Instrukcja obsługi Ei Electronics Ei262

Ei Electronics Detektor dymu Ei262

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Ei Electronics Ei262 (36 stron) w kategorii Detektor dymu. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/36

Model Ei262

Read and retain carefully for as long as the product is being used. Contains vital information on the

operation and installation. This leaflet should be regarded as part of the product.

If you are just installing the unit, . This leaflet is to be this leaflet must be given to the householder

given to any subsequent user.

The RadioLINK Carbon Monoxide Alarm Ei262 will

communicate with all other RadioLINK devices including

Smoke/Heat/Fire Alarms, Relays and other accessories.

RadioLINK

MAINS POWERED

CARBON MONOXIDE ALARM

WITH RECHARGEABLE LITHIUM CELL BACK-UP

IMPORTANT INFORMATION

What to do when you alarm is activated

CARBON MONOXIDE - THE SILENT KILLER

ALARM POSITIONING

INSTALLATION

4.1 Mounting & Wiring Alarms

4.2 RadioLINK Interconnecting etc.

USING & TESTING YOUR SYSTEM

HOW TO DISTINGUISH BETWEEN CO ALARM & SMOKE ALARM WARNINGS

MAINTENANCE

LIMITATIONS OF CO ALARMS

HOW TO PROTECT YOUR FAMILY

GETTING YOUR CO ALARM SERVICED

FIVE YEAR GUARANTEE

TECHNICAL SPECIFICATIONS

ACCESSORIES

TROUBLESHOOTING

Page

CONTENTS

1. IMPORTANT INFORMATION

WARNING: The Alarm should be permanently wired to the mains by a qualified electrician in

accordance with IEE wiring regulations (BS7671).

Install a Carbon Monoxide (CO) Alarm in every room that contains a fuel burning appliance, and in

rooms where people spend a lot of time e.g. bedrooms, kitchens and sitting rooms.

In rooms with an fuel burning appliance, install (preferably) on the ceiling (300mm from walls and

between 1m to 3m horizontally from appliance). In rooms remote from the appliance install at

breathing level, where the light indicators can be seen.

Regularly check that the green power light is on, so that rechargeable back-up cells will remain fully

charged. The CO Alarm will not work if the mains supply is off and the rechargeable Important:

cells are depleted.

Test the unit weekly by pressing and holding the Test/Hush button. The horn will sound and the radio

frequency (RF) signal will be transmitted. (Green light turns red while RF message is transmitted).

Replace sensor module after 5 years operation (see page 25).

When the CO Alarm detects abnormal levels of CO (above 50ppm CO) the red light starts to flash,

the horn will sound within 90 minutes and the signal will be transmitted. At higher levels RadioLINK

of CO the alarm will turn on sooner (see Table B - page 7).

The CO Alarm will automatically reset once the CO has cleared. Pressing the Test/Hush button will

silence the CO Alarm immediately (below 300ppm CO). If CO is still present the red light and horn

will turn on again after about 4 minutes.

The CO Alarm is no substitute for keeping chimneys and flues clear and in good condition, and all of

your appliances serviced regularly according to the manufacturer’s instructions.

Do not fit alarm until all building work is completed to avoid contamination.

Specyfikacje produktu

Marka:	Ei Electronics
Kategoria:	Detektor dymu
Model:	Ei262
Kolor produktu:	Biały
Typ produktu:	Wyprostowany
Wbudowany wyświetlacz:	Nie
Długość przewodu:	3 m
Położenie urządzenia:	Wolnostojący
Napięcie wejściowe AC:	230 V
Wysokość produktu:	1550 mm
Szerokość produktu:	595 mm
Głębokość produktu:	634 mm
Waga produktu:	60000 g
Szerokość przedziału instalacji:	600 mm
Poziom hałasu:	42 dB
Prąd:	10 A
Obciążenie:	130 W
Regulowane nóżki:	Tak
Klasa efektywności energetycznej (stara):	A+
Zawias drzwiczek:	Prawy
Roczne zużycie energii:	268 kWh
Pojemność zamrażarki netto:	194 l
Czas przechowywania podczas awarii zasilania:	16 h
Automatyczne rozmrażanie (zamrażarka):	Tak
Ocena w gwiazdkach:	4*
Pojemność zamrażarki brutto:	15 kg/24h
Liczba półek w zamrażarce:	4
Alarm temperatury:	Tak
Tryb klimatu:	N-T