Instrukcja obsługi Fellowes Fortishred 2250S

Fellowes niszczarka Fortishred 2250S

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Fellowes Fortishred 2250S (8 stron) w kategorii niszczarka. Ta instrukcja była pomocna dla 28 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/8

Quality Office Products Since 1917

FORTISHREDTM 2250C/2250S/2250M

Please read these instructions before use.

Do not discard: keep for future reference.

Veuillez lire ces instructions avant d’utiliser l’appareil.

Ne pas jeter : conserver aﬁn de consulter les directives

ultérieurement, en cas de besoin.

Lea estas instrucciones antes del uso.

No las deseche: consérvelas como referencia futura.

ENGLISH

Model 2250C/2250S/2250M

Will shred:

2250C and 2250S: Paper, staples, paper clips, credit cards, CD/DVDs and junk mail.

2250M: Paper, paper clips, staples and credit cards.

Will not shred: Adhesive labels, continuous form paper, transparencies, newspaper,

cardboard, laminates, file folders, X-rays or plastic other than noted above

Paper shred size:

Strip-Cut ........................................................................................... 5/32 in. (4mm)

Cross-Cut ........................................................ 5/32 in. x 1-9/16 in. (4mm x 40mm)

Micro-Cut .......................................................... 2/32 in. x 9/16 in. (2mm x 15mm)

*In order to perform at capacity, shredder must be plugged into a dedicated 15Amp,

120V outlet and oiled every 15-30 minutes of continuous use.

Maximum:

Paper entry width ............................................................................. 10.25”/260mm

* 8.5”x11”, 20lb., (75g) paper at 120V, 60 Hz, 5.6Amps; heavier paper, humidity or other

than rated voltage may reduce capacity.

KEY

H. Control Panel and LEDs

1. ON/OFF (blue)

2. Reverse (red)

3. Bin full (yellow)

4. Door open (red)

5. Safety Shield Open (red)

A. Safety Shield

B. Paper entry

C. Disconnect switch (open door)

D. Door

E. Basket (inside)

F. Casters

G. See safety instructions

• Operation, maintenance, and service requirements are covered in the instruction

manual. Read the entire instruction manual before operating shredders.

• Keep away from children and pets. Keep hands away from paper entry. Always set

to off or unplug when not in use.

• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder

openings. If object enters top opening, switch to Reverse (R) to back out object.

• Never use aerosol products, petroleum based lubricants or other flammable

products on or near shredder. Do not use canned air on shredder.

• Do not use if damaged or defective. Do not disassemble shredder.

Do not place near or over heat source or water.

• Do not operate the machine without the safety shield closed (A).

• This shredder has a Disconnect Power Switch in the cabinet door. The door must

be fully closed to operate shredder. In case of emergency, open cabinet door. This

action will stop shredding immediately.

• Avoid touching exposed cutting blades under shredder head.

• Shredder must be plugged into a properly grounded wall outlet or socket of the

voltage and amperage designated on the label. The grounded outlet or socket

must be installed near the equipment and easily accessible. Energy converters,

transformers, or extension cords should not be used with this product.

• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.

• For indoor use only.

• Unplug shredder before cleaning or servicing.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

CAPABILITIES

BASIC SHREDDING OPERATIONBASIC SET UP

ADVANCED PRODUCT FEATURES

PRODUCT MAINTENANCE

Ensure access to a

dedicated 15Amp,

120V outlet

41 3

Open the door

1 2 34

Place cutter head into

top of cabinet, use 2

people

Plug in and make

sure door is closed

Press ( ) ON to

activate

When finished

shredding set to

( ) OFF

Feed paper straight

into paper entry and

release

Do nothing and shredder

will automatically shut

off after 30 minutes of

inactivity

Make sure safety flap

is securely in place

SHREDDER SET-UP

All cross-cut and micro-cut shredders require oil for peak performance. If not

oiled, a machine may experience diminished sheet capacity, intrusive noise

when shredding and could ultimately stop running. To avoid these problems,

we recommend you oil your shredder each time you empty your waste bin or

every 15-30 minutes of continuous use.

OILING SHREDDER

*Apply oil

across entry

Press Reverse (R)

Set to Off ( )

and unplug

CLEANING AUTO-START INFRARED SENSORS

PAPER JAM

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE

Paper detection sensors are designed for maintenance free operation. However, on rare

occasions the sensors may become blocked by paper dust causing the motor to run even if

there is no paper present (Note: two paper detection sensors are located in the center of the paper entry).

Turn off and unplug

shredder

Locate Auto-start

infared sensor

Clean any contamination

from the paper sensors

12 3 4

Use thin, long-handled

brush to clean sensors.

Make sure brush is clean

and dry

TO CLEAN THE SENSORS

TROUBLESHOOTING

TO SHRED

SilentShred™ Technology

SilentShred™ noise quality

shreds without noisy disruptions.

Paper Capacity Indicator: When flashing blue, too much paper is inserted. Shredder will

automatically stop and reverse paper. See Paper Jam section.

Bin Full Indicator: When illuminated, the shredder waste bin is full and needs to be emptied.

Use Fellowes waste bag 36054.

Safety Shield Indicator: When flashing alternatively with On/Off LED, safety shield is

open and shredding will stop. To resume shredding, make sure safety shield is closed.

Door Open Indicator: When flashing alternatively with On/Off LED, the door is open.

To resume shredding, make sure door is closed.

Overheat Indicator: When flashing alternatively with On/Off LED, shredder requires

a 10-15 minute cool down period. When is blue, resume shredding.

When flashing blue,

too much paper is

inserted. Shredder

will automatically stop

and reverse paper

Gently pull uncut paper

from paper entry

Shred 1 sheet of

paper to clear

cutters. Resume

normal shredding

If necessary, press

Reverse (R) to run

shredder in reverse

and then pull uncut

paper from shredder

Safety Shield

Electronically controlled shield stops

shredder when opened for advanced safety

Auto Shut Off

After 30 minutes of inactivity, shredder

automatically turns off for zero energy

consumption

*Only use a non-aerosol vegetable oil in long nozzle

container such as Fellowes 35250

Specyfikacje produktu

Marka:	Fellowes
Kategoria:	niszczarka
Model:	Fortishred 2250S
Kolor produktu:	Black, Grey
Wymiary (SxGxW) (imperialne):	19.69 x 15.00 x 34.25 "
Rozdrabniacz:	Rozdrabnianie taśmowe
Niszczenie spinaczy:	Tak
Niszczenie zszywek:	Tak
Szerokość szczeliny wejściowej:	260 mm
Niszczenie płyt CD:	Tak
Niszczenie papieru:	Tak
Niszczenie kart kredytowych:	Tak
Ilość arkuszy niszczonych jednocześnie:	21 ark.
Prędkość niszczenia:	6000 mm/min
Pojemność kosza:	75.7 l
Automatyczne włączanie/wyłączanie:	Tak
Poziom bezpieczeństwa (papier):	2