Instrukcja obsługi Elica Easy PRF0158722

Elica Okap wyciągowy Easy PRF0158722

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Elica Easy PRF0158722 (28 stron) w kategorii Okap wyciągowy. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/28

READ AND SAVE THESE INSTRUCTIONS

LISEZ CES INSTRUCTIONS ET CONSERVEZ-LES

THIS MANUAL IS FOR USE ONLY IN USA AND CANADA

CE MANUEL EST UNIQUEMENT VALABLE AUX USA ET AU CANADA

EN - Instruction on mounting and use

READ AND SAVE THESE

INSTRUCTIONS

APPROVED FOR RESIDENTIAL APPLIANCES

FOR RESIDENTIAL USE ONLY

READ AND SAVE THESE INSTRUCTIONS

PLEASE READ ENTIRE INSTRUCTIONS BEFORE

PROCEEDING.

INSTALLATION MUST COMPLY WITH ALL LOCAL

CODES.

IMPORTANT: Save these Instructions for the Local

Electrical Inspector’s use.

INSTALLER: Please leave these Instructions with this unit

for the owner.

OWNER: Please retain these instructions for future

reference.

Safety Warning: Turn off power circuit at service panel

and lock out panel, before wiring this appliance.

Requirement: 120V, 60 Hz, 15 or 20 A Branch Circuit

Removing the packaging

CAUTION!

Remove carton carefully, Wear gloves to protect against

sharp edges.

WARNING!

Remove the protective film covering the product before

putting into operation.

Note: The parts marked with the symbol "(*)" are optional

accessories supplied only with some models or otherwise not

supplied, but available for purchase.

Important safety Notice

CAUTION

FOR GENERAL VENTILATING USE ONLY. DO NOT USE

TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS

OR VAPOURS.

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR

INJURY TO PERSONS, OBSERVE THE FOLLOWING:

A. Use this unit only in the manner intended by the

manufacturer. If you have questions, contact the

manufacturer.

B. Before servicing or cleaning the unit, switch power off at

service panel and lock service panel disconnecting

means to prevent power from being switched on

accidentally. When the service disconnecting means

cannot be locked, securely fasten a prominent warning

device, such as a tag, to the service panel.

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR

INJURY TO PERSONS, OBSERVE THE FOLLOWING:

A. Installation Work and Electrical Wiring Must Be Done By

Qualified Person(s) In Accordance With All Applicable

Codes & Standards, Including Fire-rated Construction.

B. Sufficient air is needed for proper combustion and

exhausting of gases through the flue (Chimney) of fuel

burning equipment to prevent back- drafting. Follow the

heating equipment manufacturers guideline and safety

standards such as those published by the National Fire

Protection Association (NFPA), the American Society for

Heating, Refrigeration and Air Conditioning Engineers

(ASHRAE), and the local code authorities.

C. When cutting or drilling into wall or ceiling, do not

damage electrical wiring and other hidden utilities.

D. Ducted systems must always be vented to the outdoors.

WARNING

TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCT

WORK.

Install this hood in accordance with all requirements specified.

WARNING

To Reduce The Risk Of Fire Or Electric Shock, Do Not

Use This Hood With Any External Solid State Speed

Control Device.

WARNING

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE.

a) Never leave surface units unattended at high settings.

Boilovers cause smoking and greasy spillovers that may

ignite. Heat oils slowly on low or medium settings.

b) Always turn hood ON when cooking at high heat or when

flambeing food (I.e. Crepes Suzette, Cherries Jubilee,

Peppercorn Beef Flambe’).

c) Clean ventilating fans frequently. Grease should not be

allowed to accumulate on fan or filter.

d) Use proper pan size. Always use cookware appropriate

for the size of the surface element.

WARNING

TO REDUCE THE RISK OF INJURY TO PERSONS, IN THE

EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE

FOLLOWINGa:

a) SMOTHER FLAMES with a close-fitting lid, cookie sheet,

or other metal tray, then turn off the gas burner or the

electric element. BE CAREFUL TO PREVENT BURNS.

If the flames do not go out immediately, EVACUATE

AND CALL THE FIRE DEPARTMENT.

b) NEVER PICK UP A FLAMING PAN - you may be burned.

c) DO NOT USE WATER, including wet dishcloths or towels

- a violent steam explosion will result.

d) Use an extinguisher ONLY if:

1) You know you have a class ABC extinguisher,

and you already know how to operate it.

2) The fire is small and contained in the area

where it started.

3) The fire department is being called.

4) You can fight the fire with your back to an exit.

aBased on "Kitchen Firesafety Tips" published by NFPA.

OPERATION

a. Always leave safety grills and filters in place. Without these

components, operating blowers could catch onto hair, fingers

and loose clothing.

The manufacturer declines all responsibility in the event of

failure to observe the instructions given here for installation,

maintenance and suitable use of the product. The

manufacturer further declines all responsibility for injury due to

negligence and the warranty of the unit automatically expires

due to improper maintenance.

Electrical & Installation

requirements

Electrical requirements

IMPORTANT

Observe all governing codes and ordinances.

It is the customer’s responsibility:

To contact a qualified electrical installer.

To assure that the electrical installation is

adequate and in conformance with National

Electrical Code, ANSI/NFPA 70 — latest

edition*, or CSA Standards C22.1-94,

Canadian Electrical Code, Part 1 and C22.2

No.0-M91 - latest edition** and all local

codes and ordinances.

If codes permit and a separate ground wire is

used, it is recommended that a qualified

electrician determine that the ground path is

adequate.

Do not ground to a gas pipe.

Check with a qualified electrician if you are

not sure range hood is properly grounded.

Do not have a fuse in the neutral or ground

circuit.

IMPORTANT

Save Installation Instructions for electrical

inspector’s use.

The range hood must be connected with

copper wire only.

The range hood should be connected directly

to the fused disconnect (Or circuit breaker)

box through metal electrical conduit.

Wire sizes must conform to the requirements

of the National Electrical Code ANSI/NFPA

70 — latest edition*, or CSA Standards

C22.1-94, Canadian Electrical Code Part 1

and C22.2 No. 0-M91 - latest edition** and all

local codes and ordinances.

A U.L.- or C.S.A.-listed conduit connector

must be provided at each end of the power

Specyfikacje produktu

Marka:	Elica
Kategoria:	Okap wyciągowy
Model:	Easy PRF0158722
Kolor produktu:	Biały
Wbudowany wyświetlacz:	Nie
Wysokość produktu:	685 mm
Szerokość produktu:	898 mm
Głębokość produktu:	500 mm
Poziom hałasu:	72 dB
Model:	Naścienny
Prędkości:	3
Maksymalna moc ekstrakcji:	760 m³/h
Minimalna odległość od płyty gazowej:	650 mm
Minimalna odległość od płyty elektrycznej:	550 mm