Instrukcja obsługi Elektron Analog Heat +FX

Elektron Niesklasyfikowane Analog Heat +FX

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Elektron Analog Heat +FX (48 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/48

FCC compliance statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment o and on, the user is encour-

aged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

European Union regulation compliance statement

This product has been tested to comply with the Low Voltage Directive 2014/35/EU and the Electro-

magnetic Compatibility Directive 2014/30/EU. The product meets the requirements of RoHS 2 Directive

2011/65/EU.

This symbol indicates that your product must be disposed of properly according to local

laws and regulations.

Legal disclaimer

The information in this document is subject to change without notice and should not be construed as a

commitment by Elektron. Elektron assumes no responsibility for any errors that may appear in this doc-

ument. Elektron may also make improvements and/or changes in the products and programs described

in this document at any time without notice. In no event shall Elektron be liable for any special, indirect,

or consequential damages or any damages whatsoever resulting from loss of use, data, or proﬁts,

whether in an action of contract, negligence, or other action, arising out of or in connection with the use

or performance of this information.

Canada

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003

IMPORTANT SAFETY AND MAINTENANCE INSTRUCTIONS

Please read these instructions carefully and follow the operating advice given here.

1. Do not use this unit near water.

2. Never use aggressive cleaners on the casing or the screen. Remove dust, dirt and ﬁngerprints with a

soft, dry and non-abrasive cloth. More persistent dirt can be removed with a slightly damp cloth using

only water. Disconnect all cables before doing this. Only reconnect them when the product is safely dry.

3. Install by following the manufacturer’s instructions. Make sure you place the unit on a stable surface

before use.

4. Connect the unit to an easily accessible electrical outlet close to the unit.

5. When transporting the unit, use accessories recommended by the manufacturer or the original box and

padding.

6. Do not install near any heat sources such as radiators, heat registers, stoves, or any other equipment

(including ampliﬁers) producing heat.

7. Do not block the ventilation holes located on the bottom of the enclosure of the unit. Make sure there is

sucient air circulation in the room where the unit is kept.

8. This product, in combination with an ampliﬁer and speakers or headphones, is capable of producing

sound levels that can cause permanent hearing loss. Do not operate for extended periods of time at a

high volume level or at a level that is uncomfortable.

9. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles,

and the point where they exit from the unit.

10. Use attachments/accessories speciﬁed by the manufacturer.

11. Unplug this unit during lightning storms or when it is not used for extended periods of time.

12. Refer all servicing to qualiﬁed service technicians. Servicing is required when the unit has been

damaged in any way, liquid has been spilled or objects have fallen into the unit, the unit has been

exposed to rain or moisture, does not operate normally, or has been dropped.

WARNING

To reduce the risk of ﬁre, electrical shock or product damage:

• Do not expose the unit to rain, moisture, dripping or splashing and also avoid placing objects ﬁlled with

liquid, such as vases, on the unit.

• Do not expose the unit to direct sunlight, nor use it in ambient temperatures exceeding 35°C as this can

lead to malfunction.

• Do not open the casing. There are no user repairable or adjustable parts inside. Leave service and re-

pairs to trained service technicians only.

• Do not exceed the limitations speciﬁed in the Electrical speciﬁcations.

SAFETY INSTRUCTIONS FOR THE POWER ADAPTER

• The adapter is not safety grounded and may only be used indoors.

• To ensure sucient ventilation for the adapter, do not place it in tight spaces. To prevent the risk of elec-

tric shock and ﬁre because of overheating, ensure that curtains and other objects do not prevent adapter

ventilation.

• Do not expose the power adapter to direct sunlight, nor use it in ambient temperatures exceeding 40°C.

• Connect the adapter to an easily accessible electrical outlet close to the unit.

• The adapter is in standby mode when the power cord is connected. The primary circuit is always active

as long as the cord is attached to the power outlet. Pull out the power cord to completely disconnect the

adapter.

• In the EU, only use CE approved power cords.

Specyfikacje produktu

Marka:	Elektron
Kategoria:	Niesklasyfikowane
Model:	Analog Heat +FX

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Elektron Analog Heat +FX, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Niesklasyfikowane Elektron

Elektron Analog Heat +FX Instrukcja

19 Września 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024

Stihl HT 70 Instrukcja

15 Października 2024

Ernesto H14270 Instrukcja

15 Października 2024

Uniden BT MIC KIT Instrukcja

15 Października 2024

Vaude Omnis Bike 26 Instrukcja

15 Października 2024

ART ProChannel II Instrukcja

15 Października 2024

Aukey DR02J Instrukcja

15 Października 2024

Master Lock 653EURD Instrukcja

15 Października 2024

Roland FR-18 Diatonic Instrukcja

15 Października 2024