Instrukcja obsługi ELAC Protek PR-71S

ELAC Niesklasyfikowane Protek PR-71S

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla ELAC Protek PR-71S (4 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
PR71-S 8-Outlet Component Surge Protector Setup Guide
PRODUCT FEATURES
USING YOUR SURGE PROTECTOR
1. Ensure the power is o on the devices you will be connecting to the AC outlets on the surge protector.
2. Plug the surge protector into a properly grounded AC wall outlet and turn on the surge protector.
3. Check that the PROTECTED and GROUNDED blue LEDs are illuminated. If the PROTECTED LED is not illuminated, the surge
protector is not operating properly and will not protect your connected devices. If the GROUNDED LED is not illuminated the
outlet the surge protector is connected to is not properly grounded and should not be used. Please have a licensed
electrician diagnose and troubleshoot the aected wall outlet prior to use.
4. Plug your equipment into the outlets on the surge protector and power on your devices as usual.
5. USB devices can be charged/powered by simply connecting the USB power cord to the USB ports on the surge protector.
The USB ports deliver 5V and up to 2.4amps of power.
⑤
④ ⑥ ⑦ ⑧
⑨ ⑩ ⑪
ELAC A
ELAC A
ELAC A
ELAC AELAC AMERICAS I
MERICAS I
MERICAS I
MERICAS IMERICAS INC.
NC.
NC.
NC. NC.
1938 N. BATAVIA ST. SUITE K
1938 N. BATAVIA ST. SUITE K
1938 N. BATAVIA ST. SUITE K
1938 N. BATAVIA ST. SUITE K 1938 N. BATAVIA ST. SUITE K
ORANGE, CA 92865
ORANGE, CA 92865
ORANGE, CA 92865
ORANGE, CA 92865 ORANGE, CA 92865
Copyright 2021 ELAC Americas Inc.
① Power Button—Press this button (.5 sec to 1 sec) to power on and
o the rear AC outlets. Press and hold for 10 seconds to factory reset
the unit.
② Reboot Button—Pressing and holding the REBOOT button for 1.5
seconds will power cycle all outlets in Group 1.
③ Dimmer Button—Adjusts the brightness of the LCD and other
LEDs to 10%, 35%, 70% and 100%.
④ Voltage Display—Displays the Voltage of the outlet that the surge
protector is plugged into.
⑤ LED Indicators— Indicates the status of the surge protector.
• Protected / Clean Power
Protected / Clean Power
Protected / Clean Power
Protected / Clean PowerProtected / Clean Power—LED On: Outlets are Protected. LED
O: Surge Protection is not working and your connected devices
are not protected.
• Ground OK
Ground OK
Ground OK
Ground OKGround OK—LED On: The wall outlet is properly grounded. LED
O: The wall outlet is NOT properly grounded and a licensed
electrician should be called to resolve the problem.
• Reversed Polarity
Reversed Polarity
Reversed Polarity
Reversed PolarityReversed Polarity—LED O: The wall outlet polarity is correct.
LED On: Reverse polarity detected. Please contact a licensed
electrician to resolve the issue.
• Unsafe Voltage
Unsafe Voltage
Unsafe Voltage
Unsafe VoltageUnsafe Voltage—LED O: Normal voltage detected. LED On:
Unsafe voltage detected and the surge protector will disconnect
power to your connected devices. Please consult a licensed
electrician.
⑥ Front AC Outlet—This front AC outlet always on unless unsafe
voltage is detected.
⑦ Front Outlet Indicator—Front AC outlet power indicator.
⑧ Dual USB Charging Ports: 5V 2.4 Amp Total USB-A ports for
charging compatible devices.
⑨ Group 2 AC Outlets— These 5 outlets provide 58db of EMI/RFI
filtration and are perfect for source and lower current devices.
⑩ Group 1 AC Outlets—These 2 outlets are designed for high current
devices such as audio amplifiers.
⑪ Overload Breaker—This breaker will trip when the surge protector
is overloaded. After resetting, please ensure the Protected/Clean
Power LED is On, if not, your surge protector needs to be replaced.
• RISK OF ELECTRIC SHOCK – Use only in dry locations and only
indoors.
• DO NOT plug into another relocatable power tap.
• DO NOT “daisy chain” surge protectors.
• DO NOT plug into 220V outlet or power source.
• DO NOT use with any aquarium equipment.
• DO NOT connect to an ungrounded outlet.
• DO NOT install this device if there is not at least 30 feet (10 meters),
or more of wire between the electrical outlet and electrical service
panel.
• This device features internal protection that will disconnect the
surge protective component at the end of its useful life
(PROTECTED LED WILL TURN OFF) , but will maintain power to the
outlet – WHICH WILL BE UNPROTECTED. If you don’t want your
equipment at risk, follow the manufacturer’s instructions for replac-
ing the device.
• DO NOT use in any circumstance that would aect the operation or
reliability of life support equipment, any medical applications, or
patient care.
SAFETY INFORMATION TECHNICAL SPECIFICATIONS
Number of AC Outlets 8
Number of USB Ports 2—5V total 2.4A
AC Outlets All 8 filtered with surge protection
Protection Modes L-N, L-G, N-G, Surge
Thermal Fuse Yes
Maximum Current 15 Amps
Line Voltage 120V @ 60Hz
Certification UL 1449, UL 1363, FCC, ICES
Max Energy Dissipation 2160 Joules
Max Spike Voltage / Current 6,000V / 144,000A
Response Time 1 Nanosecond
Filtration EMI / RFI G1: 40dB G2: 58dB
Over/Under Voltage Protection Over 135Vac / Under 95Vac
ELAC A
ELAC A
ELAC A
ELAC AELAC AMERICAS I
MERICAS I
MERICAS I
MERICAS IMERICAS INC.
NC.
NC.
NC. NC.
1938 N. BATAVIA ST. SUITE K
1938 N. BATAVIA ST. SUITE K
1938 N. BATAVIA ST. SUITE K
1938 N. BATAVIA ST. SUITE K 1938 N. BATAVIA ST. SUITE K
ORANGE, CA 92865
ORANGE, CA 92865
ORANGE, CA 92865
ORANGE, CA 92865 ORANGE, CA 92865
Copyright 2021 ELAC Americas Inc.
CAUTIONS!
This surge protector is designed to protect your electronic equipment from AC power surges up to its rated specifications only. If an electrical
surge above the rated specifications of this surge protector enter this device, connected devices may not be protected. Please understand that
electrical surges can enter electronics devices through any interconnected conductive connections. These interconnections can include coax
lines, phone lines, ethernet lines, AV connections and any other conductive material.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
To assure continued FCC compliance:
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment.
FCC ID & IC Statements
To assure continued FCC compliance:
1. Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment.
2. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed
and operated with minimum distance 20cm between the radiator & your body.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including interference peration of the that may cause undesired o
device.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator and your body.
Copyright 2021 ELAC Americas Inc.
ELAC A
ELAC A
ELAC A
ELAC AELAC AMERICAS IN
MERICAS IN
MERICAS IN
MERICAS INMERICAS INC.
C.
C.
C. C.
1938 N. BATAVIA ST. SUITE K
1938 N. BATAVIA ST. SUITE K
1938 N. BATAVIA ST. SUITE K
1938 N. BATAVIA ST. SUITE K 1938 N. BATAVIA ST. SUITE K
ORANGE, CA 92865
ORANGE, CA 92865
ORANGE, CA 92865
ORANGE, CA 92865 ORANGE, CA 92865
WARRANTY
ELAC Americas Inc. warrants to the original purchaser that this product be free from defects and or workmanship for 3-Years from the original
date of purchase. During this time period, repair or replacement will be free of charge to the original owner (See below limitations). Shipping to
and return from the repair ce of the original purchaser. nter will be the responsibility
Limitations
Limitations
Limitations
LimitationsLimitations
• Warranty begins on the date of original purchase from an authorized ELAC Americas Inc. dealer. Warranty on products purchased from an
unauthorized reseller will not be honored.
• Product is warranted only if used in home applications within the rated specifications of this product. Commercial use of this product is not
warranted.
• Product that has been modified or altered in anyway will not be warranted.
• Product that has been abused or subjected to faulty equipment will not be warranted.
• Products with defaced or removed serial numbers will not be warranted.
If service is required
If service is required
If service is required
If service is requiredIf service is required
In the event that service is required, please contact ELAC America at 714-252-8843 or at customerservice@elac.us to request a return
authorization and to arrange for service or serviced or replaced is at ELAC’s discreti replacement. Whether the product will be on. You will be
responsible to provide proof of purchase (Copy or original sales receipt). Shipping to and from our repair center will be the responsibility of the
original purchaser.

Specyfikacje produktu

Marka: ELAC
Kategoria: Niesklasyfikowane
Model: Protek PR-71S

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z ELAC Protek PR-71S, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Niesklasyfikowane ELAC

ELAC

ELAC HDX21 Instrukcja

9 Października 2024
ELAC

ELAC Protek 8 Outlet PB-82S Instrukcja

6 Października 2024
ELAC

ELAC Protek PR-71S Instrukcja

4 Października 2024
ELAC

ELAC PB12-W Instrukcja

4 Października 2024
ELAC

ELAC Protek PR-81B Instrukcja

4 Października 2024
ELAC

ELAC Protek 3 Outlet PB-30S Instrukcja

1 Października 2024
ELAC

ELAC LS10 Instrukcja

4 Września 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024
Husqvarna

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024
Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024