Instrukcja obsługi Fellowes AutoMax 100MA

Fellowes niszczarka AutoMax 100MA

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Fellowes AutoMax 100MA (8 stron) w kategorii niszczarka. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/8
PleaS
do not dISCaRd: keeP FoR FUtURe ReFeRenCe.
veUIllez lIRe CeS InStRUCtIonS avant dUtIlISeR l’aPPaReIl.
ne PaS jeteR : ConSeRveR aFIn de ConSUlteR leS dIReCtIveS
UltéRIeUReMent, en CaS de BeSoIn.
lea eStaS InStRUCCIoneS anteS del USo.
no laS deSeChe: ConSéRvelaS CoMo ReFeRenCIa FUtURa.
AutoMaxTM 100MA
The World's Toughest Shredders®
2
CAPABILITIES
Will shred: Paper, plastic credit cards*, staples* and small paper clips*
*
Manual Feed
Will not shred: Adhesive labels, CD/DVDs, continuous form paper, transparencies,
newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than
noted above
Paper shred size:
Micro-Cut ...................................................................... 5/32 in. x 1/2 in. (4mmx12mm)
Maximum:
Sheets per pass (Auto Feed) ....................................................................................... 100*
Sheets per pass (Manual Feed) .................................................................................... 10*
Cards per pass ............................................................................................................... 1*
Paper entry width .....................................................................................8.7 in. (220mm)
* 8.5 in. x 11 in., 20lb., paper at 120V/60 Hz,(75g) 3.5Amps; heavier paper, humidity
or other than rated voltage may reduce capacity. Recommended daily usage rates:
600 sheets; 10 credit cards.
IMPORTANT SAFETY INSTRUCTIONS Read Before Using!
ENGLISH
Model 100MA
KEY FEATURES AND CONTROLS
A. Auto Feed Tray
B. Auto Feed Access Panel
C. Disconnect Power Switch
1. OFF
2. ON
D. Manual Feed Slot
E. Pull-Out Bin
F. Casters
G. See Safety Instructions
H. Control Panel and LEDs
1. Reverse
2. Start (blue)
3. Bin Open
4. Remove Paper (red)
5. Bin Full (red)
6. Overheat (red)
B.
A.
F.
D.
E.
G.
H.
C.
t 0QFSBUJPONBJOUFOBODFBOETFSWJDFSFRVJSFNFOUTBSFDPWFSFEJOUIF
instruction manual. Read the entire instruction manual before operating
shredders.
t .PWJOHQBSUT,FFQBXBZGSPNDIJMESFOBOEQFUT,FFQIBOETBXBZGSPN
paper entry. Always set to off or unplug when not in use
t ,FFQGPSFJHOPCKFDUToHMPWFTKFXFMSZDMPUIJOHIBJSFUDoBXBZGSPN
shredder openings. If object enters top opening, switch to Reverse ( )
to back out object.
t %0/05VTFBFSPTPMQSPEVDUTQFUSPMFVNCBTFEPSBFSPTPMMVCSJDBOUTPO
or near shredder. DO NOT USE “CANNED AIR” OR “AIR DUSTERS” ON
SHREDDER. Vapors from propellants and petroleum based lubricants may
combust causing serious injury.
t 4IBSQFEHFT%0/05UPVDIFYQPTFEDVUUJOHCMBEFTVOEFSTISFEEFSIFBE
t %POPUVTFJGEBNBHFEPSEFGFDUJWF%POPUEJTBTTFNCMFTISFEEFS%POPU
place near or over heat source or water.
t 5IJTTISFEEFSIBTB%JTDPOOFDU1PXFS4XJUDI$UIBUNVTUCFJOUIF0/*
position to operate shredder. In case of emergency, move switch to OFF ( )
position. This action will stop shredder immediately.
t 4ISFEEFSNVTUCFQMVHHFEJOUPBQSPQFSMZHSPVOEFEXBMMPVUMFUPSTPDLFUPG
the voltage and amperage designated on the label. The grounded outlet or
socket must be installed near the equipment and easily accessible. Energy
converters, transformers, or extension cords should not be used with this product.
t '*3&)";"3%o%P/05TISFEHSFFUJOHDBSETXJUITPVOEDIJQTPSCBUUFSJFT
t 'PSJOEPPSVTFPOMZ
t 6OQMVHTISFEEFSCFGPSFDMFBOJOHPSTFSWJDJOH
3
*Apply oil across entry Press and hold Reverse
(
) for 2-3 seconds
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
Remove Paper: When illuminated, set to reverse
(
)
and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
If the jam occurred while using the auto feed feature, you can also open the access panel and slowly remove any paper found. To open the access panel, engage
both levers and slowly raise up.
TROUBLESHOOTING
PRODUCT MAINTENANCE
TO CLEAN THE SENSORS
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: the paper detection sensors is located in the center of the paper entry).
All micro-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
OILING SHREDDER
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
Turn off ( ) and
unplug shredder
Locate Auto-start infrared sensors. To access the auto
feed infrared sensor, open access panel by engaging
both levers and slowly raising up.
Continuous operation: up to
7 minutes maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
7 minutes will trigger 40-minute
cool down period.
BASIC SHREDDING OPERATION
MANUAL FEED AUTO FEED
Plug in and put
disconnect power
switch in ON (I) position
Plug in and put
disconnect power
switch in ON (I) position
Open auto feed
paper tray*
Press start ( ) to
begin shredding
Add paper
1
1
* Do not use auto feed tray to move shredder.
BASIC SET UP
CASTER INSTALLATION
1 3 42
Using cotton swab, wipe away any
contamination from the paper sensors
Dip cotton swab in
rubbing alcohol
3
Feed paper/card
straight into paper
entry and release
1
1
Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36052.
Bin Open: The shredder will not run if the bin is open. Close the bin to resume shredding.
22 3
4
2
4
2


Specyfikacje produktu

Marka: Fellowes
Kategoria: niszczarka
Model: AutoMax 100MA

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Fellowes AutoMax 100MA, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje niszczarka Fellowes

Instrukcje niszczarka

Najnowsze instrukcje dla niszczarka