Instrukcja obsługi Edwards 7005-G5

Edwards Niesklasyfikowane 7005-G5

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Edwards 7005-G5 (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/2

CHESHIRE, CT 203-699-3300 FAX 860-677-7746

Installation Instructions for the

7005-G5 Hotel Room Annunciator

Description

The 7005-G5 Hotel Room Annunciator Kit alerts hearing-impaired

individuals inside a room that someone is present outside the

room. The horn/strobe is mounted inside the room. When the

pushbutton outside of the room is pressed for 5 seconds, the signal

is activated. The 7005-G5 Hotel Room Annunciator Kit contains:

Pushbutton (Cat. No. 620), Pushbutton Mounting Plate (Cat. No.

147-10), Horn/Strobe (Cat. No. 6536-G5), and Transformer (Cat.

No. 592). You can purchase each item separately from your local

Edwards distributor.

Installation

A qualified electrician familiar with National Electrical Code

and local code requirements must install this product. Failure to

follow the safety precautions in this instruction sheet could result

in product or property damage, severe personal injury or death.

WARNING

To reduce the risk of shock, do not connect AC power

until installation is complete.

WARNING

To reduce the risk of shock, do not remove lens or

tamper with unit when the circuit is energized.

Disconnect power and allow five (5) minutes for

stored energy to dissipate before starting work or

disassembly. High energy could be stored in the

strobe circuit once it is energized.

1. Install Cat. No. 620 Pushbutton and Cat. No. 147-10 mounting

plate (Figures 1 and 2)

a. Insert the back of the pushbutton through the hole in the

mounting plate. Press on the button until it is properly

seated within the hole.

b. Install a single gang 2" x 4" (51 mm x 102 mm) electrical

box using suitable hardware.

c. Extend black and white wires using 18 AWG wire and

connectors (not supplied). Route extended wires to the

horn/strobe and transformer (polarity is not important).

Ground in accordance with local codes and regulations.

d. Mount the pushbutton switch onto the electrical box

using 2 screws supplied with the Cat. No. 147-10

mounting plate.

e. If additional pushbuttons are required, follow steps a and

b above. Then, extend black and white wires using 18

AWG wire and connectors (not supplied). Route extended

wires to the previously installed pushbutton switch and

connect wire leads (Figure 1).

2. Install Catalog No. 6536-G5 horn/strobe (Figures 1 and 4).

The 6536-G5 horn/strobe can be mounted on any single gang

2" x 4" (51 mm x 102 mm) electrical box, double gang 4" x 4"

(102 mm x 102 mm) electrical box, or standard 4" x 4" (102

mm x 102 mm) junction box with a plaster ring.

a. Install an appropriate electrical box using suitable

hardware.

b. Connect one wire from the 620 pushbutton to one of the

horn/strobe wires (polarity is not important).

c. Extend the remaining horn/strobe wire to the transformer.

d. Mount the horn/strobe onto the electrical box using two

screws (supplied).

3. Install Catalog No. 592 Transformer (Figures 1 and 3).

a. Select a metal electrical box that can be grounded. Mount

the transformer onto the electrical box (Figure 3) so that

it has ground continuity to the box and conduit system.

b. Install the box using suitable hardware.

c. Ground the box in accordance with local codes and

regulations.

d. Connect the remaining pushbutton wire to one of the

terminals marked 24V 20VA.

e. Connect the horn/strobe wire to the second terminal

marked 24V 20VA.

f. Connect the transformer's primary wire leads to an

appropriate 120V AC power source.

4. When all connections are completed, press the pushbutton

and verify operability of the horn/strobe.

Maintenance

Perform regularly scheduled testing at least twice a year or more

often as dictated by local authorities having jurisdiction.

The 7005-G5 Hotel Room Annunciator is not serviceable or re-

pairable. Should it fail to operate properly, contact the supplier

for replacement.

Table 1. Specications

Horn/strobe Voltage 24V 50/60 Hz 24V DC

Horn/Strobe Current 175 mA 125 mA

Transformer - Primary 120V

- Secondary 24V 20VA

Figure 1. Connecing Catalog No. 7005-G5 Hotel Room Annunciator

Figure 3. Catalog No. 592 Transformer

Figure 2. Catalog No. 620 and Catalog No. 147-10

Figure 4. Catalog No. 6536-G5 Horn/Strobe

Mounting on Box: Remove

appropriate 1/2" (13 mm) knockout

from electrical box. Loosen the

screw from transformer bracket

and position the transformer on the

back box so that the bracket

extends into the box. Tighten the

screw.

Surface Mounting:

Use foot-mounts

Enclosed Mounting: Mount inside a standard

two gang electrical box using a Catalog 593

plate.

P-047550-1874 ISSUE 1

4 1/2"

(114 mm)

2 3/4"

(70 mm)

ROOM FOR

HANDICAPPED

Mounting

screws

Pushbutton

To 591

To 6536-G5

PLEASE DEPRESS

BUTTON

5 SECONDS

SIGNAL

STROBE

4 1/2"

(114 mm)

4 9/16"

(116 mm)

Strobe

To 591

Horn

Mounting

screws

FRONT

VIEW

BACK

VIEW

Factory installed

wires

To 620

8V 10VA

16V 10VA

24V 20VA

2 1/4"

(57 mm)

2 1/8"

(54 mm)

(50 mm)

31/32"

(24.6 mm)

2 5/16"

(56.7 mm)

592 Transformer

120V 60 Hz

24V 20VA

Horn/

Strobe

Additional

Cat. No. 620

and

Cat. No. 147-10

(purchased

separately)

Grounded

metal electrical

box for 592

To 120V AC

power source

Electrical

box for

6536-G5

Electrical box for

Cat. No. 620 and

Cat. No. 147-10

Electrical box for

Cat. No. 620 and

Cat. No. 147-10

Specyfikacje produktu

Marka:	Edwards
Kategoria:	Niesklasyfikowane
Model:	7005-G5

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Edwards 7005-G5, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Niesklasyfikowane Edwards

Edwards 7005-G5 Instrukcja

4 Października 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024

Stihl HT 70 Instrukcja

15 Października 2024

Ernesto H14270 Instrukcja

15 Października 2024

Uniden BT MIC KIT Instrukcja

15 Października 2024

Vaude Omnis Bike 26 Instrukcja

15 Października 2024

ART ProChannel II Instrukcja

15 Października 2024

Aukey DR02J Instrukcja

15 Października 2024

Master Lock 653EURD Instrukcja

15 Października 2024

Roland FR-18 Diatonic Instrukcja

15 Października 2024