.
• 7sheetsperpasstoavoidjams.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
CAPABILITIES
Sensor lights upPress Auto-On ( ) Touch test area
To Test SafeSense® Technology
3
Press and hold Reverse ( )
2-3 seconds
Press and hold
Reverse ( )
Set to Off (0)
and unplug
Press Auto-On (I)
Set to Off (0)
and unplug
Feed into paper entry
and release
Set to Off (0)
and plug in
LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from
defects in material and workmanship for 5 years from the date of purchase by the original consumer.
Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 2
years from the date of purchase by the original consumer. If any part is found to be defective during the
warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowesoption and
expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED
WARRANTY,INCLUDINGTHATOFMERCHANTABILITYORFITNESSFORAPARTICULARPURPOSE,ISHEREBY
LIMITED IN DURATION TOTHE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall
Fellowesbeliableforanyconsequentialorincidentaldamagesattributabletothisproduct.
This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid
worldwide,exceptwheredifferentlimitations,restrictions,orconditionsmayberequiredbylocallaw.
For more details or to obtain service under this warranty, please contact us or your dealer.
Continuous operation:
8-10-minute maximum
NOTE: Shredder runs briefly after
each pass to clear entry.
Continuous operation beyond
8-10-minutes will trigger a cool
down period to resume operation.
Gentlypulluncutpaper
from paper entry. Plug in.
Run regularly in reverse for
one minute
Oil when bin is full, or
immediately, if:
•Capacitydecreases
•Motorsoundsdifferent,or
Shredder stops running
OPERATION
TROUBLESHOOTING
MAINTENANCE
Shredder doesn’t start:
Follow oiling procedure below and repeat twice.
WARRANTY
Alternate slowly back and forth
Press forward*Apply oil
across entry
Press Auto-On (I)
Yellow - SafeSense
®
active
Yellow flashing - SafeSense
®
not active
Make sure bin is pushed in
Wait for motor to cool down
Shred one sheet
Paper jam: Set to Off (0) and empty bin. Replace bin and follow any or all of the below procedures.
PAPER
CARD/CD
Hold card/CD at edge
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
Feed into card/CD entry
and release
ATTENTION: If the SafeSense® light remains on, you must engage the Override Switchinordertoperformstepsabove.Oncethejamiscleared,resetthe
SafeSense® feature. (See SafeSense® instructions below.)
SafeSense® paper jam: If the SafeSense® feature activates (SafeSense® light remains on) to cause the user to think the
shredderhasjammedwhenithasnot,usetheOverride Switch to deactivate the SafeSense® feature and clear the
paper. Warning when switch is in override position, the SafeSense® light will flash and the SafeSense
® feature will NOT
function. Once the paper is cleared, reset the SafeSense®
feature.
Press and hold
Reverse ( )
SafeSense
®
override switch
Active Not active
Sensor light illuminated–paper
jammed
Disconnect power switch must be in ON (I) position to operate shredder. Insert waste bag (Fellowes #36052) for easy disposal.


Specyfikacje produktu

Marka: Fellowes
Kategoria: Niszczarka do papieru
Model: MicroShred MS-450Cs

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Fellowes MicroShred MS-450Cs, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Niszczarka do papieru Fellowes

Instrukcje Niszczarka do papieru

Najnowsze instrukcje dla Niszczarka do papieru

GBC

GBC Momentum X26-32 Instrukcja

8 Października 2024
GBC

GBC AutoFeed+ 300M Instrukcja

8 Października 2024
GBC

GBC AutoFeed+ 150X Instrukcja

8 Października 2024
GBC

GBC Momentum X18-12 Instrukcja

8 Października 2024
GBC

GBC AutoFeed+ 300X Instrukcja

8 Października 2024
Bonsaii

Bonsaii S120-C Instrukcja

7 Października 2024
Bonsaii

Bonsaii C209-D Instrukcja

7 Października 2024
Bonsaii

Bonsaii 4S30 Instrukcja

7 Października 2024
Bonsaii

Bonsaii 3S16 Instrukcja

7 Października 2024
Peach

Peach PS300-21 Instrukcja

7 Października 2024